Question about Cars & Trucks
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tighten in sequence to 29ft.lbs then tighten in sequence to 58ft lbs. then loosen all bolts. Then tighten in sequence to 33ft lbs. then tighten each bolt in sequence 90 degrees then tighten each bolt again 90 degrees
Posted on Jul 26, 2009
BMW cylinder torque setting all models
According to my service manual as follows.
Cyl head to engine block (torx e12 M10 bolts)
Stage 1 30nm (22 ft – lb)
Stage 2 + 90 degrees
Stage 3 + 90 degrees
Cyl head to lower timing chain cover 10nm (89in – lb)
The tightening sequence is from inside to outside crossover as normal. Loosening sequence is from outside to inside crossover. Remember to set torque wrench at low setting and work gradually up through the whole sequence until you get the desired torque.
Posted on Aug 29, 2009
Tips for a great answer:
Nov 16, 2017 | DAF Cars & Trucks
Aug 17, 2015 | Kia Cars & Trucks
Oct 15, 2012 | Toyota Cars & Trucks
Jun 11, 2011 | 1997 BMW 318
Apr 15, 2011 | 2001 Daewoo Nubira
Jan 22, 2011 | Audi A3 Cars & Trucks
Dec 17, 2010 | Volkswagen Polo Cars & Trucks
Nov 24, 2009 | 2001 Kia Sportage
Feb 07, 2009 | 1994 Oldsmobile Cutlass Supreme
Jun 16, 2008 | 1992 BMW 3 Series
Jun 24, 2018 | Cars & Trucks
78 people viewed this question
Usually answered in minutes!