Question about Cars & Trucks

1 Answer

Hidrolic system does not work properly - Cars & Trucks

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 5,317 Answers

What system is that? Brakes? Clutch? If it's the hydraulic clutch, most often it's the clutch master cylinder. The internal seals don't hold pressure. Sometimes the slave cylinder. If there is a leak, that will cause loss of pressure.

Posted on Jan 01, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where do I put a.c. refrigerant in a 1996 mercury mystique 16 valve zetec 4 cylinder?

If you are doing a do it yourself recharge at home, chances are the system will not work properly. The system needs to be properly evacuated/vacuumed and then recharged for proper operation. Just filling it will not make the system operate properly. Have it done proffessionaly if you want it to work

Mar 01, 2016 | Mercury Cars & Trucks

1 Answer

Where is fuse box for hidrolic fan

there is no fuse for a HYDRAULIC fan

Feb 26, 2014 | 2000 Lincoln LS

1 Answer

Clutch pedal stays on the floor

hidrolic circuit with leak.....clutch problem....hard to be sure without see

Nov 24, 2011 | 2002 Toyota Camry

2 Answers

Can you adjust the clautch

No its all hidrolic system you can bleed if you have say a leak in the master it will work until enough air gets back in to the system but no adjustment

Nov 24, 2010 | 1997 Nissan 200SX

1 Answer

My car is not starting cuase the clutch is stuck and all the way down and olso the stick shift stuck in rear position i drove my normal last night and it was very good by the way ichange the...

It sounds like the master cylender has failed, maybe old, damp fluid has corroded the bore and ruined the rubber seal, joggle the car to unload the gears and it will come out of gear (and perhaps roll away, is the e brake ok and on?)

Aug 24, 2010 | 2001 Hyundai Elantra

1 Answer

I need to re charge my air conditioner in my 2003 Yukon XL. How do I do this?

well first question is
1. does it have a leak in the system?
2. was the system open for any leanth of time?
3. did the compressor lock up causing the system to fail?
4. if the compressor did fail, then the system will require a rebuild....compoints replaced and flushing of the no replaced parts.

if you answered no to thies questions then

if the system is empty....

1. to properly charge a system it need to have a vacum drawn on it to 30lb for min of 15 mins.
2. then there ststem ( depending on the last service it receved or miles on the system) i might require sever ounces of pag oil
3. once these requirements are met, the proper amount of 134a need to be charged to the system.
this is done thru a scale or other mesurement device....just adding cans of 134 will not work properly ( back in the age of R12 a system could be severl ounces off and still work properly, 134 require an almost exact amount to work )
4. once the system is charged,,,cycle the a/c on and off severl times to flow the pag oil into the system.
this should do the trick. but it require specility tools.

if the system is low ( only from a leak in the system some where)
you MIGHT try the auto parts answer to a/c charging and place a do it your self charge up kit to it.... will have a guge and proper attachments....
2.follow the directions and hope for the best...... but again.,...this might buy you a little time....
3. a problem still is with the system and will run low again causing it to shut down due to lack of proper presures.......

with people hunting to fix what they have try a local reputable A/C / Radatior shop with the proper equipement....but ask for prices and if there are any deals to be had....a smart shoper is always better then a poor consumer...... i hope i helped...good luck :)

Jun 25, 2009 | 2001 GMC Yukon XL

1 Answer

Let out clutch it dont ingage


Jun 20, 2009 | 1994 Toyota Pickup

2 Answers

My engine ie knocking

sounds like a lifter spring load or hydraulic? or maybe top end rocker whats the restart like on it ??? surge up and down??

Jan 04, 2009 | 1985 Chevrolet Chevette

1 Answer

Hidrolic suspension

You need a special service tool to perform this task, and there are many pages in the manual to accompolish the adding of fluid. This is not something that one can undertake without the service manual, special precautions, and the special filler tool.... If the oil is not leaking, and no parts have been replaced, do not try to adjust the oil level. You are dealing with very high pressures in this system, you could get hurt. This is the best advice I can give you.

Oct 06, 2008 | 2001 Toyota Land Cruiser

1 Answer

I have a 1999 Saab 93. When I am trying to turn there is a noise coming from the steering (I guess). Yesterday I saw a leakage of fluid. What is going on?

the hidrolic pump for your power steringing has a warn seal and this might have to be changed. you might to feel simtoms of stiffness in the turning of the wheels. is had this same problem a while back . but just make sure the level of the power stering fluid is kept toped up till you fix if.

Jul 16, 2008 | 1999 Saab 9-5

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides