Question about 2004 Pontiac Grand Prix

2 Answers

A/C not blowing cold. heat works, blower works, checked fuses and relays. running for 5 minutes cannot see the compressor / clutch kick in. Uses R-134a does it need to be recharged first?

Posted by on

  • smartnh67 May 23, 2009

    Thanks Rockitman



    Charged it up a bit, compressor kicked right on, let it settle a bit and finished recharging.. blowing icy cold again.

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,559 Answers

First you should check the refrigerant level and charge if needed.

Posted on May 20, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

It's your A/C condensor i have the same prob with my 2003 sunfire.

Posted on May 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Grand Prix GXP keeps blowing the 10amp fuse for the AC. When replaced, it runs cold again until I start driving, then it blows and only has hot air once again. Very frustrating in Texas heat!


13
A/C CLUTCH Fuse
10A
A/C COMP Relay - try replacing the A/C compressor clutch relay # 38 in under hood fuse / relay box . ! Could be shorting out after hot . I don't won't to get to technical on you, doing voltage drop testing on the circuit . If not relay the compressor clutch coil could be going bad when heating up . There are videos on you tube , testing A/C compressor clutch relay .

Jul 05, 2016 | 2008 Pontiac Grand Prix

5 Answers

A c not working


kindly check the fan blower resistor if still working and functioning..

Aug 08, 2008 | 1995 GMC Suburban

1 Answer

2001 Oldsmobile Alero 4 cyl , Air Conditioning, compressor clutch will diss-engage. Blower fan is working, Freon psi is good, All the fuses and relays are good, Did some testing, and the compressor and...


The pressure means nothing as far as the state of charge. You need to have the system completely evacuated and recharged with the specific charge weight for that vehicle. Only then can the pressures or anything else mean anything.

Aug 18, 2013 | 2001 Oldsmobile Alero

1 Answer

Sentra AC


There's a 10amp fuse that powers the ac clutch relay and compressor. There are 15amp fuses that power the blower motor and the ac control switch. All of those fuses get power from the key switch. The resistor and fan switch provide the ground circuit for the blower motor.
I would want to know if those fuses are getting power, and if the control panel is working. You should be able to ground the blower motor and make it run on high, and that should not have any effect on if the ac compressor is running or not.
It could be a key switch problem in that the circuit is not strong enough to handle the load from the blower and the compressor at the same time.

Jun 21, 2013 | Cars & Trucks

3 Answers

The a/c on my 2010 Mercury Milan quits blowing after about 2 hours of driving. Any ideas?


Sounds to me like the A/C clutch is no good and out of adjustment.You should goto your nerrest junkyard and get a used assembly take the clutch off then you learn how it comes off and install it on yours the save the pump for later use if needed. The clutch should only have a .010 air gap after install between th inner elctro magnet and the clutch plate it's self.

Aug 04, 2012 | 2010 Mercury Milan

1 Answer

My air condition is not working


first check your fuses and any relays sometimes you have multible relays that are the same in a fuse box that you can switch around but i would bet you have a leak either in your compressor or in your line if the clutch is not kicking on and off or running all the time when you turn it on thats because your freon has leaked out the system is sealed freon does not go bad if there is no pressure in the system it will just blow warm air your question is vague so if your blower is not blowing bad blower motor or a fuse if warm not getting cold your system has a leak if you have not broke the system you can try stop leak 2 cans to seal a leaky compressor compressor could be bad if it wont spin noisy clutch could be bad need new compressor but if a leak after stop leak add the right amount or r-134a 2 to 3 cans if the compressor kicks on on the first can of stop leak or freon your system did leak down and you hope the stop leak fixes it but first check all your lines are tight and that the freon is not leaking from the high or low pressure ports the valve can leak sometimes make sure your caps are on take some spit after you add freon back into your system see if your spit blows a bubble if it does replace or tighten the valve. a few things to check start with power fuses then add a can of freon if you have power now clutch engagement if you add and kicks on there is the reason a leaky system it will all leak back out in a day or several days... thats why you can add the stop leak things you can try or take it to the shop and pay someone some $$$$$

May 26, 2010 | 2003 Honda Accord

1 Answer

Ac compressor not switching on 1986 Peugeot 505.GTI How can I test clutch wiring,. Have just aquired this car , heater blowers etc. working but ac clutch not cutting in, is there a switch I have not found....


The best thing to do first is to check the AC clutch itself if it's working, locate the air - con compressor and you will see a wire coming out from the front top of the AC-compressor, it has a connection, remove tht connection and take a piece of wire, connect it to the wire frm the AC-compressor and the other end of the wire to the battery positive terminal,by doing so you will hear a clicking sound of the clutch at the AC-compressor, better still is to start the car's engine, switch 'ON' the AC as normal, let the blower blow thn connect tht wire frm the AC-compressor to the positive side of the battery terminal and check it out if the AC-compressor rotates and also you may get in the car and see if its blowing cold air.
Please also check this -->
HEAT/COLD selector (on the dash) is not selected at HEAT...if it is thn the AC-compresor clutch will not kick in!
Hope this helps!

Dec 27, 2009 | 1986 Peugeot 505

2 Answers

Acura integra 96 Air Conditioner compressor did not run


Check the A.C>Relay or It could be low or leaking freon

Jul 06, 2009 | 1995 Acura Integra Coupe

3 Answers

92 cadillac deville a/c blows fuse


The conector for the a/c compressor comes with a diode that keeps power from returning after the compressor cycles off. Check or replace the connector/and or diode and see if that fixes the problem

May 18, 2008 | 1992 Cadillac DeVille

Not finding what you are looking for?
2004 Pontiac Grand Prix Logo

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8201 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...