Question about 2004 Saab 9-3

Open Question

Traction control failure

Car runs normally

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 334 Answers

SOURCE: traction control failure warning came on yesterday and now the car won't start.any advice please??

you will have to take the car to a dealer and have it scaned. youve have a sencer gone bad or one of the computer gone bad ok .sorry for the bad news

Posted on Apr 19, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Traction off lamp does not work on my 2005 LeSAbre


Traction off - is the normal state of running for the traction control system for this car. If one of the wheels slips when you start up then the traction 'on' light comes on and Traction Off only shows for a short while when it goes off.

Aug 20, 2017 | Buick LeSabre Cars & Trucks

1 Answer

Traction control light is on. Is this an MOT failure? Will it be electrical or module failure?


MOT failure ? You must be located in the UK .The traction control light being on indicates a problem in that system an probably has a trouble code stored in the ABS electronic brake control module . Your best bet is to have a qualified repair shop check it out . Or at least call an ask about MOT requirements .

May 28, 2016 | Ford Cars & Trucks

2 Answers

I loose power when traction control light comes on in my 2002 mustange gt


With some makes and models this is normal. The PCM will reduce engine power when the traction control senses wheel slip as a safety precaution until traction is restored

Feb 14, 2016 | Cars & Trucks

1 Answer

Light abs traction control stays 1998 buick park avenue


PRE-DIAGNOSTIC INSPECTIONBefore diagnosing ABS/TCS, perform a comprehensive visual inspection of system as follows.Check ABS/TCS wiring harness connectors for looseness. Check harness routing; pay particular attention to wheel speed sensor wiring harness routing. Check fuses No. 1D, 5B and 6B in instrument panel fuse block. Check fuses No. 1 and 2 in underhood fuse block. Check brake fluid level in master cylinder reservoir. Check brake fluid level in Pressure Modulator Valve (PMV) assembly reservoir. Ensure parking brake is fully released. Ensure parking brake switch is functioning properly. Always perform ABS/TCS system functional check before using DIAGNOSTIC CODE CHARTSThe EBCM/EBTCM has self-diagnostic capability, which can detect system failures. Fault codes stored by EBCM/EBTCM can be displayed using Tech 1 scan tester. There are no provisions for flash code diagnostics.Begin ABS/TCS diagnosis with PRE-DIAGNOSTIC INSPECTION procedure. If failures are found during pre-diagnostic inspection, perform necessary repairs, and proceed with ABS/TCS FUNCTIONAL CHECK. See Fig. 5 .If no failures are found during pre-diagnostic inspection, go to ABS/TCS FUNCTIONAL CHECK. See Fig. 5 . The ABS/TCS FUNCTIONAL CHECK will either indicate ABS/TCS is functioning properly or direct technician to various diagnostic procedures such as diagnostic charts, symptom diagnosis or BRAKE warning light diagnosis.CHART D - TRACTION OFF WARNING LIGHT ON CONTINUOUSLY & NO DTC SET (BUICK WITH UH8 OR U2A INSTRUMENT CLUSTER)Circuit DescriptionWhen ignition switch is first turned to RUN position, EBTCM goes through a self-test, which lasts 2-4 seconds. During self-test, EBTCM commands TRACTION OFF indicator warning light on. Powertrain Control Module (PCM) can also command EBTCM to set a Code 75 which will illuminate TRACTION OFF indicator.Traction control switch is located either on instrument panel center trim plate or driver's front door trim panel. Switch allows driver to select traction control mode (on/off). When traction control system is turned off, TRACTION OFF warning light comes on.EBTCM monitors transaxle temperature through

Jul 12, 2014 | 1998 Buick Park Avenue

1 Answer

Traction control light flashes


mine does it any time i drive funny, drive on gravel or ?
it's normal
what is not normal, is if it stays on.
what does jeep pulls at 50 mean.??????????????
are what is pulling,???????????
do you mean the car pulls to the left or right ? steering wheel steady/.?
brakes pull? while braking, or brakes pull full time?
if the lamp is on , on flat hard dry pavement, the car needs service.
the operators guide tells you all this, read the pages?. on traction controls.???? do so, read the whole thing.

the lamp can mean:
1: car was out of control and i made corrections.
2: system failure.

connect a scan tool see if there are DTCs on the system.s


Mar 04, 2014 | 2010 Jeep Patriot 2.4

1 Answer

Engine cuts out after a skid


traction control faulty. You slip and slide, your traction control activates, then here lies your problem.. after your traction control activates, it is creating an electrical short, vacuum leak, etc. look at what your traction control is operating, probably brakes. SO look at the brake booster vacuum lines or connecitons. Hope this at least gives you an idea of where to look. COuld be your traction control module is faulty.

Dec 15, 2013 | 2006 Chevrolet Trailblazer

1 Answer

Track control pop on what do that mean and can I trim it off


Your traction control switch may be located on center IP fascia. below the front a/c control switch. Pls check your manual. You can turn it on or off and it will indicate visually on the insrument panel cluster. Normally the default mode is off,(traction light off) meaning the traction system is enabled and operational. If the light comes on while the engine is running and even without touching the switch, it only means that your traction control system have been disabled because the system has detected a fault; you can still run and proceed carefully in good brakes without the traction control system..However' you still need to have your vehicle scanned for codes to know the specific cause.

Feb 18, 2011 | 2007 Chevrolet Tahoe

1 Answer

What is the use of the trac off button?


trac has to do with traction control which is useful in wet conditions such as rain or snow. if you have the owners manual, read it. it may tell you to run normally with it off. i would imagine it wouldnt matter in this case. to be able to run it with trac off, the advantages would be faster response on take off. what the traction control does in when the tires begin to break free it slows the wheel to gain traction once again so you dont loose control. cheers

Dec 20, 2009 | 2005 Scion xB

Not finding what you are looking for?
2004 Saab 9-3 Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

rgbypoet

Level 2 Expert

166 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...