Question about 2000 Jaguar Vanden Plas

1 Answer

Where crankshaft position sensor located on 2000 Jaguar vanden plas?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Jaguar Master
  • 645 Answers

If its a v8 its on the underside on the flywheel/torqueconverter housing in the centre 8mm bolt or torx head close to the subrame crossmember if its a x300 straight six its on the top front above crank pulley 8mm bolt.

Posted on Jan 14, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 100 Answers

SOURCE: 1988 Jaguar Vanden replace headlight

What you need to do is remove the 2 screws on the top bezel from inside the engine bay, then underneath the outer corner of the plastic headlamp surround there is a philips screw, (put your head under neath car near from wheel) loosen the screw, do not remove it, now the headlamp plastic bezel/surround will come free enough so you can get a philips screwdriver in through the middle of the headlamp surround, there is a chrome retaining ring holding the headlamp in place, loosen the 3 philips screws (do not remove) The retaining ring will rotate and you can slide the ring out from the outer edge of the headlamp surround. The headlamp will then come out throught the middle of the surround, disconnect the 3 pin multiplug and reverse process for install.

Posted on Sep 19, 2008

  • 109 Answers

SOURCE: leaking valve covers, 2000 jaguar vanden plas supercharged

no there is'nt enough pressure underneath to make it leak try tighting up the valve cover bolts or just getting a new gasket about a $6.00 to $10.00 dollar fix depending on where you go

Posted on Dec 02, 2008

  • 1 Answer

SOURCE: Jaguar Vanden Plas 1996 where is fuel filter located?

The fuel filter is an inline type, and is located up under the Driverside rear wheel arch. If you get underneath and look up and behind the rear coil spring you will see it. just follow the fuel lines from the tank. It's a bit tight and you will get covered in fuel but it's doable.

Fram's number is G3727, which is the same used on my '04 Chevy Suburban. You'll need to release the fuel pressure by unscrewing the gas cap first. Also, you'll need some wrenches to hold fast both at the filter and line ends, plus some rags and a coffee can to catch/absorb the fuel that will spill out of both the filter and the line; you'll loose about 1/2 a cup. Good luck.

Posted on Aug 15, 2009

  • 24 Answers

SOURCE: Where are the trunk lid struts located on a 95

They are located at the outside of the boot hidges, a little way back.

Posted on Mar 30, 2010

  • 14585 Answers

SOURCE: I have a 2000 Jaguar vanden plas and a amber light

Check engine light. takes a scanner to read the codes

Posted on Jun 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is camshaft position sensor located on 2000 Jaguar vanden plas?


facing the car from the front it should be at the left hand side at the rear, take fire wall shelf off for an easier access.

Jan 01, 2014 | 2000 Jaguar Den Plas Supercharged

1 Answer

Jaguar Vanden Plas 1996 where is the fuel pump located?


this is a picture of fuel pump location hope it can help you and good luck

Nov 18, 2012 | 1996 Jaguar Vanden Plas

1 Answer

Leaking valve covers, 2000 jaguar vanden plas supercharged


no there is'nt enough pressure underneath to make it leak try tighting up the valve cover bolts or just getting a new gasket about a $6.00 to $10.00 dollar fix depending on where you go

Dec 01, 2008 | 2000 Jaguar Vanden Plas

Not finding what you are looking for?
Cars & Trucks Logo

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...