Question about Cars & Trucks
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
What you need to do is remove the 2 screws on the top bezel from inside the engine bay, then underneath the outer corner of the plastic headlamp surround there is a philips screw, (put your head under neath car near from wheel) loosen the screw, do not remove it, now the headlamp plastic bezel/surround will come free enough so you can get a philips screwdriver in through the middle of the headlamp surround, there is a chrome retaining ring holding the headlamp in place, loosen the 3 philips screws (do not remove) The retaining ring will rotate and you can slide the ring out from the outer edge of the headlamp surround. The headlamp will then come out throught the middle of the surround, disconnect the 3 pin multiplug and reverse process for install.
Posted on Sep 19, 2008
Before 2005 the Blutooth Units in the Jaguars were Analog. Analog phones are no longer available, everything is digital. The only option according to Jaguar USA is to pay $2000.00 for a digital unit. Then any bluetooth enabled phone will work.(Jaguar stated that since the government made the switch, they will not do upgrades at Jaguars expense)
Posted on Jan 07, 2010
Try inserting the key into the drivers door lock and try centrally locking and unlocking all the doors a few times. If this does not reset the valet function try using the key in the drivers door lock and pressing the fob at the same time as locking and unlocking the doors. Even with valet mode engaged you should be able to access the trunk by physically inserting the key into the trunk lock.
Posted on Oct 06, 2010
Testimonial: "it was really helpful and the trunk yea i was able to open with the key but it still doesn't remove the valet all is doing is not keep sunroof open "
The starter motor is located on the passenger side ( left ) side of the motor. it is held onto the motor with two bolts. Before starting the removal process you must disconnect the battery by removing the ground lead. Under the car disconnect the battery feed wires on the solonoid mounted on the starter. Also disconnect the white with red tracer wire on the solonoid. This is the wire that comes from the starter relay on the firewall. Remove the upper bolt first. You can get at it from the top of the engine bay and then remove the bottom bolt. This starter is heavy. The starters on the later cars were a lot lighter. The starter will clear the engine. Be sure to test the new starter before you install it. Installation is reverse of the removal.
Posted on Dec 31, 2010
Tips for a great answer:
Jan 05, 2016 | Cars & Trucks
Apr 27, 2011 | 1995 Jaguar Vanden Plas
Dec 22, 2010 | 1991 Jaguar XJ6
Dec 19, 2010 | 2002 Jaguar Vanden Plas
Dec 16, 2010 | 2001 Jaguar Vanden Plas
Jun 17, 2010 | 2000 Jaguar Vanden Plas
Jan 15, 2010 | 2001 Jaguar Vanden Plas
Dec 01, 2008 | 2000 Jaguar Vanden Plas
Jun 17, 2018 | Nissan Cars & Trucks
35 people viewed this question
Usually answered in minutes!