Question about Cars & Trucks

Open Question

Wiring dab pump tf40/81

Where do coloured wires go ie 1-2-3-4-5-earth

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 625 Answers

SOURCE: stereo wiring

test all gronds and powers then the remaining cables use a AA batterie and conect one cable on each end on the baterie like on of on of like toching at times and that will make the speakers to sound for a little then you will identify every speaker then read the diagram on the radio and plug it in acording to the radio diagram

Posted on Jun 01, 2008

Ad
emissionwiz
  • 77499 Answers

SOURCE: escort diesel fuel pump problem , new one has 3 wires instead of 1 wire

Find the lead that has 12 volts when the igtnition switch is turned on, that is the lead you will use.

Posted on Aug 25, 2008

3bachelors
  • 52 Answers

SOURCE: Tow bar wiring

use the wires inside the hatch behind the plastic panel on either side. Wiring for your car is as follows - 












Parking Lights YELLOW (-) 1K OHM RESISTOR AT THE STEERING COLUM HARNESS USE A 1KOHM RESISTOR Brake Lights WHITE/TAN (+) AT SWITCH Reverse Lights VIOLET/BLACK (+) 72 PIN CONN POS 6 BEHIND PASS KICK







Good Luck, NGK

Posted on Sep 04, 2008

  • 149 Answers

SOURCE: On a land rover discovery, windscreen wiper motor,

Ok, here are the wiring colors and functions/destinations. C0030 is the motor connector for the front windscreen.
C0030-1 - Black, runs to a Earth
C0030-2 - White/Green - Fed from the front wiper relay, via the IDM
C0030-3 - Blue/Green - Flick Wipe/Fast Wipe
C0030-4 - Green/SlateGrey - Power from Aux Relay
C0030-5 - Red/Green - Looks to be a speed control connection.

It's hard to tell to be honest, you'd really need to sit down with RAVE and the electrical circuit diagram and the operation description to make head or tail of it.

Posted on Feb 25, 2010

  • 30 Answers

SOURCE: 1999 GMC Savana 2500 fuel

there is 2 one is for the evap fuel tank pressure sensor...and the other is the pump module...the module one should be 4 wires purple gray white and pink i think..just 2 of them are for the actual pump...run a test lamp on them...you should have power to it for 5 seconds ..when the key is 1st turned to the run position..thats the prime siglal to the pump..

Posted on Apr 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Lambda sensor signal wire


If u mean bypass as in putting a new wire in, I'd be in plugging the Ecu connector and lambda sensor then running a simple test to make sure u got the right wire , a four wire lambda is 2 heater wires usually the same colour which when on is positive 1 5v Ecu feed and a earth

Jun 27, 2015 | 2003 Chrysler Voyager

1 Answer

Need wiring diagram with breakdown of colored wiring on fuel pump motor on 1999 mitsubishi galant ES, 4 cyl


the two thick wires are for the pump and the other two for the fuel gauge ,check for voltage at the pump if no voltage then follow the wires back to see if their is a connection somewhere ,also check the earth connection if no power in the two wires ,ie one probe onto the earth and the other to a suitable ground on the bodywork ,then continuety

Jan 17, 2015 | 1999 Mitsubishi Galant

1 Answer

Can you tell me the colour of the earth wire to the fuel tank of my fiat stilo


Most likely not a wire, bad sending unit on the fuel pump, but most grounds are black or white/black stripe

Jul 31, 2014 | 2004 Fiat Stilo

1 Answer

I brought a rover mgzr and want to put radio in it but the wires in the loom have had the connectors cut off so i just got the speaker wires and the four wires to power the radio, I know which speaker...


My assumption would be black = earth, red/black = power, purple power antena? green white? start by getting a test lamp put the earth ********, turn ignition on & check all wires for power also test in acc position & off position in case 1 is memory (constant power) once you know which ones are power put the test light in the power & black to check the black is the earth. Once you have + & - & speakers it should work.

Jun 27, 2012 | Cars & Trucks

1 Answer

3phasemotorwiring


rayburns07,

Thank you for asking me to help you with your problem. However, this is either not within my level of expertise or the question is unclear or there is not enough information and I cannot help you at ths time.

Nov 23, 2011 | Cars & Trucks

1 Answer

My Ford XR3 brake light are not working even if i have a new switch and fuse. which wiring colours are use and how to trace this to the fuse box


Unsure on wire colours but pretty sure the best place to start is on Brown or Black wires as the are Earth.

Start at the rear and make sure the earth points are good and clean.

Dec 09, 2010 | 1986 Ford Escort 4-Door

1 Answer

I need a circuit diagram for a 2000 Hyundai accent sterio plug. ie colours for speaker wires, power, ign, dash lights etc.


speaker wires you can connect one at a time to see which is which as for the others black is earth, red is usually ignition, yellow is constant power (memory) and sometimes you'll have a blue wire for power out or you can usually just buy an adaptor plug to suit most stereos

May 18, 2010 | 2000 Hyundai Accent

1 Answer

No electricity to the fuel pump ...if I remove the pump and hook it up to a 12v source it works fine...hook it back up to the two wires on the car..nada


Well all your problem should be is either the feed to the pump is not there OR the earth wire isent earthing SO get a test light put 1 end to any part of engine and the other to the pump feed wire if it lights up then you have feed so its the EARTH so fit a new earth wire from engine or body to pump and away you go,,,,,,But make sure that the petrol pipes on on the correct way

Oct 03, 2009 | 1984 Alfa Romeo Spider

1 Answer

On a land rover discovery, windscreen wiper motor, there are 5 coloured wires. Can you tell me what each one does, ie. green -- earth brown -- constant + red -- fast blue -- slow black -- intermitant...


Ok, here are the wiring colors and functions/destinations. C0030 is the motor connector for the front windscreen.
C0030-1 - Black, runs to a Earth
C0030-2 - White/Green - Fed from the front wiper relay, via the IDM
C0030-3 - Blue/Green - Flick Wipe/Fast Wipe
C0030-4 - Green/SlateGrey - Power from Aux Relay
C0030-5 - Red/Green - Looks to be a speed control connection.

It's hard to tell to be honest, you'd really need to sit down with RAVE and the electrical circuit diagram and the operation description to make head or tail of it.

Sep 01, 2009 | 1999 Land Rover Discovery

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...