Question about 1998 Chrysler Concorde

1 Answer

Intermittent start/gauges 1998 Chrysler Concorde Lxi sometimes won't start---just nothing. Sometimes it starts and then dies after a few seconds. Sometimes it starts just fine and runs OK then the dash gauges go to zero and the check engine light comes on but continues to run. If I shut it off it may start with no gauges or it may not start. If I disconnect the cable plug out of the power center and plug it back in it usually starts. I have beat my head against this thing and I came up with a bad BCM. Am I correct?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Chrysler Master
  • 2,494 Answers

Could be the smaller wire at the battery terminal,clean battery terminals and check connections are tight.

Posted on May 28, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: HOW DO I GET TO THE BATTERY IN MY 1999 CONCORDE LXI

The batery is located in the right side finder. You have to pull the wheel and you will see the cover for it toward the front of the car behind the head lite. its not fun. Good luck

Posted on Dec 18, 2008

  • 68 Answers

SOURCE: I have a 1998 Chrysler

Check your battery. I had the some problem, and new battery fixed it.

Posted on Jan 10, 2009

  • 323 Answers

SOURCE: Chrysler Concorde LXI 4 door - 2004 The car starts up and seconds after, the RPM drops and the car shuts off. The code P0513 comes up on the computer.

That is a code for an invalid skim key. If you have another skim key try it. If it does the same thing then the skim module may be bad.

Posted on May 07, 2009

  • 160 Answers

SOURCE: 2002 Chrysler Concorde Lxi

There is a faulty sensor or valve. Sounds like a valve. The best thing to do, is take it somewhere that can diagnose the trouble code. Autozone can I believe, and they can tell you exactly what's going on with it.

Posted on Jul 17, 2009

  • 363 Answers

SOURCE: NO GAUGES & WON'T SHIFT TRANSMISSION

I would have the high and low shift sensors replaced first. If it continues to not shift it is staying in limp mode and you need to take it to trans shop to have diagnostic

Posted on Jul 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a chrysler concorde 1998 the speedo works occasionally i checked the codes with a code reader no codes were givin i checked fuses all is good any ideas?????


No generic code reader will read anything other than PCM/ECU codes, and sometimes ABS codes if you spend a little extra money.

The 1998 Chrysler Concorde also didn't have a instrument cluster that was controlled by the Body Computer. (BCM)
If your speedometer is working occasionally, then chances are that there is a intermittent short in the wiring or that one gauge is just going bad.

While you're driving or when it happens, try to pay attention to what makes it happen... Hitting bumps in the road or hitting the dash with your hand will be a sign of possible bad wiring.
If it worked when you shut the car off, and then doesn't work when you start it back up the next day could mean that the speedometer and/or instrument cluster is going bad.

Oct 20, 2014 | 1998 Chrysler Concorde

1 Answer

Hello! I have a 1998 Chrysler Concorde lxi 3.2.


P1684 only means battery power has been lost sometime in the last 50 engine starts. If the battery has gone dead or has been disconnected, this is a normal code. Begin by testing your battery. It could be as simple as recharging or replacing the battery.

Mar 02, 2018 | Cars & Trucks

1 Answer

DOES A 1999 COCORDE 3.8 HAVE A FUEL FILTER?


take the car in and have an OBD analysis done.

Apr 25, 2010 | 1998 Chrysler Concorde

1 Answer

I have a 1999 concorde lxi and the battery like keeps coming on. Sometimes it starts sometimes it doesn't. The battery seems to have a lot of juice in the battery could be alternator even it still starts?


By the description of your problem it seems you have a defective voltage regulator.

Take your car to an AutoZone to have the alternator tested. There is no charge for this diagnostic.

Good Luck

Feb 21, 2010 | 1999 Chrysler Concorde

1 Answer

Chrysler Concorde LXI 4 door - 2004 The car starts up and seconds after, the RPM drops and the car shuts off. The code P0513 comes up on the computer.


That is a code for an invalid skim key. If you have another skim key try it. If it does the same thing then the skim module may be bad.

May 06, 2009 | 2004 Chrysler Concorde

2 Answers

Temperature gauge is up and down


Sounds like youve noyiced the first sign of a failing thermostat.Its now taking more heat to open the thermostat or its jamming on the slide when it opens and closes.Good luck with it and pay special attention to your temp gauge until its replaced.

Dec 14, 2008 | 1998 Chrysler Concorde

Not finding what you are looking for?
1998 Chrysler Concorde Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...