Question about 2004 Dodge Ram 1500

Open Question

2004 dodge 1500 5.7 hemi ignition coil c secondary circuit replaced coil and it burnt it up after engine running at idle for about 5 minutes what could be causing this to happen

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 139 Answers

SOURCE: check engine light on, ignition coil diagnostic

i would start with the gas cap and have them read the
code again. its a cheaper way to go first

Posted on Apr 10, 2009

chipweingart
  • 1 Answer

SOURCE: problem with starting my 2003 dodge ram

My father has the same problem with his 2001 Chrysler Sebring, the key will go into the ignition switch but wont turn. Called the dealer and seems the tumblers inside the ignition have gotten stuck, the solution... put the key in the ignition and tap it gently with a hammer (plastic tip if you have it) and it worked fine. Not sure what the guys at Autozone are pull but on a Ram 5.7 Hemi there are individual coils, not one, I should know I also have a 2003 Ram 1500 and have changed the plugs (not fun)... I have a code scanner (Hypertec) and when I've gotten a check engine light I check it with the scanner. Turned out mine had a problem with the air sensor in the intake. $15 part fixed the problems. Good Luck.

Posted on Apr 26, 2009

  • 15 Answers

SOURCE: 1998 dodge ram pickup 318 eng.

If the engine seems to run fine over 1450 RPM maybe there is a vacuum hose leaking or EGR valve is slightly stuck open. Any help from the OBD II trouble codes? Or is there simply no MIL and no stored information in the OBD II computer read at the local parts store through the connector by the drivers knee?

Posted on Dec 04, 2009

  • 249 Answers

SOURCE: replace timing chain on 03 dodge ram 1500 with 5.7 hemi

i have an 02 and i purchased a repair manual from autozone

Posted on Jan 05, 2010

dhorsefield
  • 286 Answers

SOURCE: malfunction indicator light

if you receive a code indicating ignitial coil c secondary circuit this means a plug wire that connects your ignition coil pack module to a spark plug in the motor has come loose OR has become worn out
(not likely on '05 odel) or one of the coil pack modules has gone bad. If you recently had muffler repair work done, then suspect a wire has come loose and attempt to remove and reconnect each wire to the coil pack. If not, I would recommend replacing the coil pack module that's easiest to get to and testing the vehicle after replacing it. If that doesn't do it you will have to keep replacing until it starts running properly or you will need a shop manual to indicate which one is "COIL C". It's not very likely that a wire will be worn out based on the age of your vehicle, but heat from a motor will destroy a coil pack over a matter of several years especially if the coil pack is near an exhaust pipe or exhaust manifold.

Posted on Jul 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

12 dodge 1500 hemi has two burnt wires coming from underhood fuse box into harness. one wire goes to the wipers. the other is unknown. no fire or fuel. it will turn over. what do I check next?


2004 DODGE RAM 1500 - Electrical System Problem - Auto ...

www.arfc.org/complaints/2004/dodge/ram_1500/.../problem.aspx
2004 Dodge Ram 1500 problem with Electrical System. ... MY TRUCK ALSO HAS THE STALLING PROBLEM WHEN COMING TO A STOP AND ACCELERATING. ... FLAW OF THE ENGINE FUSE BOX AS THE CONNECTORS ARE EXPOSED .... HOOD WAS OPEN NOTICED BURNED WIRE ON ALTERNATOR HARNESS.
images for 12 dodge 1500 hemi wiring

Jan 07, 2016 | Dodge Cars & Trucks

1 Answer

04 DODGE Ram hemi cylinder 3 misfire


Check engine compression and compare. then test running engine compression most engines have about 130-170 cranking compression and about 90-110 running compression. OR bring that cylinder to its Top Dead Center compression stroke apply air to the cylinder and check to see where the air is going open throttle plate bad intake valve, from exhaust pipe bad exhaust valve, from oil cap piston rings.

Mar 23, 2014 | 2004 Dodge Ram 1500

2 Answers

2004 dodge ram 1500 hemi 5.7 engine dies when stopping, or idles irradic at low speeds when accelarating


Check/clean the MAP sensor and throttle position sensor. This should fix the issue. Its a common problem with Chrysler products.

Oct 26, 2012 | 2004 Dodge Ram 1500

1 Answer

My daughter's 2004 RAM check engine light is on, code P2305. What is the meaning?


P2305 = IGNITION COIL 2 SECONDARY CIRCUIT- INSUFFICIENT IONIZATION - 5.7/SRT8

Nov 15, 2010 | 2004 Dodge Ram 1500

1 Answer

What is a p0307 code on a dodge truck 1500 5.7 hemi 2004 the truck is missing on one cyl.


P0301-P0308....2T catalyst........2004-05 Ram...Cylinder 1-8 Misfire Detected Conditions: Any time engine is running and the adaptive numerator has been successfully updated. When more than 1.5% (300M, Magnum), 2% (Durango, Ram), 2.5% (Durango LEV, Ram LEV), misfire rate is measured during 2 trips, or with 10-30% misfire during 1 trip. 3 good trips required to turn off MIL. Possible Causes: ASD relay output 2 circuit fault Injector control 1 circuit fault Coil control 1 circuit fault Ignition wiring, spark plug, or ignition coil fault Fuel pump inlet strainer plugged Restricted fuel supply line Fuel pump module fault Fuel pressure leakdown fault Fuel injector is damaged or has failed Engine mechanical problems exist PCM has failed. Hope this helps you. Thank You for using fixya.If you like this solution please rate it....Thank You, iluv2fish....Ray

Jun 24, 2010 | 2004 Dodge Ram 1500

1 Answer

ENINELIGHT ON CODE P2305


P230 = IGNITION COIL 2 SECONDARY CIRCUIT- INSUFFICIENT IONIZATION - 2.7/3.5

P2305 = IGNITION COIL 2 SECONDARY CIRCUIT- INSUFFICIENT IONIZATION - 5.7/SRT8

Jun 09, 2010 | 2004 Dodge Ram 1500

1 Answer

Looking for firing and coil order 2004 hemi 5.7


For ALL 2004 Dodge RAM (1500, 2500, and 3500) (2WD and 4WD) 5.7L V8 Hemi:

.........Firing Order:
Coil...1-8-4-3-6-5-7-2
Plug..6-5-7-2-1-8-4-3

This should have been located at the top of the your Intake Manifold.

Let me know if this helped...

Apr 15, 2010 | 1998 Dodge Ram 1500 4WD

1 Answer

Problem with starting my 2003 dodge ram


My father has the same problem with his 2001 Chrysler Sebring, the key will go into the ignition switch but wont turn. Called the dealer and seems the tumblers inside the ignition have gotten stuck, the solution... put the key in the ignition and tap it gently with a hammer (plastic tip if you have it) and it worked fine. Not sure what the guys at Autozone are pull but on a Ram 5.7 Hemi there are individual coils, not one, I should know I also have a 2003 Ram 1500 and have changed the plugs (not fun)... I have a code scanner (Hypertec) and when I've gotten a check engine light I check it with the scanner. Turned out mine had a problem with the air sensor in the intake. $15 part fixed the problems. Good Luck.

Apr 18, 2009 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...