Question about Cars & Trucks

Open Question

ESP & HDC light is on and the ABS light - Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: ABS, ESP, Level warning lights (2004 Allroad TDI)

I had the brake light switch replaced by a local dealer. Cost was $140 and it fixed the problem. Have driven the car for two weeks since and no lights and all systems normal.

Posted on Oct 15, 2008

lastech
  • 408 Answers

SOURCE: ESP,ABS and brakelights comming on

hello,good day,try to replaced your brake light switch,this switch have 2 function,for brake light and for esp and bas module,ty

Posted on May 10, 2009

232K7
  • 26 Answers

SOURCE: ESP & ABS light comming on all the time

you should have the ESC/ABS module scanned for DTC's.

here are the 2 most likely causes.

1. low brake fluid
2. sticking/siezing brake lamp switch

at the dealership i see the brake lamp switches go bad left & right on a lot of the newer hyundai's. are your brake lights working?

Posted on May 11, 2009

  • 1 Answer

SOURCE: Air suspension inactive, HDC inactive, ABS light on, Range Rover

Air Suspension Inactive usually means there is a problem with the Air Suspension. However, it will also come up when alternator or battery voltage is low, or when you reset (disconnect and then connect) the battery. To reset it manually: while in P(ark), turn steering wheel all the way left, hold few seconds, and then all the way right, hold few seconds. All the warning lights will go out. Most common failure is the passenger front air strut, since batteries are prone to leaking acid, it leaks right on top of the rubber airbag and burns through it. Dealer willcharge you one hour to diagnose, or you can easily diagnose this by looking at the ride height of each particular corner of the truck. If its sits low, or emits hissing sound when you park the truck, its leaking. If you keep driving with leaky air strut, you risk burning up the air compressor, as its working extra hard to compensate for the leak. Replacing the strut is easy 45min job even for a novice mechanic, and you can do it yourself. Strut can be found new for approx $750 online. If you are fed up with air suspension issues, there is a $700 kit that converts the truck to springs, and disables all of the air suspension. Look up Arnott Industires

Posted on Jun 15, 2009

  • 12 Answers

SOURCE: fit new indicator stalk to VW passat esp , abs light on now

the stalk should have no interference with the abs or esp set up what i would look at doing is checking your abs sensors they can go all of a flash...goodluck

Posted on Jun 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My esp light has come on and it won't turn off on a Audi a3 2006


TDISLine 1874 solutions Jun 16, 2012
The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty.
You should access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.

Check & replace if necessary the brake pedal switch placed above pedals on the support.

If the problem still occurs you should access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS & ESP ECU, and reset it.

Jan 09, 2013 | Cars & Trucks

1 Answer

The ESP light on my AudiA3 stays on


The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty.
You should access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.

Check & replace if necessary the brake pedal switch placed above pedals on the support.

If the problem still occurs you should access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS & ESP ECU, and reset it.


tdisline_516.jpg

Jun 16, 2012 | 2006 Audi A3

1 Answer

What does ESP light mean on a cls 500 Mercedes Benz


The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty.
You should access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.

Check & replace if necessary the brake pedal switch placed above pedals on the support.

If the problem still occurs you should access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS & ESP ECU, and reset it.


tdisline_516.jpg

Feb 10, 2012 | 2006 Mercedes-Benz Mercedes Benz CLS500

1 Answer

How can I fix my ESP problem on my passat 2002 , when ESP comes on the car struggle till 2400 rev then it s ok?? Help


Check & replace if necessary the brake pedal switch placed above pedals on the support.
If the problem still occurs you should access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS & ESP ECU, and reset it.


tdisline_516.jpg

The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty.
You should access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.
Good Luck!

Oct 26, 2011 | 2002 Volkswagen Passat

1 Answer

Yellow warning indicator lamp of a tringle with an excalmation point in the center and a counterclockwise arrow arround the triangle ---what does it mean?


Check & replace if necessary the brake pedal switch placed above pedals on the support.
If the problem still occurs you might access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS ECU & reset it.
tdisline_516.jpg
The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.
I'm convinced that your brake pedal switch is faulty because the glow plug warning sign went ON after ESP warning light. Just replace the brake pedal switch, see if rear stop lamps light when press the brake pedal, and test the car on the road.
Good Luck!

Sep 06, 2011 | 2005 Audi A4

1 Answer

I have a vw passat TDI130 2003. It runs really well, but engine workshop lights up along with the esp, abs and the glow plug indicators lighting up, most garages are charging just for a diagnosis to the...


Check & replace if necessary the brake pedal switch placed above pedals on the support.
If the problem still occurs you might access the ESP & ABS ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ESP & ABS ECU & reset it.
I'm convinced that your brake pedal switch is faulty because the glow plug warning light went ON, along with the ESP & ABS. Just replace the brake pedal switch, see if rear stop lamps light when press the brake pedal, and test the car on the road.

May 20, 2011 | 2003 Volkswagen Passat

1 Answer

The esp light went on first and then the glow plug warning sign on my 2005 TDi passat. said workshop assistance, what is the problem


Check & replace if necessary the brake pedal switch placed above pedals on the support.
If the problem still occurs you might access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS ECU & reset it.
tdisline_516.jpg
The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.
I'm convinced that your brake pedal switch is faulty because the glow plug warning sign went ON after ESP warning light. Just replace the brake pedal switch, see if rear stop lamps light when press the brake pedal, and test the car on the road.
Good Luck!

May 11, 2011 | 2003 Volkswagen Passat

2 Answers

2008 wrangler. abs, esp and traction control light staying on. checked brake fluid and fuses


Check first the third eye brake light. does it work? okay the problem reside in a ABS sensor make sure it is hook up or if you recently did a brake job it didnt get contaminated. When the ABS signal is interfered with ESP,Traction is disabled. One or some of the wheel speed sensor is disconnected or is being interfered with. This is common for a recent brake job if any occured

Apr 23, 2011 | 2008 Jeep Wrangler

1 Answer

ABS and ESP lights on all the time. I bought Audi A4 B6 2004 only two months ago. It started in heavy rain.


The ESP system means the Electronic Stability Program. If the ESP & ABS lights on the dashboard permanently the ESP & ABS system is faulty. You must access the ESP & ABS Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car (placed in dashboard, under a plastic cover above the ashtray). Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP & ABS ECU, in other words reset the ESP & ABS system and turn off the warning lamp on dashboard.

Dec 31, 2010 | 2004 Audi A4

1 Answer

ESP & ABS light comming on all the time


you should have the ESC/ABS module scanned for DTC's.

here are the 2 most likely causes.

1. low brake fluid
2. sticking/siezing brake lamp switch

at the dealership i see the brake lamp switches go bad left & right on a lot of the newer hyundai's. are your brake lights working?

May 07, 2009 | 2006 Hyundai Sonata

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...