Question about 1984 Isuzu Pickup

1 Answer

Gear Oil Refill in Hoden gemini 1986

How i am going to refill the gear Oil in Holden Gemini Rb 1986

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 88 Answers

Two plugs fill from the bottom one until it comes out the top one

Posted on May 20, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1994 Duster 2.2. Why does the transmission slip in first gear?


clutch is contaminated, it may get better with use, or break down completely, if its auto drain the fluid & refill with new.

Jul 02, 2015 | Plymouth Cars & Trucks

1 Answer

I have a rear wheel drive Holden Gemini I want to swap the engine to a latter model witch had injection. What engine will bolt in?


there will ne an engine family model change from one to the other so to reduce problems I would suggest that you change engine and gear box as a unit. BY doing this you will have a wider range of units to choose from

Jul 17, 2014 | Cars & Trucks

1 Answer

2002 holden rodeo manual tranny filler plug stripped out, will not tighten completely.


A spot of bother but not impossible to repair . A BSP ( pipe plug) plug will do the job so get yourself a BSP thread tap and tap in a new thread . Take care as the plug is a taper plug and the more you screw it in the tighter it gets so when tapping the thread keep checking how much further to go by trying the plug in all the time.. The problem will ne metal filings in the gear box so go slow and the oil will catch and hold the metal . when you have finished then drain the oil and flush the box several times with say diesel fuel . Put the drain plug in each time and the magnet will catch any metal bits as it is splashed around . When you are satisfied that there is no more bits then refill the gear box and drain and refill after a few miles

Feb 22, 2014 | Cars & Trucks

1 Answer

I got 1993 mazda mx3 i changed cv joints and my gear oil leaked out of tranny.. i cant figure where or how to refill


there should be a square divet one low and one high on the side of the transmission that you can unscrew and refill with the gear oil.

May 09, 2010 | 1994 Mazda MX-3

1 Answer

How do I remove the starter motor in my 1986 holden gemini RB. can only find one bolt


The other bolt is straight across from the one you pulled out you will need a 6 inch 3/8 drive extension and a wobble socket or a 3/8's swivel to get it out with. be sure to disconnect the positive battery cable at the battery before removing or trying to remove the opposite bolt or it will short and could cause the battery to explode. Rate if this was helpful. here is a picture of the starter so you can see it this is advance auto. 5841283_wrw_16884_thmb.jpg Worldwide Starter Part No. 16884
Reman; with Automatic Transmission; See Test Chart Page # S-4
Warranty LIMITED LIFETIME REPLACEMENT
$79.99
Core Charge $10.00 ?

Sep 21, 2009 | 1986 Isuzu I-Mark

1 Answer

Wheres the timing marks on the crank and cam for a holden gemini rb 1985


cam gear mark lines up with head at 9 o clock and dowl pin near centre bolt is at 12 o clock
crank gear keyway at 12 o clock and mark in disc behind gear lines up with mark on oil pump at 12 o clock also.

Jun 10, 2009 | 1990 Isuzu Amigo

1 Answer

Automatic transmission adjustment


It could easily be much more than tightening the bands. The transmission may have to be rebuilt. Tell the seller to go ahead and have the bands tightened and show you the bill, and that you will pay it if it is only tightening bands. Bet he will not do that.

Sirwriter

May 24, 2009 | 1986 Isuzu Impulse

1 Answer

Can not find a radiator to fit 84 rodeo


gemini radiator should be ok as they are same engine

Feb 15, 2009 | 1984 Isuzu Pickup

1 Answer

STARTS AND IDELES FINE WHEN PUT IN GEAR AND PUSH ON GAS IT HESITATES BAD IF I FLOOR IT WILL GO


Holden Gemini has two different carbys the difference is the number of pins on wiring loom plug to carby, a couple of these pins are connected to switches on gearbox and it changes the carby settings depending witch gear it is in .One switch on gearbox is reversing lights and others if fitted are for carby.

Jul 18, 2008 | Isuzu I-Mark Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...