Question about 2001 Dodge Ram 2500 Truck

Open Question

2001 dodge 2500 5.9 cummins diesel, 6 speed, just started cutting out and smoking real bad, running rough

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Smlslikdsl
  • 12 Answers

SOURCE: 1999 dodge ram 2500 5.9 cummins diesel

Check the fuel pressure at the filter. Odds are the lift pump, located below the filter, is toast. Continual cranking of the motor with a bad LP wil cause the injector pump to heat up and burn out. Replace the LP and fuel filter. Bleed the system by cracking the inlet to the injector pump and bumping the enigine over so the LP will run. Once you have fuel at the injector pump, crack injectors 1,3,and 4. Crank the motor for no more 6 or 7 seconds at a time until it turns over. Give the pump time to cool for a couple of mintues between cranks. This process is easier with two people, one to crank and the other to watch for fuel and tighten the injectors once it starts. If the injector pump is fried at this point from cranking with no fuel, the motor should idle, but will stumble all over itself when the throttle is applied.

-Brandon

Posted on Jan 31, 2009

  • 3 Answers

SOURCE: water pump replacement procedure 2005 2500 dodge with cummins diesel

take off old water pump. clean up area on the motor real good.do this by using a scrapper and cleaning slolvent. when thats all done put hi temp silicon on the block water pump and the put gasket on silicon. let dry for like five minutes. put in on torque bolts to specs.

Posted on Mar 22, 2009

  • 1 Answer

SOURCE: 2003 Dodge Ram 2500 diesel 4x4 wiring diagram

TPIM PROBLEM , MUST HAVE COMPUTER FLASHED AT DEALERSHIP

Posted on Jun 04, 2009

  • 1 Answer

SOURCE: 2001 dodge 2500 diesel oil leak in front of power

The power steering pump is piggie backed to the vacuum pump. The seal in the back of the vacuum pump has engin oil under presure behind it cousing a leak that gets worse over time. Cummins make a seal kit to fix this leak.

Posted on Feb 05, 2010

dustyboner
  • 331 Answers

SOURCE: Where is the fuel filter located on a 2006 Dodge

It is located on the driver's side of the engine. You will see a yellow handle for the fuel/water separator drain valve at the bottom of the filter housing. The black plastic top unscrews and the filter can be pulled out.868820e.jpga75da07.jpg

Posted on Sep 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Just bought. 5.9 cummins Can`t get it to start without pushing gas pedal slightly. Runs good after warms up. Still have to give it fuel to start.


Numerous Conditions May Cause Engine to Crank But Not ...

repairpal.com > Problems > Dodge > Ram 2500
2006 Dodge Ram Laramie 2500, 5.9i liter Cummins ... I know in the old days the dodges had a way about starting up an engine and that would be where.

White smoke, rough idle at startup - Dodge Cummins Diesel Forum

www.cumminsforum.com > ... > 3rd Gen. Powertrain
Jun 5, 2010 - 9 posts - ‎7 authors I have an 06 Dodge 5.9L that has a light white smoke and rough idle when first ... 2006Ram 2500 QCSB 4x4, 3" Carli coils w/ 1" Daystar spacer, ... Still ran good tho, dispite the exact conditions you describe on Cold Start up.

Oct 20, 2015 | 1995 Dodge Ram 3500

1 Answer

Cummins diesel in 2001 Dodge is cutting out and mild surge. code#s are P0500,P0370 P1693


you have codes related to the pcm, transfer pump and a vehicle speed sensor. these could be related or all individual issues. related issued could be wiring, untill you start doing testing it will be hard to tell.
start cheap and test the speed sensor first, then you can clear the codes and continue on any codes come back.


Disconnect the PCM harness connector(s).
Disconnect the Vehicle Speed Sensor harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the 5 Volt Supply circuit between the VSS harness
connector and the PCM harness connector.
Is the resistance above 5.0 ohms?

Jun 10, 2012 | 2001 Dodge Ram 3500 Truck

2 Answers

Its a 2004 2500 4x4 6 speed 5.9 cummins. got the front end hunh up in a deep mud hole. it has very little power now and has a wineing noise the more gas you give it. dont wine when idling. when you give it...


Sounds like you either broke (small crack) or may be smashed/crimped a fuel line. White smoke in diesels means that there is not enough fuel or that there is air getting in the line some how. Don't confuse white smoke with a blown gasket, this would smoke all the time

Feb 20, 2011 | 2004 Dodge Ram 2500

3 Answers

Bought 01 dodge, 2yrs ago, has 300,000 miless,


Well, Hate to say this to you but your Cummins 24v turbo diesel does not have glow plugs. The fuel temperature necessary for proper ignition is heated by an element inside your fuel filter housing.

Mar 25, 2010 | 2001 Dodge Ram 2500 Truck

1 Answer

2001 dodge 2500 diesel oil leak in front of power


The power steering pump is piggie backed to the vacuum pump. The seal in the back of the vacuum pump has engin oil under presure behind it cousing a leak that gets worse over time. Cummins make a seal kit to fix this leak.

Dec 26, 2009 | 2001 Dodge Ram 3500 Truck

1 Answer

Dodge Ram 2500 Cummins Diesel 2001. Starter hangs up when start


Have you had a mot or try checking with an mechanic¬!

Jul 29, 2009 | 2001 Dodge Ram 2500 Truck

1 Answer

Rough idle and generally running terrible!


if idling rough sound like air in system.and your injection pump timing is off.

May 23, 2009 | 1999 Dodge Ram 2500 4WD

1 Answer

2003 Dodge Ram 2500 diesel 4x4 wiring diagram


TPIM PROBLEM , MUST HAVE COMPUTER FLASHED AT DEALERSHIP

Apr 21, 2009 | 2001 Dodge Ram 2500 Truck

3 Answers

Need info on rough idel 5.9 cummins


bad injector?
easy to test with vom, just check from terminal on injector to ground if one reads different thats the problem, you do need to disconnect wire to check, my help is free and will be glad to help further just vote fixa..LOL my rating is all I care about. Hope yu can help me too.

Dec 19, 2008 | 2004 Dodge Ram 2500

1 Answer

Water pump replacement procedure 2005 2500 dodge with cummins diesel


take off old water pump. clean up area on the motor real good.do this by using a scrapper and cleaning slolvent. when thats all done put hi temp silicon on the block water pump and the put gasket on silicon. let dry for like five minutes. put in on torque bolts to specs.

Aug 22, 2008 | 2005 Dodge Ram 2500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...