Question about 2005 Chrysler Sebring Conv

1 Answer

2005 Sebring There is a "squeal" noise under the glove box when fan motor is turned on.

If i put my hand under the glove box and apply pressure the noise stops but as soon as I remove my hand it starts again. It doesn't matter if it is on 1-2-3-4 setting it still makes a hoorible noise.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chrysler Master
  • 3,103 Answers

Motor is loose and fan is rubbing on housing.. need to fix or it will burn the motor out..

Posted on Dec 31, 2013


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 22219 Answers

SOURCE: my blower motor makes loud noise on top settings

new motor by the sound of it ,but never worked on one so i couldnt tell you where it is,other than its no doubt a complete unit with the resistance so it will not be cheap

Posted on Nov 18, 2008

  • 147 Answers

SOURCE: only blows air from defrost vents

You have a failed vacuum supply for the HVAC unit. Vacuum is supplied from intake manifold of engine. Listen for hissing noise in engine bay while running to try to pinpoint failed vacuum hose.

Posted on Mar 29, 2009

  • 2 Answers

SOURCE: 2005 chrysler sebring start then dies right

i bought a 2005 sebring and they gave me 2 keys. one grey and thick. the other black and less heavy. the black one will start the car but as soon as i take it out of park it dies. the grey key has a chip in it that sends a signal to the engine. The black one doesn't. it is more like a back up key so that if you lock your other key in the car and it also unlocks doors and trunk.

Posted on Oct 24, 2009

  • 1168 Answers

SOURCE: is there an low oil pressure automatic engine shut

Ouch. This one doesn't sound good Adrienne. Sorry. No automatic shutdown for low oil unfortunately. 1.25 qt of oil isn't enough. Sure sounds like a seized engine.

Posted on Nov 01, 2009

  • 16 Answers

SOURCE: heating problems

replace the heating core but change the antifreeze first and clean the system and make sure there's no stop leak in the hoses. you will need to flush the heater core out completely several times to know for sure.

Posted on Mar 06, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My blower motor dosent work on my 2005 mercury sable

Probably your blower resistor switch (it's the part that gives you your fan speeds) is bad. You can test your blower by applying 12volts to it and see if it spins. The blower motor and resistor switch are both under/behind your glove box. Both should be easily accessible after removing panel above feet.

Oct 16, 2015 | 2005 Mercury Sable

1 Answer

Access fan box 2005 chrysler sebring

The blower motor comes out of the bottom of the box behind the glove compartment. Taking the entire heater box out is a bigger job than most DIY can handle.

Jul 02, 2013 | Cars & Trucks

1 Answer

Where is the blower fan?

The blower motor should be on the passenger side under the glove box. The noise is probably the bearing in the motor.

Jun 05, 2013 | 1994 Mercury Capri

2 Answers

2005 pontiac vibe just started making like & popping noise on the passenger side behind the glove box under the dash and the noise stops when the car is off. No heat or air was on

you have a bad actuator motor or a broken blend door in the heater box, the noise you hear is the skipping of the gears in the actuator motor, the ehating system along with ac use motors to move doors inside the heater box, the doors control the flow of the air and the temp, you will need to locate the bad one by unplugging one at a time, when noise stops you have the right one, remove it by removing screws that hold it to box. with motor removed look at the hole that controls the door, you will see a small square that the motor turns ,this id part of the door hinge, you should be able to turn side to side, this swings door left and right like a rood door, open or closed, if the door swings good then the actuator is bad, let me get a picture to help you located it, you will located the heater box in the location of the noise, behind glove box, try to acess from the bottom of the dash and also remove glovebox,hope this helps, good dayjohnjohn2_96.jpg

Apr 13, 2011 | 2005 Pontiac Vibe

1 Answer

My heat is not working at all! When I turn the fan on I hear a clicking under the glove box. I was told that it may be the fan that is makeing the noise. What do you think?

If your fan is running as normal, then I doubt it's that. Sounds more like the blend/air door may be stuck. Here's a picture from a 99 I had to replace blower motor on. Look to left of blower motor in housing you will see the door I'm talking about. It's electrically controlled by motor attached to bottom of housing. Put your finger on that motor to see if you feel it clicking when you hear that noise. You may be smart to remove bottom part of housing(ducting) to access it, and try to free it up by hand, or remove electric motor and try to rotate shaft to see if it's free first. If it does move freely, then I'd replace the motor. If not free, then remove housing as I said and see if you can get it freed up by hand.motor1258_4.jpg

Jan 06, 2011 | 1998 Plymouth Grand Voyager

1 Answer

Hi, I was wondering if I can fix the loud noise with my fan. It is getting louder and louder. 2005 Camry LE.

I would suggest to you to remove the lower cover, under the glove box, and then the glove box door. Next, remove the 3 screws that holds the heater fan motor to the heater box. Then, lower the fan motor out of the box area. You will probably find some debris in the fan part of the motor./fan assembly. If you car has a cabin air filter, I would also recommend that you change it at this time, whilst you have the cover off. This is a very easy job.

Nov 13, 2009 | 2000 Toyota Camry

1 Answer

Where would I find the blower/fan relay on a 2005 Hyundai xg350L?

It would be under your glove box. if your blower motor only blows on hight you need a transistor it is in the same location under the glove box.

Mar 26, 2009 | Hyundai Motor 2005 XG350

1 Answer

Heater/ac fan will not come on at all. I can feel heat when i put my hand to the vent, but the blower/fan is not working. I checked the fuse and it is fine. What could be the problem?

Test the blower motor by jumping 12 volts to the blower motor connector, if it works you have a defective blower motor speed control resistor which is located just next to the blower motor, i recommend u replace both as the blower motor ages it draws more current and this causes the resistor fail, u should be able to buy these parts in the aftermarket, the dealer parts will be very expensive.

The blower motor is behind the glove box. Remove the glove box (3screws, 1 on the left side and 2on the bottom). Remove the glove box lower frame (4 screws). The blower motor assembly will be on the right hand side under the dash

Jan 23, 2009 | 1992 Honda Accord

1 Answer

Sound coming from passenger side when i turn the heating fan

I would remove the fan motor. You may have ingested something from the glove box into the fan motor. This is a known issue, the opening for the heater box is directly behind the glove box, and papers can get sucked into the heater fan. The fan is held on by 3 screws, under the glove box, it is easy to remove.

Regarding the coolant loss, I would suspect that you have a water pump leak. A slow leak is not uncommon, and a pressure test will hold the pressure. I would have the water pump examined.

Hope this helps; a FIxYa rating for my assistance would be greatly appreciated.

Jan 14, 2009 | 2003 Toyota Tundra

Not finding what you are looking for?
Cars & Trucks Logo

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides