Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
yeh its located under the passenger side glove box,its in the heater box beside the heater motor ,,2 scews hold it in and it looks like a credit card when its out,,,,
Posted on Apr 19, 2009
Chanses are its the resister, it should be located by the heater motor, most are above heater box behind glove box.
Posted on May 16, 2009
Hi some of them are a pain ,but if your paitient you'll get it ,they are normally held in by 3 7/32nd bolts just remove the connector and remove the screws and it will come out ,if the floor insulation under your carpet gets in the way I usually carfully take a utility knife and cut out a small square to allow more room to pull it down and out ,depending on the placement of the resistor.
Posted on Aug 08, 2009
There isn't a torque spec since those bearing are pre-loaded. You place the unit on a good known vic and get a breaker bar and you might even have to put an extention on that and you begin to tighten unitil you fell the bearing start to load...a little extra short turn wouldn't hurt at that point.
Posted on Oct 05, 2009
Tips for a great answer:
Dec 03, 2015 | Cars & Trucks
Feb 08, 2012 | 2000 Chevrolet 2500
Jun 23, 2010 | 1991 Chevrolet Silverado 2500
Apr 10, 2010 | 2006 Chevrolet Silverado 2500HD 2WD
Jun 24, 2009 | 2000 Chevrolet Silverado 1500
May 16, 2009 | 2003 Chevrolet Silverado 2500
Feb 03, 2009 | 2000 Chevrolet Silverado
Jan 06, 2009 | 2005 Chevrolet Silverado
79 people viewed this question
Usually answered in minutes!