Question about Cars & Trucks

1 Answer

Where do I put oil in my 99 gmc jimmy - Cars & Trucks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Cars & Trucks Expert
  • 412 Answers

Should have a cap on the valve cover.

Posted on Jan 01, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

alicantecoli
  • 22095 Answers

SOURCE: What is the cause of High emissions of Nitrous Oxide on 99 GMC Jimmy

new catalytic converter and oxygen sensors

Posted on Nov 05, 2008

  • 2 Answers

SOURCE: remove airbag 99 gmc jimmy

I actually just took mine out today on a 1998 Gmc Jimmy. Its kind of simple now that ive done it. There are four ten millimeter bolts holding the passenger module in. you will need to drop your glovebox down so it is upside down to see these. It is easier if you take it right off. just take a shop light and look at the bottom of the module you will see two silver bolts (the only two ten mm down there) take them out. Then if you look up underneath you will see another up at the top left. To get this out you can hand wrench it or you can use a mini impact with an ajustable extension. to get the next the easiest way I found was to take off the trim aroung your speedometer get in the drivers seat and there is another ten millimeter nut on the top right (right by the vent holes) take that out then you are unbolted. Without going into tons of details when you start doing it you will quickly realsie how to do it it just takes some patience. Dont forget to pull the fuse before you do anything its a 15 amp fuse second row 3rd up in the panel inside the car. Hope this helps

Posted on Mar 04, 2009

  • 7 Answers

SOURCE: my '99 gmc jimmy has a clicking noise inside the

Your valves need to be re-shimed  If your motor is the 2.2 the problem is quite normal.  Expensive to fix but normal.  You can sill drive the car fine. 

Posted on Mar 23, 2009

rsst
  • 175 Answers

SOURCE: Bad oil leak driver side front fender

There is an adapter for the oil filter with 2 lines coming out of it above the drive shaft from the transfer case to the front differential. The O ring on these will go sometimes causing loss of oil. Also check the 2 lines for leaks and cracks.

Posted on Jul 09, 2009

  • 468 Answers

SOURCE: 1999 gmc jimmy w 4.3 v6. cannot find oil filter

look under the front of your blazer, just below the bumper, and you will see a little access door in the plastic guard. Open this door, and you will find your oil filter.

Posted on Dec 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I replaced blower resistor on my 99 gmc jimmy its still blowing on the same speed as it was. could it be the relay?


Could be the switch.
Can you check for voltage on the terminals for the resistor ?

Jul 05, 2012 | 1999 GMC Jimmy

2 Answers

I have a 4WD 1998 GMC Jimmy 4.3L Vortec V6 and it started running hot then it shut off and wouldn't start back up... do you think there would be any way to fix without replacing the whole engine


IS THEIR WATER IN THE OIL? CHECK THE PLUGS TO SEE IF THEIR WET.YOU MIGHT PUT SOME PLUGS IN IT IF WET TO SEE IF IT WILL RUN.THEN PUT SOME HEADGASKETS ON IT.BUT IN REALITY NEW MOTOR WOULD BE BEST.

Aug 26, 2011 | 1998 GMC Jimmy

1 Answer

Where is the oil filter located on 99 jimmy


not at rear corner of block by transmission.?

Aug 08, 2009 | 1999 GMC Jimmy

1 Answer

Bad oil leak driver side front fender


There is an adapter for the oil filter with 2 lines coming out of it above the drive shaft from the transfer case to the front differential. The O ring on these will go sometimes causing loss of oil. Also check the 2 lines for leaks and cracks.

Jul 07, 2009 | 1999 GMC Jimmy

1 Answer

Transmission replacement


no the year is not interchangeble,the latest you can put from 99 then tranny get new profile

Jun 14, 2009 | 1998 GMC Jimmy

1 Answer

Transmission oil leaking


Out put seal.leaking.allso check the pan gasket.

Jun 11, 2009 | 1999 GMC Jimmy

1 Answer

I cant find the oil filter on my jimmy


At the very front, under front bumper of skid plate, there is a small drop down panel, filter is behind that.

Mar 30, 2009 | 1999 GMC Jimmy

1 Answer

My '99 gmc jimmy has a clicking noise inside the engine. the oil is full and it started after taking a long trip.....400 miles


Your valves need to be re-shimed  If your motor is the 2.2 the problem is quite normal.  Expensive to fix but normal.  You can sill drive the car fine. 

Mar 22, 2009 | 1999 GMC Jimmy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...