Question about 1996 Hyundai Sonata

1 Answer

Fan/Blower There is a selector lever that can be moved to select where you would like the blower to feed the air from ie you can select to blow on the foot, windscreen or on yourself. My blower, even after selection does not blow from the front (facing you) but blows from all other openings when selected. Your tips will assit.

Posted by on

  • hafif May 26, 2009

    Kindly advise how do you get to the 2 levers, what components you have to take out to reach the levers.

  • hafif May 27, 2009

    Thank you and will try this out in the weekend.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 90 Answers

There are two cable under the dash that lead to the flaps in the heater. One of these has slipped and needs resetting. Hope this helps.

Posted on May 20, 2009

  • Derek Bannister
    Derek Bannister May 27, 2009

    Hi again. Right up under the dash you will see the cables that go to the heater flap. You may have to take away the lower part of the dash. I think the cables are on the left hand side. Hope this helps.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Heat and air wont blow through vents


The selection door, is operated by 1/4" vacuum hoses. When turning the knob or sliding a lever, to select between floor, vents, or dash deck for windshield defrost, vacuum is created by the valve body and the blower will then blow thru the desired vents. When these hoses/lines are compromised, especially on a vehicle over 15 years old it seems likely, vacuum won't be created, and the last working position, is normally where it stays! Until the lines are replaced.
Good luck.

Mar 24, 2015 | 1998 Buick LeSabre

2 Answers

Suzuki x4 2009 fan does not spin but when I turn air on it blows cold air.


Not sure which fan you mean. Engine cooling fan is different from heat/air blower fan.

Feb 04, 2015 | Suzuki Cars & Trucks

1 Answer

Defrost isn't blowing air


ur r going to have to check the button or the release lever that alouds u to move the air to the other positions sometimes that's the problem

Nov 29, 2013 | 1996 Volvo 850

2 Answers

1997 ford explorer ac blows out console, but not out of dash. replaced dah switch, and know replaced front dash blower motor resistor. still n change. can anyone give me a clue??? thanks.


There are two parts to the heating unit that control the air.
1. the blend door, this moves when you change from hot to cold.
2. The selector changes where the air comes from. This is what the problem is in your case. Look at the plenum (area under the dash that has the motor and levers connected to and see if one of them moves when you change modes. Sometimes the selector lever will move but the actual door inside the plenum is broken off.

Aug 31, 2013 | Ford Explorer Cars & Trucks

1 Answer

When i turn on the ac no air blows throw


Go to the fuse block and check 15A fuse D which feeds power to the blower motor. Then check 10A fuse K which feeds power to the blower relay and the fan (blower) speed select relays. If the fuses check OK, the blower relay, the fan switch or the speed control relays may be defective. also, the fan speed resistor may be defective

Oct 17, 2012 | 1993 Nissan Pathfinder

1 Answer

I turned on the ac and the light does not work, the vents are not blowing and the car is running hot. I have a saturn SL 1996


First check the 15 amp HVAC fuse located in the main fuse block inside the car on the passenger side of the center console, under a cover. If the fuse is good, then the problem may either be the HVAC blower switch (which is the fan blower selector switch), the fan blower motor resistor, or the fan blower motor. An auto repair manual will explain and illustrate for you the steps on how to check each of these components.

Even after pushing the ac light switch on, the fan blower selector switch has to be turned on as well (working) because it provides an electrical path to the positive side of the battery to complete the circuit and turn the ac light on. What the ac light switch does is provide the electrical path for the ac compressor clutch to come on through the ac control relay which is controlled by the car's PCM(computer) when you want ac, but the ac light switch still needs to run through the fan blower selector switch to receive its power. You can turn on the fan without the ac light switch because it gets its ground path(negative) from the blower motor. So the blower motor has to work in order to provide a ground path for the fan blower selector switch to be functional. You could have a faulty blower motor which is why no air blows through the vents. The fan blower motor is located inside the car on the passenger side underneath the dash at the bottom end of the glove compartment box. You'll see it. It's right above where a person rests their feet on the floor. Therefore, if your 15 amp HVAC fuse is good, check to see if you have voltage at the blower motor connector. Unclip the connector and with the ignition on and the fan blower switch moved to any one of the first 3 selections, check for voltage using a multimeter. The voltage will vary because there is a blower motor resistor. Voltage should be higher on setting 3 than 1. If you do have voltage at the blower motor connector, check for a faulty blower motor. The auto repair manual will tell you how to do it using jumper wires.

It's normal that your car is running hot because the radiator fan works in conjunction with your ac compressor. If the ac is on, the radiator fan will be on and therefore the engine coolant temperature will stay in it's normal operating range. If the ac is off, the radiator fan will stay off as well and the engine coolant temperature gauge will begin to rise and show pretty hot (especially at idle). It will do this up until a certain degree then the radiator fan should turn on thermostatically and stabilize the temperature. It's scary and I know what your saying because it does that to my car if my ac isn't on. Don't worry it won't overheat.

May 29, 2011 | 1996 Saturn SL

1 Answer

Fan which blows heat doesn't work when toggle at dash board is moved to high.


When your fan switch is placed in the high position, it feeds directly to the fan motor and bypasses the blower motor relay. If the fan is operating on speed 1-3, then you have one of two things wrong, either you have a blown fuse, or the fan selector switch is faulty on the high setting.

Mar 29, 2011 | Geo Tracker Cars & Trucks

3 Answers

HEATER NOT WORKING IN 2001 LEXUS RX 300


you most likely have a bad airmix servo. this happens alot on these. they are expensive to replace too.

Sep 10, 2009 | 2001 Lexus RX 300

5 Answers

Blower not blowing


can you hear the fan working on all speeds?

Sep 22, 2008 | 2002 Jeep Grand Cherokee

Not finding what you are looking for?
1996 Hyundai Sonata Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...