Question about SsangYong Rexton

Open Question

HDC Light is on

The HDC, ESP and ABS light is on in my Rexton the auto gear bos also jumps into neutral whilst driving

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: ABS, ESP, Level warning lights (2004 Allroad TDI)

I had the brake light switch replaced by a local dealer. Cost was $140 and it fixed the problem. Have driven the car for two weeks since and no lights and all systems normal.

Posted on Oct 15, 2008

Ad
  • 1 Answer

SOURCE: Air suspension inactive, HDC inactive, ABS light on, Range Rover

Air Suspension Inactive usually means there is a problem with the Air Suspension. However, it will also come up when alternator or battery voltage is low, or when you reset (disconnect and then connect) the battery. To reset it manually: while in P(ark), turn steering wheel all the way left, hold few seconds, and then all the way right, hold few seconds. All the warning lights will go out. Most common failure is the passenger front air strut, since batteries are prone to leaking acid, it leaks right on top of the rubber airbag and burns through it. Dealer willcharge you one hour to diagnose, or you can easily diagnose this by looking at the ride height of each particular corner of the truck. If its sits low, or emits hissing sound when you park the truck, its leaking. If you keep driving with leaky air strut, you risk burning up the air compressor, as its working extra hard to compensate for the leak. Replacing the strut is easy 45min job even for a novice mechanic, and you can do it yourself. Strut can be found new for approx $750 online. If you are fed up with air suspension issues, there is a $700 kit that converts the truck to springs, and disables all of the air suspension. Look up Arnott Industires

Posted on Jun 15, 2009

  • 750 Answers

SOURCE: GEAR NEUTRAL LIGHT BLINKING WHILE THE CAR IS ON DRIVE

faulty contacts in neutral switch replace with new unit

Posted on Oct 08, 2009

  • 165 Answers

SOURCE: My Mercedes ML 270 cdi ABS etc lights and gearbox.

  • you need a Brake safety switch replaced.This is located behind you brake pedal.it's a common problem. The warning lights will reset after a few engine starts.

Posted on Nov 17, 2009

tneubauer
  • 437 Answers

SOURCE: my esp/bas light and the red airbag and abs lights

ESP = Electronic Stability Program
BAS = Brake Assist System

Posted on Jan 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 Mercedes E430 base sedan. Last week I replaced the brake light switch because it was out and it solved the problem to the point that I can now put my car into gear and drive it, however, as...


Brake light switch problem may cause the ESP / BAS lights to illuminate.

Common symptoms of a bad
Mercedes brake light switch.
  • Car stuck in Park.
  • ABS ESP ETS lights come on.
  • Can not move the shifter from Park to Drive.
  • Brakes Defective Warning on Instrument Cluster
  • Car won't shift gears. Stuck in 2nd gear, limp mode.
  • Brake lights don't work. (Brake light switch can still be defective even if the brake lights work. Checking the brake light operation is not a good test.)
  • ESP, BAS, ABS lights turn on. Car won't shift properly. Stuck in gear.


TEST: To test your new brake light switch: Turn you car off to reset the ABS light. apply the parking brake. and start the car in neutral or park without using the brake. if the problem is the brake light switch... the light will only come on when you press the brake pedal.

If you replaced the brake light switch and the light is still on you should check a few other things such as:

  • Fuses and Relays
  • ABS pump
  • ABS wheel speed sensor
  • Brake Fluid Level
  • Get an advanced scanner to read trouble codes.


NOTE: ** You may need a MBZ scan tool to reset the error code which was stored in the ECU because of the bad brake light switch.

Feb 25, 2015 | 2000 Mercedes-Benz E-Class

1 Answer

Esp driving


location not stated, or road conditions. nor if in 4low , nor if the ESP switch is off or on. Ask Suzuki for help (lol) or any ASE shop.

it's not magic, it can not give traction , if none.
on ice slow down. (esp can do that too. slow you,brake you and even
shift gears in the transmission)

are you in 4wd? or high 4Low, esp is inactive. (or limited)
read the operators guide. (if lost, get one now)
read the page on driving on ice.
chapters 5,6,7.
have you had any off these conditions , related to ESP, this a
is the ESP light acting wrong, or CEL check engine light running?
are all dash lamps (warning) showing correctly per the opr. guide?
ESP & ABS are vary complex, (not magic)


quote from the servise manual. (car battery dead or disconnected?)
ESP control module
When ESP control module is removed / installed, do
not use impact wrenches which generate shock or
impact to avoid damaging sensors in ESP control
module.
Note that Calibrate word here..!
When any of the following operation is done, calibrate
steering angle sensor, G sensor and master cylinder
pressure sensor (in ESP control module) referring to
"Sensor Calibration in Section 4F
- When battery or dome fuse is removed. (
a low battery or weak)
- When steering angle sensor is replaced.
- When ESP control module is removed.
- When yaw rate / G sensor assembly is removed.



read this, it covers this system well,

http://www.wkjeeps.com/wk_esp.htm

read page 7-2 here (the do not drive words)
http://www.autodealertools.com/quickQuote/manuals/2007/Grand%20Vitara.pdf

this car has no center differential. (read limits there of)
are you using chains on the tires?
oper guide page 4-6 , read that yet?

If the vehicle speed is greater thanapproximately 30 km/h (19 mph), the ESP systems (other than ABS) will turn
on automatically and the light will go out.
When the transfer switch (if equipped) is
turned to the "4L LOCK" position, the

ESP systems (other than ABS) will be canceled automatically. The light will come on and stay on.
• If the ESP systems operate continu-ously such as when driving on slippery roads, the traction control functions of the ESP systems may be canceled temporarily to avoid overheating the brake pads, and the light will come on. After a short period of time, the ESP.

(this latter cut out happens, with wild driving)

Dec 05, 2013 | 2007 Suzuki Grand Vitara 4WD

2 Answers

2004 freelander v-6, auto, 2wd, 46400miles, on a 4 to 10 mile trip. The service engine soon light comes on, with hdc amber light with ! Comes on. The rpm jumps to 3700-3800 at 70 mph. It's as if you are...


If the hdc light is on check the wiring to the hdc switch on the gear lever and also check/clean/dismantle the brake switch on the pedal.
if you worry about vis motors see how to check them, monitor them and fix them here in this video

Sep 08, 2013 | 2004 Land Rover FreeLander

1 Answer

Transfer case jumps out of gear


sounds like a servo or sensor problem more than a transfer case. try removing all electrical plugs to t case run it through the gears then replace one by one to see if there is a problem there.

Oct 27, 2012 | 2001 Isuzu Rodeo

1 Answer

Gear shift stays in park and abs esp and asr lights on


1) try to use the self diagnose.
2) place ignition swtuch in the start position, the lights coming on
3) engine starts, the brake light sould turn off inmediately. the ABS ligth will illuminate for aprox 6 seconds.
4) test drive the vehicle at speed above 20mph for a few minutes. during the test the both test lights should remain off, if any one of the warninign light utron, take note of the condition.
5) stop the vechicle using the braking pressure.both light should remain offf during the stopping procedure.
60 place the gear selector in to PARK, and observe the warning lights, they should both be off.
God bless you

Jul 09, 2012 | Cars & Trucks

1 Answer

I have a 2000 Audi TT Quattro (180). Both my ABS and ESP light were on. I took it to my local garage who replaced a front wheel sensor which eliminated the ABS light. After a 30 mile drive the ESP light...


Check bearing and joint/knuckle on every wheel and even on the drive shafts, if there is lack/knocking, that could cause abs and esp light, because sensor doesnt give right information and ecu only records sensor fault but doesnt say why the infromation is wrong.
They changed the sensor but didnt solve the cause!!!

Feb 17, 2011 | 2005 Audi A3

1 Answer

I have a 05 Magnum with around 170,000 miles on it. The ABS and ESP lights are on as well as the engine light. The ABS and ESP lights were on for about 4 months and when I slowly went through a 10"...


have a fault scan done by a reputable shop or auto parts store. Anytime lights come on indicates a fault was tracked by OBII. You should get addressed ASAP when lights come on. Driving 4 mos. could've caused major damage. But in this case I think it was a low voltage issue that triggered lights, regardless, get scanned and address the issue correctly.

Jan 09, 2011 | 2005 Dodge Magnum

2 Answers

Abs warning light comes on and stays on whilst wv bora 2000 w reg


sounds like the usual ,one of the ring gears on the drive shafts has come loose

Dec 01, 2009 | 1996 Land Rover Discovery

3 Answers

My Mercedes ML 270 cdi ABS etc lights and gearbox.


  • you need a Brake safety switch replaced.This is located behind you brake pedal.it's a common problem. The warning lights will reset after a few engine starts.

May 18, 2009 | 2002 Mercedes-Benz M-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

647 people viewed this question

Ask a Question

Usually answered in minutes!

Top SsangYong Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

terry stevens

Level 3 Expert

991 Answers

Are you a SsangYong Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...