Question about 1998 Chrysler Town & Country

1 Answer

After oil change, light comes on and it dings non-stop

I need to know how to reset my maint. switch on my van, my oil light keeps dinging since i have had an oil change

Posted by on

  • Greg Bernett
    Greg Bernett May 11, 2010

    Just a question, do you have the owners manual?

  • Anonymous Mar 20, 2014

    oil light came on had oil changed at auto shop picked car up now oil light comes on and dings runs fine no noises from motor oil level fine took it back to shop they reset the computer but problem still there

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

DISCONNECT YOUR BATTERY FOR TEN SECONDS , THEN RECONNECT IT.

Posted on May 20, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 Plymouth Voyager. When stopping/slowing down the car while turning to the right the car makes 3 consecutive beeps. ding, ding, ding, and the check oil light flashes for half a second.


Hi, have you dipped the the oil and checked you have enough in the engine to keep it within the correct quantity to keep your engine safe . The only other option is the engine oil sensor needs replacing.

Jan 08, 2016 | Plymouth Cars & Trucks

1 Answer

Can someone help me my pt cruizer 2004 oil come one and blinks on and off and ding a lot if i change my oil would it stop and stays off


Yes, changing the oil will help, however, you will also have to clear the "change oil" light. Either figure out what buttons to press to delete that, or go to an auto parts store and ask if they can help you reset it.

Mar 07, 2015 | 2004 Chrysler PT Cruiser

1 Answer

Why does my oil light keep coming on and dinging?


You need to take your van to a repair shop or garage and get the oil pressure checked with a mechanical guage. It sounds like your oil pump could be going bad. This could cost you an engine if you aren't careful.

Aug 01, 2014 | 1999 Chrysler Town & Country

1 Answer

2004 Chrysler Pacifica oil light on and dinging


This is the pressure light I think. Have that looked into RIGHT AWAY before you burn out the bearings in the engine.

Mar 20, 2014 | 2004 Chrysler Pacifica

1 Answer

My 95 Ford Windstar has just developed a rather distressing problem. In the morning, I get in my van and everything is fine. A few hours later, when I get in my van and start it, there is a warning bell...


one of the door ajar switches are sticking. needs to be put on the computer to find out which one. only other way is to go around and unplug the switches until your light shuts off.

Mar 30, 2011 | Ford Windstar Cars & Trucks

1 Answer

My brake light is on and it keeps ding ding dinging and its very anoying because the E-brake is off. my problem is i lost the cover for my fuse box under the dash, so i dont know what one to pull to stop...


under the dash at the E brake there will be a single wire should be TAN with a WHITE tracer (stripe) and a black connector disconnect that and the dinging should stop then you can replace that switch that you just disconnected
hope this helps

May 19, 2010 | 1997 Pontiac Bonneville

1 Answer

Annoying alarm dinging until van reaches 17mph


This means one of the door ajar sensors is stuck. You need to remove the door trim panel and then the latch and then the sensor. Once out clean and lube it. There is a sensor inside every door.

Mar 16, 2010 | 1998 Ford Windstar

1 Answer

Oil light comes on and dings all day


If engine is not ticking or knocking while running, likely the pressure sender is faulty. If changing it makes no difference, have actual pressure checked with a mechanical gauge.

May 28, 2009 | 1997 Plymouth Grand Voyager

1 Answer

My Oil light and dinging won't go off


Replace oil pressure sensor. Location back side of engine block. A shield protects the sensor. A special deep well socket will take you less then 5 min to replace. Without the tool humm I might still be working on mine.

Feb 08, 2009 | 2004 Chrysler PT Cruiser

Not finding what you are looking for?
1998 Chrysler Town & Country Logo

602 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...