Question about Cars & Trucks

1 Answer

93 suburban transmission

When driving my 93 suburban its shifts from first to second and when i get to 35 it doesnt want to shift. all it does is whines

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,103 Answers

Check fluid levels add if low.. filter may be clogged up..

Posted on Dec 31, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 93 Lincoln Town Car wont shift out of first until starts to overrev

Bring it to a mecanic for a tranny tune up

Posted on Nov 09, 2008

csmock132
  • 4669 Answers

SOURCE: 1997 Suburban 4x4 5.7L Transmission whines until it shifts

You rear planetary set is worn from a restricted cooler.

Posted on May 06, 2009

  • 1 Answer

SOURCE: Transmission wont shift into 3rd gear.

I had this exact problem on my 2005 5.3L Suburban... It would shift into 1 and 2 and reverse, but not 3 and 4.

I took it into a transmission shop, and he said the 3-4 shift solenoid was burned up. Wanted 1500 to fix it. Far from home, so I have to pay it.

Posted on May 31, 2009

  • 41 Answers

SOURCE: I have a 93 Chevy Suburban 1500 and the

yes just change out the tail shaft the electric speed o into the older one i just changed out a 84 to a 93 trans very easy

Posted on Jun 25, 2009

  • 11 Answers

SOURCE: How do you remove the gear shift lever on a 93 ford ranger?

many of these trucks have a mazda trans in them, to remove these shifters you will need to remove the 4 phillips head screws from the corners of the trim around the shifter boot and pull it up out of your way. it's not necessary to remove the boot from the shifter, just lift it up for access to the top of the trans. at the base of the shifter on the top of the trans you will see a plate attached with torx head screws. remove all but 2 of them, now make sure the trans is in neutral and remove the last 2 screws and pull the shifter straight up. the shifter is now out leaving a big hole open on the top of the trans for dirt to fal into so put a wrag in it or screw a piece of cardboard to it. installation is the reverse. good luck

Posted on Oct 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Suburban transmission hard shifting from first to second only


How long have you owned it? Is it possible there is a shift kit installed for towing? Was there something that was done just before it started doing this? A tune up perhaps?

Dec 05, 2013 | Cars & Trucks

2 Answers

My 2001 chevy suburban feels heavy like it wont shift


check transmission fluid level,could be very low transmission slipping not going into over drive.if been long time change transmission fluid and filter.if transmission fluid filter already been changed other problems cause transmission not to shift could have worn broken need adjusting.governor valve sticking, governor drive gear worn, governor weights or springs missing or damaged. you could have sticking first and second shift valves.your first and second servos pistons seals stuck or damaged. do fluid change and add some high mileage transmission treatment go to any auto parts stores find transmission additive that will loosen up transmission sticking shift valves in the valve body. if your check engine light is on have vechicle code scan for faulty tps in which will cause transmission not to shift over drive.

Oct 16, 2012 | 2003 Chevrolet Suburban 1500

1 Answer

Can I convert a 87 suburban from throutlebody fule injection to carberated without changeing the 700R4 transmision dose the trans.need the computer to work.


that transmission should be using a kick-down cable for shifting. the700r4 did not go to electronic shifting untill 93.

Jan 07, 2011 | 1987 GMC Suburban

2 Answers

After a long drive, especially in warm weather my 1999 Silverado shifts really hard going from first to second..then it goes away ..might be a heating problem?


The hard shifting you are experiencing is caused by slight wear in the valve body in the transmission. It doesnt mean your tranny is bad though. This hard shift will only usually occur when the transmission temp reaches 93 degrees. So you could rebuild the valve body or sometimes a tranny flush is a temp fix.

Sep 22, 2010 | 1999 Chevrolet Silverado 1500

3 Answers

Transmission only drives 35 miles per hour,stays in second gear.


I will need to know the transmission we are talking about. Here is a site that will help you identify your thttp://www.nastyz28.com/chevy-transmission-identification.phpransmission.
I would say it is the shift solenoid, but we must know which applys, please let me know.

Feb 08, 2010 | 1994 GMC Suburban

1 Answer

1993 Suburban 4 speed automatic transmission shifts hard front 1st to second. Transmission is 3 years old, 15,000 miles. It is a factory rebuilt.


That should be the L60-4 truck version
Have the sedan version, 93 Caprice.
That was the first year of the new electronic shifting transmission.
Especialy when cold she will shift hard, but it's normal.
But that depends on what you call normal.
I have gotten used to it over the last 17 years.

Jan 27, 2010 | 1993 Chevrolet Suburban

1 Answer

My 93 suburban will not shift out of 1st..i haven't drove it atleast a good 2 1/2 3 years. it starts but wont shift...any suggestions?.


Take it out for a drive on a country road and floor it...it may be the transmission or solenoid valves are stuck this should unfreeze them also check for corrosion in the electrical plugs to transmission clean them with vinegar and apply electrical contact grease and reconnect them

Oct 13, 2009 | 1993 Chevrolet Suburban

2 Answers

I have a 93 Chevy Suburban 1500 and the Transmission won't shift into any gear. I have an 1983 Chevy Suburban Transmission that is still good. Can I use the 83 Transmission in my 93 Suburban?


Not without a little adapting. The 1993 has a 4l60e which is electronically controlled and has shift solenoids. If the 83 is an overdrive it is a 700r4 which is the same trans but not electronic. If you put it in the speedo wont work and you will need to install a T.V. cable so the transmission will shift. The 93 won't go forward or backwards?

Jun 15, 2009 | 1995 Chevrolet K1500

3 Answers

Transmission wont shift into 3rd gear.


I had this exact problem on my 2005 5.3L Suburban... It would shift into 1 and 2 and reverse, but not 3 and 4.

I took it into a transmission shop, and he said the 3-4 shift solenoid was burned up. Wanted 1500 to fix it. Far from home, so I have to pay it.

Nov 30, 2008 | 1999 GMC Suburban

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...