Question about 1998 Ford Expedition

1 Answer

Air susp... i have 1999 crown vic that the back just sank one day the light came on the dash but goes off,, and i dont hear the pump running is it a fuse or what? wear is the pump at in this car?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 532 Answers

The pump is left front corner under the hood,or thats where they usually are,but it could be the line at the pump,or at the rear air bags,it also could be a fuse especially if you have overloaded it at one time,not sure where that is so you will have to look in the owners manual.

Posted on May 20, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 ford crown vic won't start. changed fuel


Maybe your problem is with the one or many injectors, if just one is bad, you will have problems. Get yourself a multimeter and set it to read in ohms and find what spec the injectors should be at. If out of spec, then you need to replace that one injector(s).

Mar 25, 2013 | Cars & Trucks

1 Answer

'99 Ford Crown Vic LX: #12 30A Maxi fuse blows seconds after starting or ignition turned on.


i had this problem with my 1999 jeep grand cherokee laredo with the brake lights it kept popping fuses right after the ignition was turned on try putting a higher amp fuse in place of the old one that keeps blowing then check for shorts to the starter and check grounds and wires and also the transmission issue check the fluid and then if the fluid is fine change the transmission filter the filter may have not gotten replaced when the transmission was rebuilt and may be clogged or dirty

Oct 04, 2012 | 2002 Ford Crown Victoria

1 Answer

Im thinking my fuel pump but not sure it only turns over when i prime it once the prime is gone it dies and i dont hear the pump when i climb under tank its a 1999 crown vic w/ intercepter 4.6l also a...


first check the fuse and relay for fuel pump. heres how to check the pump. get under car and put hand on bottom of fuel tank, then have a person turn key to on . if pump is ok. you will feel a vibration in tank. you may have to do this a few times because a fuel pump only runs a few seconds to get fuel pressure to engine then shuts off. but when vehicle is running its on all the time to supply fuel to engine.

Oct 06, 2011 | 1999 Ford Crown Victoria

1 Answer

I dont know which fuse controls my fuel pump on my 1999 ford crown vic


On fuse pannel it should say fuel pump. It should be near battery or inside car. Read owners manual for more detail.

Jun 10, 2011 | 1999 Ford Crown Victoria

1 Answer

1999 FORD CROWN VIC. 4.6 - PROBLEM, NOISE


This is caused by the IAC valve. Over time the valve becomes gummy and inoperative. Get it replaced and the problem is solved. IAC stands for idle air control, hence the stalling concern.

Oct 17, 2009 | 1999 Ford Crown Victoria

2 Answers

1999 ford crown vic dash light running light problem.


Check all the bulbs at tail end for parking and brakes, test grounds and harness for trailer. Check fuses. clean batery terminals, Re instal head light swich properly and make sure all wires conect.
Vitally

Sep 09, 2009 | 2000 Ford Crown Victoria

1 Answer

HOT & COLD ELECTRIC VENTS NOT MOVING.


Blend door actuator. When it fails for some reason it turns to the hot side and gets stuck. Dash must come out. I usually do it in 3 hours, because I've done it numerous times.

May 17, 2009 | 1997 Ford Crown Victoria

1 Answer

1999 crown vic keeps getting air locked at the fuel rail?


check your fuel pressure
if you dont have enough pressure this will happen
when the fuel pressure is good the system will just push the air out through the injectors or the fuel return line

May 15, 2009 | 1998 Ford Crown Victoria

1 Answer

Crown Vic will turn over but not start


first do you hear your fuel pump running? if you don't more then likely the relay may have went bad. second check your connection to your coil's..make sure there clean and tight..and getting back to the fuel problem if you hear your pump running then it could be the fuel filter clog...try this and let me know....

Oct 13, 2008 | 1999 Ford Crown Victoria

2 Answers

Engine light po 300 code


IS THIS A 99 CROWN VIC? IF SO IS IT MISFIRING? IF THIS IS THE CASE YOU MORE THAN LICKLY NEED PLUG WIRES.

Sep 06, 2008 | 1999 Ford Crown Victoria

Not finding what you are looking for?
1998 Ford Expedition Logo

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...