Question about Cars & Trucks

Open Question

Bmw 745i problems

Code 2828

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 231 Answers

SOURCE: BMW 745I 2002 wiper dead

there are several things that can cause the wipers in your car not to work. if you have verified the fuses are good and verified power to your wiper motor, I would try disconnecting the negative battery cable for 15 minutes, then checking operation of the wipers. by the way, which fuses did you check?

Posted on Mar 25, 2009

Ad
tse22
  • 103 Answers

SOURCE: brake warning light is on for 2002 bmw 745i.

The brake pads have sensors in them, when the pads get worn down to the sensor the light comes on letting you know its time to replace. this happens well before the pads are completely gone to reduce wear on the rotors. You should have the brakes replaced and the sensor also.

Posted on May 17, 2009

Atyourdoor
  • 93 Answers

SOURCE: BMW 745i airbag light. Told to replacing airbag clockspring

Hello , check the airbag contact sensor behing the grill assembley . They are located to the left and right of the grill almost to the headlight assemblies. Check the wires to them for corrosion and damage. Check the fuse as well. There should be an air bag testing wire or fuse in the fuse panel. DO NOT UNPLUG THE AIR BAG SENSORS OR HIT THEM !!

Posted on Aug 22, 2009

  • 47 Answers

SOURCE: 2002 BMW 745i code p0370

This is a generic code which says " Timing Reference High Resolution Signal A Malfunction ". This sounds like an electronic problem from where the computer gets a signal form sensors ( in this case probably a camshaft or crankshaft sensor ) to determine top dead center cylinder #1, in order for the computer to determine the correct timing. Since the computer is not sensing correct timing ( be it electronic or maybe your timing belt has skipped a tooth or more?) this would be the reason for your car not starting.

Posted on Jun 19, 2010

  • 87 Answers

SOURCE: HOW TO CHANGE THE OIL AND FILTER ON A BMW 745I BMW

open drain plug and let out oil.
oil filter unscrews and new one goes inside

Posted on Jul 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why do my 2003 bmw 745i vibrate while driving


several reason that should be checked.. Check for balance Check the condition of the tyres . check for sidewall bulges and belt separation. check the discs are not warped. check that the steering joints are not worn. Check cv joints ("u") joints in the drive shafts .Run the fault codes and check for engine misfire on a cylinder.. Check the wheel alignment. Check all pulley bearings and unit bearings on the motor that are belt driven. Check harmonic balancer if fitted.

Jul 29, 2014 | 2004 BMW 745i

1 Answer

Bmw 745i problems


check your fader switch from front to back >>>>>>>>>>>mutebuttonon radio not switched on ...alternatively radio output or amplifier in car if fitted

Jan 13, 2014 | Cars & Trucks

1 Answer

What are signs and symptons of thining brake pads on 2005 bmw 745i


fluid level drop and eventually a high pitch squeal when applying the brakes.

Sep 03, 2012 | 2005 BMW 745i

1 Answer

I have 2002 bmw 745i with code 2744 misfire cylinder #4


to narrow this fault down it would be best to swap the coil,plug and injector,all too different cylinders to see what cylinder the fault goes to and then you will know the problem.

Feb 08, 2011 | 2002 BMW 7 Series

1 Answer

My 745i has gas and batterty power but it will not start.


The 2002 BMW 745I has a recall when the gas goes under a third of gas it will shut off and not start cause it thinks it has no gas. You can call BMW and they will check if your car is on the recall list and you can get it fixed for free. Or they told me to just take it to the BMW dealership and tell them.

Nov 14, 2010 | 2002 BMW 7 Series

2 Answers

2004 745i needs a new engine. Is it worth paying


WHY do you need a new engine for the car,whats wrong with it as no engine is worth throwing away and a BMW it worth doing it up as even a 318i is worth doing up etc as the body is worth selling if 100%and the engine is worth doing so dont be a mug.

Oct 27, 2009 | 2004 BMW 7 Series

1 Answer

BMW 745i airbag light. Told to replacing airbag clockspring


Hello , check the airbag contact sensor behing the grill assembley . They are located to the left and right of the grill almost to the headlight assemblies. Check the wires to them for corrosion and damage. Check the fuse as well. There should be an air bag testing wire or fuse in the fuse panel. DO NOT UNPLUG THE AIR BAG SENSORS OR HIT THEM !!

Aug 22, 2009 | BMW 750 Cars & Trucks

2 Answers

BMW 745I 2002 wiper dead


there are several things that can cause the wipers in your car not to work. if you have verified the fuses are good and verified power to your wiper motor, I would try disconnecting the negative battery cable for 15 minutes, then checking operation of the wipers. by the way, which fuses did you check?

Mar 24, 2009 | 2002 BMW 7 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14445 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...