Question about 2002 Kia Sedona

1 Answer

Wont start. fuel pump klicks once only. no spark from plug wire

Engine turns over but wont start. fuel pump just makes one klick noise, and im getting no spark from plug wire to a bolt

Posted by on

  • jasonearlsmi May 20, 2009

    fuses all good, no distributor...

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,267 Answers

First check the fuses from the battery. The distributor is used to induce the induction coil which in turn sends it to the plug. Hence the contact point of the arm(silver contact point) needs to be replaced.....sodeep

Posted on May 20, 2009

  • Sudeep Chatterjee
    Sudeep Chatterjee May 20, 2009

    The Distributor hold the cables leading to the plugs. Its cap is snap on type with 2 restraining brackets to hold the upper cover in place. It responsible for the firing sequence in each cylinder of the engine so as to get max output power. One cable also enters from the induction coil for the starter......................sodeep

  • relliott1966 Mar 29, 2014

    replaced all fuses then till no spark, used a diagnostics tester and found that the Crankshaft Position Sencor Curcuit is Malfuctioning

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What do I do my car wont start klicking noise after changing start motor what ?


If you have not had a load test done on the battery or cleaned the battery posts and terminals then that would be a good place to start. You can have lights but when the starter is engaged the voltage drops right off and the solenoid just clicks.

Jul 30, 2014 | 2001 BMW 318i

1 Answer

On my 1994 bonniville, when i turn on the igniton some of the time it will start but some times all i get is a klick ..klick klick.. the battary is new


try this simple:
first clean and tight battery nuts
if you still have the problem replace the "starter"(most possible problem) good luck

Jun 30, 2011 | 1994 Pontiac Bonneville

1 Answer

Im working on a 1986 toyota pickup 2.4l efi non turbo 4x4 i replaced the head gasket and i have a black wire coming from the intake wiring harness that has no plug on it .if i touch this wire to a hot wire...


Sounds like this wire should operate the electric fuel pump through the fuel pump relay.The fuel pump relay should start the fuel pump to maintain fuel supply to the common fuel rail and any surplus fuel will be bleed back to tank by pressure control.The injector opening sequence is contolled by computer once the engine is properly timed.
If you say the engine runs for a few seconds it would indicate fuel pump or relay is not getting power to operate or fuel pump is not delivering enough pressure to feed the injectors

Apr 29, 2011 | 1986 Toyota Pickup 4WD

1 Answer

2002 blazer crank but wont start


2 things that you have to check on no starts every time. Spark at spark plug and fuel. Turn key to run position and listen at gas tank for fuel pump to run you should hear a whining noise. This will only happen for 3 to 4 seconds then it will shut off until engine starts. You can turn key off then to run every 3 to 4 to listen for fuel pump. You may hear the relay click off in engine area even if pump does not run. Fuel pump failure is pretty common. If pump is running pull spark plug out or put a spare plug into spark plug wire and have someone crank engine set plug on engine and watch for spark. This will give you a starting point. Hope it helps.

Mar 30, 2010 | 2002 Chevrolet Blazer

2 Answers

Diesel engine wont start when cold


check the wireing to the glo-plugs.... sounds like they are'nt getting juice

Jan 26, 2010 | 1983 Jeep CJ7

1 Answer

Will not start. 1995 astrovan will not start. engine turns over as normal, sounds like it is starving for fuel or spark.


pull a spark plug wire off at spark plug put another plug in wire lay plug and wire against metal of engine and turn motor over looking at plug for spark. as for pump noise turn key on not to start and listen for whine noise for a couple seconds. if hear whine that is your fuel pump noise. not a clear filter canister about under drivers seat on inside of fram

Sep 07, 2009 | 1995 Chevrolet Astro

1 Answer

2004 Kia Sedona wont start but i can hear starter.


if the starter is revving very slowly it is the battery, charge battery. if not, It can be three things happing. 1 no spark 2 no fuel 3 no crank signal or the car computer is bad- you will need to unplug one of the spark wires and remove the spark plug and put the spark plug in the spark plug wire boot, and touch the spark plug on any metal on the car and have some start the car. donot touch the spark plug itself and see if there is a spark. if spark is bright, then it is not spark plug and wires but if no or spark is not bright, check the spark plug wires by applying a little bit of water on the spark plug wire and take a 12v test light, connect the clap to ground and and have some one to crank the vehicle, touch allover the spark plug wires with the tip of the test light, if you see spark, replace the wires and change the plugs.. they are not good. if spark is present, check for fuel by removing any one of the spark plugs and see if it is wet. if wet fuel pump is ok but if not go look for the fuel pump fuse and relay. is fuse blown, replace, check the relay resistor with a volt meter. it should be around 40 to 80 ohm. if everything is good from this point check the fuel pump itself by disconnecting the connector to the pump and apply 12v and ground using jumper wires or some wires to the fuel pump if you donot hear the pump,replace pump. if you, the crank signal or computer may be the problem

Jan 02, 2009 | 2004 Kia Sedona

Not finding what you are looking for?
2002 Kia Sedona Logo

Related Topics:

271 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...