Question about 2002 Dodge Neon

1 Answer

No power to my spark plugs. but power to the inlet wires.

Im turning the key and engine turnes but wont start i check the power to the coil pack from all three wires and all wires have power but no spark to the spark plugs....

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Dodge Master
  • 599 Answers

Check to make sure the camshaft is turning,timing belt may have broken or slipped,check and make sure all the teeth are still on the belt,very common problem get back to me if you need more help, as i strive to be the best.Please rate my fix, problems,get back to me

Posted on May 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cherokee revs up wont start


Your description is too vague to give specific advise. However, if you are stating that the engine turns over when you turn the key but it wont run, then you want to check a few possibilities. Fuel, Spark, compression. Make sure the engine is getting fuel. Then check for spark at one of the plug wires. Then check cylinder compression. No fuel can be a fuel pump, plugged filter, or pump electrical connection, like pump relay or wires. Spark problem can be ignition coil, coil pack, distributor module, distributor points. Compression can be piston rings, valves, head gasket. This is not everything, but it may help you!

Jun 11, 2014 | 1990 Jeep Cherokee Limited

Tip

Car That Turns Over But Won't Start problem?


There are many possibilities for this problem. But are some are very common for this problem.
1) Check out there is enough gas in your car.
2) Check the charge of the battery. It should be exact 12 volts. if the charge is low the engine will crank but won’t start.
3) Get it confirmed that there is fuel in car and fuel pump is also turning on
4) To check whether fuel pump is turning on or not try this procedure.Insert the key in the ignition, then turn the key to the ON position, and listen carefully from the back seat side you will here an electric noise for about 1 second every time you cycle the key on/off. If you hear nothing then your fuel pump is faulty or not receiving any power. In this case the fuel pump needs replacement.
5)But if fuels pump check out ok.then continues towards engine for finding fault. Check where engine is receiving the gas. Many times clogged fuel filter or blocked fuel injectors don’t let gas to flow towards the engine.
6) If the gas flow is proper towards the engine. Then route towards the spark plugs.
7)Check whether you get spark while you crack the engine. if no spark then it’s the problem in the spark plugs.
8) The spark plugs receive power from coil pack. If the coil pack is having proper voltage the fault in spark plugs is confirmed. But if the coils pack has low voltage then its time to replace the coil pack.

This will help. Thanks.






on Mar 16, 2010 | Chrysler Town & Country Cars & Trucks

1 Answer

My car will not start it cranks but will not turn on. So far I have changed the crank sensor I also have no spark to coil packs or spark plugs Fuel pump does not turn on when I turn the key. What is the...


Begin by checking fuses. Ignition, efi, fuel pump fuses. When key turned to on, do the warning lights and gauges work? That verifies switch has power and is sending power out. With key on, the coil primary wire to coil packs should have voltage.

No spark and no gas? Fuel pump fuse good? I think I would use a test light or multimeter to check that fuel pump fuse terminal has power to it with key on. If that's good, pull connector off at fuel tank and check for a voltage signal on fuel pump wire when the engine is cranking-if good signal, fuel pump needs taken out for replacement or inspection. If no signal check that fuel pump relay has power to it. With key off, pull the relay and check that one terminal has power to it-the feed wire for the pump. If no power signal at all, check maxi fuses or fusible links for a failure.

Sep 04, 2013 | Cars & Trucks

2 Answers

Cranks but wont turn over


Cranking is Turning Over,same thing

Sep 02, 2013 | 2000 Mitsubishi Galant 4dr Sdn ES

1 Answer

92 lumina wont start


anti theft deturent light flashing??with key on engine off??

Dec 23, 2012 | 1992 Chevrolet Lumina

3 Answers

2007 nissan titan turns over but wont start no spark to the plugs .


The problem could be in the spark plugs. Usually if just one of the spark plugs is not producing the spark needed, the engine would still start. It may run rough, but will still start. If none of the spark plugs are producing a spark (or firing) then this could be the culprit.The spark plugs gets power to spark from coil packs.So check the coil pack first.If the coil pack checked ok then its faulty spark plugs causing this problem.Also remove the spark plug connection and clean it and reconnect it and recheck.In some cases this helps. ---------------That's it.

Nov 18, 2010 | 2007 Nissan Titan LE

2 Answers

My 96 Saturn sc2 wont turn over or start.


Was there oil/coolant in cylinders when they were pulled?

Jun 22, 2009 | 1992 Saturn SL2

1 Answer

Car wont start


No spark, ck the crank position sensor. bolted on engine at the front crank pully. Good luck. unplug and plug it back in to clean the wire connection/

Jun 03, 2009 | 1990 Dodge Dynasty

1 Answer

Not getting spark


Testing the coil packs.

1. Get an INSULATED wire and hook it to a ground on the car.
2. Get some one to help you
3. pull a spark plug wire off the coil
4. hold grounded wire close to, but not touching, the part where the spark plug wire connects
5. keep hands away from coil and have your helper turn the engine over ( start car and turn off)
6. if there was a spark between the wire and the coil pack it is good. if not, the coil pack needs replaced
7. replace the spark plug wire
8. test the rest

Apr 22, 2009 | 2003 Mitsubishi Galant

Not finding what you are looking for?
2002 Dodge Neon Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...