Question about 1992 Dodge Ramcharger
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The first thing you need is to have the unit scanned. Check things like the baro sensor,map sensor,coolant temp. and the TP sensor.Also check your fuel pressure,volume and injector spray pattern. I think you will have found your problem,but if not hit me back with engine size and any codes,Good Luck.
Posted on Aug 25, 2008
SOURCE: starting and running problem
Breaking up like you described can be related to a condition where the distributor drive gear is wearing out.
Had you checked it for rotor tip travel (about 5mm of loose travel is the max) or had the distributor indexed? The indexing procedure appears to be similar to an ignition timing adjustment but isn't the same.
Chrysler TSB 18-08-93 Rev A describes a condition often seen on the 1992-1993 3.9 engine. The distributor drive gear wears out prematurely and then wallows out the support bushing in the engine block. Your oil pump is driven by the same gear through the distributor shaft, so cold engine operation often is worse from the higher viscosity of the oil and the resulting load it places on the worn parts.
The distributor index slips to the retarded zone (trails what it should be) just from the gear wear. Adding in the worn bushing and chain stretch can put the distributor in a position where ignition cross-firing can occur and the switch plate (cam sensor) within the distributor can drop out-of-sync with the crank sensor.
If you haven't done so, check this out for me. Remove the distributor cap and twist the rotor clockwise and counter-clockwise. The total tip travel should not exceed 5mm, which is just about 1/8". Even if it exceeds this, an adjustment/ indexing of the distributor will get it running right again if only for a short while.
Posted on Mar 11, 2009
Here is a firing order diagram and note the distributor cap latch positions between terminals 1 and 2 and 5 and 4, and let me know if you need any help to understand this diagram or if you require any further assistance.
Posted on Oct 21, 2010
Tips for a great answer:
Nov 07, 2014 | 1987 Dodge Ramcharger
Nov 04, 2013 | Dodge Dakota Cars & Trucks
Feb 03, 2010 | 1983 Dodge Ramcharger
Dec 04, 2009 | 1998 Dodge Ram 1500 4WD
Feb 05, 2009 | 1988 Dodge D-Series Pickups
Aug 13, 2008 | 1992 Dodge Dakota
Oct 13, 2017 | 1992 Dodge Ramcharger
Jan 08, 2014 | 1992 Dodge Ramcharger
24 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: