Question about Cars & Trucks

Open Question

Knock sensor malibu 3.5 L location - Cars & Trucks

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
mechanicm639
  • 253 Answers

SOURCE: bad knock sensor on 1998 chevy malibu 2.4L

The knock sensor is on the back side of the engine near the trans. It is round, with a 1 wire connector. You will have to get it from underneath. Good Luck.

Posted on May 06, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 Chevy avalanche knock sensors location


Nathan, 2 Knock's are located under intake manifold.
Check the attached links,
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

How To Install Replace Engine Knock Sensor 2000 06 5 3L Silverado Sierra...

Knock sensor 5 3 4 8 6 0 replacement

05 Chevy Avalanche Knock Sensors

4 8 5 3 6 0 knock sensor replacement GM



Mar 06, 2016 | Cars & Trucks

1 Answer

How to change knock sensor on 2004 Malibu v6


Why do you need to change the knock sensor? Just because there is a code for it doesn't mean it's bad. Does the vehicle run bad? Tune up or fuel filter can cause the code to set for the knock sensor. It listens for knocking so the pcm can shut the car down. Those very rarely go bad unless it has been soaking in coolant leak.

Sep 09, 2015 | 2004 Chevrolet Malibu

1 Answer

Where is the knock sensor located on a 1997 2.4 Chevy Malibu?


It is at the back of the block, on the drivers side. It's a royal PITA to get at. Make sure you have a drain pan below it as you WILL lose coolant. After replacing, be sure to burp the cooling system.

Feb 13, 2015 | 1997 Chevrolet Malibu

1 Answer

Where is the knock sensor for a 4 cylinder Malibu 2009


Knock Sensor (KS) (LAT or LE5)
At the lower left side of the engine, in front of the starter motor . It has a dark blue an gray wires .

Feb 12, 2015 | 2009 Chevrolet Malibu

1 Answer

I have a 2000 malibu will the knock sensor keep it from runnig


No.
The knock sensor picks up vibration in the engine and signals the engine computer to slow down the timing. It may run sluggish, but should still run.

Oct 16, 2014 | 2000 Chevrolet Malibu

1 Answer

Wereisp0327 nock sensor located on 2007 malbiu 4 cylinder engine


Off of the main engine harness in front of the engine, you'll find a lead that goes to the coolant temp sensor, and just after that a little lower towards the driver's side you'll find the Knock sensor lead.ac21663_1.jpg

Mar 17, 2013 | Cars & Trucks

3 Answers

I have a 1999 chevy malibu with knocking noise ina 3.1l v6 motor.


Sounds like you didn't put the pushrods back in the proper locations. There are two different lengths in this engine and you may have one backwards

Apr 09, 2010 | 1999 Chevrolet Malibu

1 Answer

Knock sensor replacement ....2003 kia rio....emissions ...obd II....failure...need to pass inspection...failure code P0325 (Knock sensor 1 circuit malfunction)....where vis the knock sensor located on a...


Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.

Mar 19, 2010 | 2003 Kia Rio

1 Answer

The car does not power on desk after a crash,


see for electriacl problem such as  1.see weather the bulb are ok or fused in deck pannel 2. see for fuses that are related to perticular system 3.like you told about the knock sensor most of them are located behind the bumper assembly, near bumper mounting chassis,bracket, the best thing for a hazard free trouble free thing you can visit the nearest authorised service station or workshop they will surely help you sir till then have happy motoring, & drive safely see you soon Sir...!

May 24, 2009 | 2003 Chevrolet Malibu

2 Answers

Bad knock sensor on 1998 chevy malibu 2.4L


The knock sensor is on the back side of the engine near the trans. It is round, with a 1 wire connector. You will have to get it from underneath. Good Luck.

May 06, 2009 | 2008 Infiniti FX35

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...