Question about 1993 Toyota Pickup

1 Answer

Truck started sputtering and wouldn't start right away. Took a lot of rotations to start, then I was going down the road and it just quit. I changed the mass air flow sensor but that didn't fix it, found that it wasn't firing, so I put a new ignition coil on it, it's firing now but it still want start

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Toyota Expert
  • 180 Answers

Timing chain?

Posted on Dec 31, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 86 4runner will not start,put

Your problem very well maybe that the new inline fuel pump that you put in does not supply sufficent fuel pressure to let it run... so to solve it i know it is expensive but you will probally have to put a tank fuel pump in.

Posted on Oct 03, 2008

rob82abn
  • 28 Answers

SOURCE: coil wire shorting out, replaced wire, still no spark

I HAVE A QUESTION THAT MIGHT HELP, THE 22-RE 4 CYLINDER HAS A STEEL TIMING CHAIN, IVE BEEN TOLD THAT THE V-6 HAS A RUBBER TIMING BELT ON THE SIDE OF THE MOTOR UNDER A COVER?

Posted on Feb 21, 2009

  • 84 Answers

SOURCE: 1999 Toyota Camry V-6.

when starting push gas, if runs
idle valve (IAC) stuck,replace or disassemble and clean the burrs
has two time this promblem

Posted on Mar 01, 2009

  • 1 Answer

SOURCE: 93 TOYOTA HILUX ( 22RE ) STARTS THEN STALLS AFTER 1-2 MINUTES

Try cleaning the throttle body.Check the air-gap for the pick-up coil inside the distributor assembly(use a brass feeler gauge)
Check valve clearances if needed(possible tight intake valve adj.)
Check base timing(follow instr. via under hood label)
Hope this helps.

Posted on Mar 17, 2009

  • 146 Answers

SOURCE: Rav 4 2004 stalls, sputters won't run changed

Change your plug wires. If you want to, switch wires with another cylinder. If the misfire moves to the new cylinder, you found your bad wire.

Posted on Feb 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 gmc yukon xl


Sorry to get your hopes up but I have a similar problem with my 2005 Yukon Denali. How long does the truck stay running before it shuts down? Mine started out with short spurts of the truck shutting down while driving. It slowly progressed to the point where it will only run for about 45 seconds. Originally the truck would sputter the gauges would die and then the truck would die. It slowly progressed to the point where it only runs for 45 seconds and there is no signs before hand. Does any of this happen to your vehicle? I have checked all of my cables and the main ground wires. Along with changing a few of the relays. Nothing has helped. My problem started with an electrical component heating up and quitting. Now it doesn't matter how hot it is in only runs for a couple seconds.

Jul 07, 2014 | 2003 GMC Yukon XL

1 Answer

99 dodge ram 1500 sputters and quits


i would check three parts , i have seen a weak ignition coil make this happen, change fuel filter and last possibly either fuel pump or fuel pump regulator

Jan 12, 2013 | Cars & Trucks

1 Answer

MY CHEVY TRUCK IS SPUTTERING LIKE ITS GOING TO QUIT AND THE LIGHTS ARE DIMMING GOING DOWN THE ROAD


Do not understand the fuel problem, but the lights is probably a bad alternator. Major auto parts stores will test it for free

Sep 13, 2012 | Cars & Trucks

1 Answer

2003 yukon xl loses all power while driving(SHUTS OFF)


Sounds like your fuel filter need's to be changed. Start with that and good luck.

Apr 06, 2009 | 2003 GMC Yukon XL

2 Answers

2001 gmc sonoma fuel pumpeplaced,ot starting now


check to see if you removed the fuel pump solenoid, which is one of the steps you should have done when changing the pump.

Jan 15, 2009 | 2001 GMC Sonoma Extended Cab

1 Answer

My truck is cutting out. please help


your problem is your fuel pump ,,replace filter and test pressure gm trucks are know for it it will do this intermitantly then finally just quit on you

Dec 30, 2008 | 1993 Chevrolet C1500

1 Answer

1995 Ford Ranger Splash 4x4 4.0L V6


John, I will save you some money, I just took my 94 ranger with the same problem to the dealer and they fixed it. They replaced the ignition sensor and the fuel pump sensor and a O2 sensor. The ignition and fuel pump sensor is in a fuse box right behind the battery. They are a 1 in. black pull out cubes. Ask a parts store which ones they are. Numbers are stamped on the cube. John in Oregon

Oct 31, 2008 | 1995 Ford Ranger Supercab

Not finding what you are looking for?
1993 Toyota Pickup Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...