Question about 2006 Mazda Tribute

2 Answers

Manual transmission not shifting

Manual transmission will not shift while engine is running. will shift when engine shut off and will drive once engine is started again.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mazda Master
  • 3,103 Answers

Is the shift clutch rod out of alignment or broken..

Posted on Dec 31, 2013

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 338 Answers

Clutch is dragging, not disengaging completely. Clutch is pressure plate knackered or the clutch linkage is way out of adjustment. If it's a hydraulic clutch it might need bleeding?

Posted on Dec 31, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

  • 13 Answers

SOURCE: 1993 mazda mx6 transmission is not slipping, but will not shift into higher gears. Will run at high RPM's and not shift up. Any suggestions on what it might be.. Mechanical, electrical, fluid change,

sounds like a shift solenoid in the trans.

Posted on May 10, 2009

keithheavili
  • 410 Answers

SOURCE: Engine stalls when shifting into any drive gear.

It sounds like your idle air control valve could be going out on you.  The extra stress from being in gear can cause the car to stall out if the IAC valve isn't opperating properly.  The IAC is attached to the throttle body and is normally held on by two screws.  IAC valves are relatively cheap from AutoZone and easy to replace.  That would be my best guess based on your description.  Good luck and let me know if you have any other questions.  Thanks for an honest rating and for using FixYa!

Posted on May 24, 2009

  • 129 Answers

SOURCE: check engine light came on and now shifts hard from park to drive

The engine light is telling you, you have a transmission problem which sound like a shift solenoid. If you take the care to a local garage or dealer you can have them scan the vehicle for the problem code, which will tell you which solenoid is bad.

Posted on May 26, 2009

  • 204 Answers

SOURCE: 1993 Mazda 626 auto trans shift hesitation when warm

Have your checked your trans fluid?

Posted on Feb 03, 2010

  • 1403 Answers

SOURCE: My check engine light came

suggest that you check your transmission fluid post haste please. you may only need to add transmission fluid to your car. also,if you have to add the fluid,where did your fluid leak? check for leaks under your car when parked. you may need transmission fluid and filter change,suggest that you do this with new filter and add lucas transmission treatment to the fluid change also. you'll need to purchase this yourself,unless you have a mechanic in the family that can do it for you.if not i suggest you find a mechanic you trust,then tell him,or,her to add this to your tranny fluid change. also suggest while the mechanics there at the transmission to check the modulator valve on the transmission,and the vacum line that operates it. just a hint. thanks for choosing fixya.com

Posted on Mar 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does the daewoo shuts down when transmission is shifted to drive


you may have a faulty torque converter and it is loading down the engine to much to keep enough rpms to stay running or it could be and issue with the engine. more info is required. RPMs in park, does it do it if you use the throttle while shifting to drive, does it do it in reverse as well?

Jul 14, 2014 | 2001 Daewoo Lanos

1 Answer

Why does the daewoo shuts down when transmission is shifted to drive or reverse?


You may have a faulty torque converter and it is loading down the engine to much to keep enough rpms to stay running or it could be and issue with the engine. more info is required. RPMs in park, does it do it if you use the throttle while shifting to drive?

Jul 14, 2014 | 2001 Daewoo Lanos

1 Answer

2001 dakota auto transmission will not shift automatically


You lost your 2-4 and that is normally the Band or Drum

Apr 12, 2013 | 2001 Dodge Dakota

2 Answers

Can shift gears not started, but once engine is on can't shift


auto or manual would help, i would say clutch in a manual or damage to auto gear box or torque convertor if automatic. manual is a cheap fix auto may be thousands.

Jan 17, 2013 | 1994 Honda Accord

1 Answer

My engine starts, idles great but when in gear to go, it hesitates


Can be issue with transmission or its related components.Many car models face such problems.

For complete step by step troubleshooting,few help links are provided below.Click the link below and go through its procedure to resolve the problem:----
Engine misses and truck jumps? Hard to down shift? Issue with high gear only? http://technoanswers.blogspot.in/2012/02/engine-miss-and-truck-jumps-hard-to.html

---------
Car sitting for year, now will not crank and go in gear? http://repairhelpcenter.blogspot.com/2012/01/car-sitting-for-yearnow-will-not-crank.html

--------

2004 Peugoet: Clutch not going in gears?
http://whoisbyme.blogspot.in/2012/05/peugeot-307-clutch-will-no-go-in-gears.html

---------
Engine stumbles and shuts off in forward gear on Toyota Land Cruiser? http://schematicsdiagram.blogspot.com/2012/01/engine-stumbles-and-shuts-off-in.html

--------
Transmission problem? http://schematicsdiagram.blogspot.com/2012/01/transmission-problem.html

---------
Car engine Overheats and transmission starts slipping?

http://schematicsdiagram.blogspot.com/2011/12/car-engine-overheats-and-transmission.html

-------------
Manual Transmission Clutch System Failures?

http://repairhelpcenter.blogspot.com/2011/11/manual-transmission-clutch-system.html

-----------
Automatic transmission will not go into high gear? http://howtobyme.blogspot.com/2011/11/automatic-transmission-will-not-go-into.html

--------
Manual transmission very hard to shift from one gear to another? http://repairhelpcenter.blogspot.com/2012/01/manual-transmission-very-hard-to-shift.html

--------
Dodge manual transmission will not go in reverse gear? http://technoanswers.blogspot.in/2012/02/dodge-manual-transmission-will-not-go.html

---------
2006 Chrysler 300c: Shifter Stuck in Park? http://technoanswers.blogspot.in/2012/06/2006-chrysler-300c-shifter-stuck-in.html
---------- 1998 Ford Expedition: Will not Shift Out of Park? http://schematicsdiagram.blogspot.in/2012/06/1998-ford-expedition-will-not-shift-out.html
---------- Car will not move when in gear?

http://repairhelpcenter.blogspot.in/2012/02/car-will-not-move-when-in-gear.html

----------- Mercedes-Benz transmission sticks in first gear? http://technoanswers.blogspot.com/2012/01/mercedes-benz-transmission-sticks-in.html
---------- Mercedes Benz not engaging in first gear? http://technoanswers.blogspot.com/2012/01/mercedes-benz-not-engaging-in-first.html
--------- Chrysler PT Cruiser only goes in First gear?

http://howtobyme.blogspot.com/2011/11/chrysler-pt-cruiser-only-goes-in-first.html

-----------

Car is stuck in park and the shift will not move?
http://howtobyme.blogspot.com/2011/08/car-is-stuck-in-park-and-shift-will-not.html

------------


These details will help.Keep updated for more help.
Thanks.

Oct 16, 2012 | 1997 Honda Passport

1 Answer

Transmission will get stuck in a gear and wont up shift to the next gear or it will constantly up shift and down shift


suggest you check for a vacum line off that goes to the transmission modulator valve, which controls the shifting in transmission.or may possibly just be a bad modulator valve on the side of the transmission. 1st check for a vacum line off, with engine running do you hear a whistling or air sucking sound on top or rear of motor? if so, follow that sound to a hose or small black hose thats off.if you are driving the car and start off in low drive and can manually shift to upper gears with no problems,your problem is either a vacum line off, or it's a bad modulator valve on the transmission. hope this helps!!!

Nov 10, 2010 | 1992 Chrysler Lebaron

2 Answers

Can a 1998 4x4 S-10 blazer be dinghy towed?


Yes it can, just place your Transfer Case in Neutral position.
Shifting into NEUTRAL
To shift the transfer case to NEUTRAL do the following:

Make sure the vehicle is parked so that it will not roll.
Set the parking brake.
Start the vehicle or turn the ignition to RUN.
Connect the vehicle to the towing vehicle.
Put the transmission in NEUTRAL (N).
Shift the transfer case to 2HI.
Simultaneously press and hold the 2HI and 4LO buttons for 10 seconds. The red NEUTRAL light will come on when the transfer case shift to NEUTRAL is complete.
Shift the transmission to REVERSE (R) for one second, then shift the transmission to DRIVE (D) for one second, or FIRST (1) for vehicles equipped with a manual transmission.
Turn the ignition to LOCK.
Place the transmission shift lever in PARK (P), or FIRST (1) for vehicles with a manual transmission.
Release the parking brake prior to towing.

Shifting Out of NEUTRAL
To shift out of NEUTRAL:

Set the parking brake and apply the regular brake pedal.
Shift the transmission to NEUTRAL (N) and turn the ignition to RUN with the engine off.
Press the button for the desired transfer case shift position (2HI, 4HI, AUTO 4WD or 4LO).
After the transfer case has shifted out of NEUTRAL the red light will go out.
Release the parking brake.
You may start the engine and shift the transmission to the desired position.
Excessively shifting the transfer case into or out of the different modes may cause the transfer case to enter the shift protection mode. This will protect the transfer case from possible damage and will only allow the transfer case to respond to one shift per 10 seconds. The transfer case may stay in this mode for up to three minutes.

NEUTRAL: Shift the vehicle's transfer case to NEUTRAL only when towing your vehicle.
Good luck and hope this answers your question.

Jan 30, 2010 | 1998 Chevrolet Blazer

5 Answers

1997 Chevy 4L60e Transmission Shift Problem


How many miles? Have you maintained, serviced trans in past or just waited for this day to wonder what happened?

Jan 04, 2010 | 1997 Chevrolet Suburban

1 Answer

4x4 would not shift from low to high without shutting engine off.


Four wheel drive vehicles require you to put the transmission in neutral to go into low and to get out of low. That being said, if you still need to shut the engine down completely then your transmission needs an adjustment.

Feb 20, 2009 | 2004 Nissan Titan

Not finding what you are looking for?
2006 Mazda Tribute Logo

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8557 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...