Question about 2002 Chevrolet Venture Passanger

1 Answer

2002 Chevy venture accelerates without stepping on the gas pedal even while in park..

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 46,580 Answers

Run fault codes and look for problem sensors (MAP/MAV)

Posted on Dec 31, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
MacGyver911
  • 42 Answers

SOURCE: Chevy Malibu idle problem

Throttle position sensor. It's under recall for most Malibu models.

Posted on Mar 19, 2009

  • 66 Answers

SOURCE: Help changing thermostat 2002 chevy venture

THERMOSTAT REPLACEMENT

Removal Procedure
1.Remove the air cleaner and duct assembly.
2.Drain the coolant until the coolant level is below the thermostat. Refer to Draining and Filling Cooling System .
3.Remove the crossover exhaust pipe.
4.Remove the radiator hose from the thermostat housing
5.Remove the thermostat housing bolts and clean any sealer from the bolt threads.
6.Remove the thermostat housing and gasket.
7.Remove the thermostat.
8.Clean the mating surfaces.

Installation Procedure
1.Install the thermostat.
2.Install the thermostat housing and gasket.
3.Install RTV sealer, GM P/N 1052366 or the equivalent, to the thermostat housing bolt threads. .
4.Install he thermostat housing bolts.
Tighten
Tighten the bolts to 25 N.m (18 lb ft).
5.Install the radiator hose to the thermostat housing.
6.Install the crossover exhaust pipe
7.Install the air cleaner and duct assembly.
8.Fill the cooling system. Refer to Draining and Filling Cooling System .
9.Inspect the cooling system for leaks. Repair as necessary.


http://www.2carpros.com/forum/automotive_pictures/99387_Graphic2_59.jpg

http://www.2carpros.com/forum/automotive_pictures/99387_Graphic3_26.jpg

http://www.2carpros.com/forum/automotive_pictures/99387_Graphic4_13.jpg

Posted on Mar 30, 2009

  • 1 Answer

SOURCE: parking lights stay on after

i just put a remote start alarm system on my 2002 chevy impala now when i turn the car off the parking lights come on after i turn the ignition off and stay on for like 10-15 min before the goes off but before they goes off they blink 3 times and then shut off .

Posted on Nov 05, 2009

  • 82 Answers

SOURCE: my 2003 chevy impala idle high in park n when i

things to check: check for engine vacume leak
carbon build up at throttle body. idle air contoller maybe stuck due to carbon build up or defective

Posted on Mar 21, 2010

  • 1149 Answers

SOURCE: The gas gauge on my 2002 chevy venture is not

Hi:
Your tank sending unit is bad. Unfortunately, it is part of the fuel pump assembly, and the part costs around $400, give or take. plus installation labor. It is an all too common problem on GM vehicles, as I have had to change it on my last 2 GMs. If you do an internet search you will find plenty of others in the same boat!

Posted on Apr 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is it that my kia 2002 sportage automatic is experiencing dead acceleration/throttle even if i push pedal


throttle position sensor/ Idle air control sensor no good one or both could be bad if you are parked can you press on the gas and the engine raises the rpm's or does it stay the same could also be accelerator cable broke if no raise in engine rpm's revs up

Aug 23, 2014 | Cars & Trucks

1 Answer

In my 2002 chevy cavalier when applying the gas pedal slightly in neutral or park i hear a click and the rpms go down slightly


first off run the fault codes to indicate any electronic problem. Next check under the accelerator pedal for a loose /broken clip that is allowing the pedal to disconnect from the sensor or cable .

Aug 03, 2014 | 2002 Chevrolet Cavalier Coupe

1 Answer

Hi my chevy venture has always engine check light whenever i start and somthing not right. Any idea to solve this problem? what are the symptons of this problem?


to reset engine warning light simply turn key on without starting slowly depress gas pedal to floor 3 times in about 5seconds wait 15sec then shut off key...this is in the owners manual under engine check warning light.but also may want to have someone plug a obd2 code reader into the plug under center of dash under steerind wheel....code readers cost around $100 at canadian tire or other such part stores..this reader will tell you what trouble codes if any are present in your vehicles computer.hope this helps..

Jan 22, 2011 | 2002 Chevrolet Venture Passanger

1 Answer

How do you replace an ignition switch on a 2002 chevy venture van? I have a 2002 chevy venture van and have had a problem with the starter staying engaged. I replaced the started and it fixed it...


So what it only does it in park or neutral ! The vehicle starting circuit is only suppose to let it start in park or neutal . Park neutral safety switch won't allow B+ voltage to S terminal on the starter solenoid unless the vehicle is in park or neutral . It's probably the starter relay contacts stuck closed . You really should learn how it works before guessing as to the problem . Plus learn automotive electrical testing ! The ignition switch when turned to the start position send's a voltage signal to the PCM - engine computer .The PCM will energize the starter relay to crank the engine . PCM / ABS 10amp fuse in the I/P fuse box supply's B+ voltage to the park / neutral safety switch . When in park or neutral the B+ voltage goes through the control side of the relay to the PCM which will supply a ground to energize the starter relay .

Jun 17, 2017 | 2002 Chevrolet Venture Passanger

2 Answers

Reset oil change light 2000 chevy venture


Try turning the key to the on position without starting the vehicle and press your gas pedal all the way to the floor 3 times within 10 seconds of turning the key to the on postion. If this doesn't work let me know and I'll have another solution.

Apr 20, 2010 | 2000 Chevrolet Venture

2 Answers

Fault code p0440 CHevy venture


I had that exact code a couple weeks ago. Mine needed new oxygen sensors. They(there are 2, only one was throwing a code, but I had both replaced) cost a little over $100 to have replaced.

Sep 19, 2009 | 2002 Chevrolet Venture Passanger

1 Answer

2002 Chevy Trailblazer


hi, those sound like throttle actuator codes. the throttle body on your vehicle should be an electronically controlled unit without wires to control actual acceration an deceleration. now, there is also an electronic switch called a potentiometer on the gas pedal that transmits signal to the throttle body to tell it what to do. most of the time, the throttle body is what goes bad here. you should also check the wiring to the unit for bad connection by wiggling the wire connector and seeing if the reduced engine power light comes on. if this happens, you will likely have to replace the wiring pigtail and the throttle body. but, in some cases, the gas pedal switch goes bad, and likely what is not allowing the transmission to shift out of park, the pcm may lock out the solenoid controlling the shifter. but, don't just run with that answer, it maybe completely wrong. i have seen more throttle bodies and wiring harnesses go bad than gas pedal switches in those vehicles. but you might want to have a shop diagnose further, it may even be two unrelated problems, or in the powertrain computer itself.

Mar 26, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

My 2002 Chevy Venture rolls while in park. I accidentally hit the gear shift into park while moving.


when the trans went into park it most likley broke the small rod that engages park and unless you are a capable mechanic with a repair manual you should leave fixing that to a pro hope this helps you

Jan 18, 2009 | 2002 Chevrolet Venture Passanger

1 Answer

2000 chevy venture van- It starts, but will not idle.


Hi , this can be caused by a bad, tps (trottle position sensor)also can check fuel presure and fuel filter,good luck.......

Aug 31, 2008 | 2000 Chevrolet Venture

Not finding what you are looking for?
2002 Chevrolet Venture Passanger Logo

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...