Question about 2002 Chrysler Town & Country

1 Answer

Cruise control not working

Cruise will light up but when you press set it does not not set

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 45,659 Answers

Check for adjustments on clutch and or brake pedals sensors

Posted on Dec 31, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: horn,airbag light,cruise control

ON CERTAIN MINIVANS, THE DRIVER'S AIR BAG MAY BECOME DISABLED DUE TO A FAILURE OF THE CLOCKSPRING, WHICH IS LOCATED IN THE HUB OF THE STEERING WHEEL. Consequence Summary: THIS CONDITION WILL MANIFEST ITSELF THROUGH ILLUMINATION OF THE AIR BAG WARNING LAMP, AND COULD EVENTUALLY RESULT IN A DRIVER'S AIR BAG OPEN CIRCUIT, IF THE PART IS NOT REPLACED IN A REASONABLE AMOUNT OF TIME. Corrective Summary: DEALERS WILL REPLACE THE CLOCKSPRING ASSEMBLY ON ALL COVERED VEHICLES WITH 70,000 MILES OR LESS. FOR THOSE VEHICLES WITH MORE THAN 70,000 MILES, DAIMLERCHRYSLER WILL OFFER AN EXTENDED LIFETIME WARRANTY UNDER WHICH IT WILL REPLACE THE CLOCKSPRING AT NO CHARGE IF IT FAILS. DAIMLERCHRYSLER WILL ALSO REIMBURSE OWNERS WHO HAVE PAID TO HAVE THE CLOCKSPRING REPLACED ON THEIR VEHICLES. THE RECALL BEGAN ON OCTOBER 12, 2004. OWNERS SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403. A malfunctioning clockspring can also effect your cruise control,radio, wipers, and your horn relay. This can also happen one at a time til none of these are working.The solotion is to get the clockspring replaced . I DO NOT suggest you doing this on your own!

Posted on Jul 19, 2008

  • 1 Answer

SOURCE: multable problems

It happened to our 99 too, turned out to be inside the steering wheel. a coil that Chrysler recalled. It was a free repair at a dealership

Posted on Oct 14, 2008

csmock132
  • 4669 Answers

SOURCE: horn,airbag light,cruise control

Sounds like a bad clockspring

Posted on Feb 27, 2009

  • 5 Answers

SOURCE: engine light on ,2500 rpm surge, and no cruise control

That is normal operation. Take the car for a ride and try it then. Zoom Zoom

Posted on Sep 02, 2009

johnjohn2
  • 5763 Answers

SOURCE: 2007 Chrysler Sebring cruise control

Some of these dont use a light you just hit the on button and set cruise remember if brake is hit it shuts down and you must be going over 40mph, if this doesnt work then check your fuses,good luck.

Posted on Nov 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My cruise control on my 2001 Kia Sportage stopped working.


Check your repair manual where the vacuum hoses for the cruise controls are (engine bay). Maybe one of the hoses came off or has a leak.

Feb 29, 2016 | 2001 Kia Sportage

4 Answers

2005 Chevy trailblazer ext problems 1. Cruise will not set.worked last on 4/12/15 2. While checking fuses for CC problemdome lights stopped working, but worked fine before checking fuses. PLEASE HELP!


Bummer deal! This may be a way to tell you some tail lights are burnt out. Some cruise controls have a fuse in a second location.
The fuse is not in right or is blown. Check with a new fuse. Hope this helps. ...gc http://www.auto-tune-up-and-repair-options.com/

Apr 20, 2015 | 2005 Chevrolet Trailblazer Ext

1 Answer

What causes my cruise controll to not work intermittenly


cruise control starts working above 50kmh, so if your under that it wont work. the cruise servo may be at fault, or I have seen battery acid leak down on the vacuum lines causing cruise not to work correctly. cruise control works off of a vacuum so without it, it wont work. if the cruise light doesn't turn on when pressing the set/cruise button intermitantly it may be the switch itself that is starting to fail

Apr 24, 2014 | 2004 Chevrolet TrailBlazer

1 Answer

2003 oldsmobile alero v6 -- cruise control stopped working...The cruise on/of button lights up, the green light cruise indicator comes on in the dash panel, but cruise control does not engage when CST SET...


Try checking the small switch at the top of the brake pedal. There may be two one for brake lights and one for the cruise control. To ascertain what is what, pull one wire off and see if brake lights work. If not, then the other switch controls the cruise control disconnect and engage..I you have a DC test light check to see if power is on on both side of the switch with brake pedal up. If so, depress pedal and check power on the other side there should be none, if there is the switch is defective.

Aug 02, 2017 | Cars & Trucks

1 Answer

Ford focus cruise control


Once you have turned your cruise control on accelerate to desired speed press SET button on right hand side of steering wheel before lifting foot from accelerator, then remove foot from accelerator. pushing RESUME button will deactivate cruise control without turning it off. Then when clear of traffic push resume again to activate cruise control. It will automatically resume to previous set speed.

Apr 30, 2013 | 2006 Ford Focus

1 Answer

Cruise control not working


Have you tried pressing the cruise control "on" button once then when you reach your cruise control speed press the "Set/Acc" button. The green cruise light should turn on then.

Jan 08, 2013 | 2002 Mazda Tribute

1 Answer

This problem is on a 1998 740iL. When I press the steering wheel cruise control activator - the green indicator light comes on but when I press the "set" (+) button it does not engage and the car does not...


my BMW 740i has a problem with the cruise control.
The cruise control will work for about 20 miles and then quit working and will not work again.

May 17, 2010 | Cars & Trucks

1 Answer

I have a 2008 Honda CRV and for the life of me I cannot engage the Cruise control- I press the Cruise Button on the right of the steer wheel and nothing happens - nothing Help anyone ? Tks Nancy


The cruise-controls have 2-buttons that must be activated before it gets the car going when you remove your foot off the gas-pedal.
The cruise button is essentailly a switch that turns 'on' the cruise servo-motor that tells the sytems that you wants to use it, so it gets ready.
There are other three switches on the right-side of the steering wheel namely: resume accel; cancel; set decel.
To get your car to cruise: you must steady your speed and foot on the gas-pedal. You cannot just press the switches and expect the car to cruise. It takes about two-to-three seconds for the system to respond to a set cruising speed.
How to do it: accelerate to a speed of about 30-mph. Press the 'cruise' button on the dash first. Next you press 'set decel' button. This will turn 'on' the cruise control light on the instrument panel. Then wait a second or three and you would feel the cruise engagement. Any touch on the brake pedal will slow down the car and turns the cruise off. The 'cancel' button turns off the cruise light on the instrument panel.
If you hit the brake-pedal at any time for any reason, and you would like to continue cruising again, simply press the 'resume accel' button.
The cruise system works in conjunction with the braking system of the car. So all major parts of the braking system must be in good condition, otherwise the cruise system could shut off itself.





Sep 28, 2009 | Honda CR-V Cars & Trucks

2 Answers

Cruse controll


Pull up on the brake pedal. If that does not work check your brake light bulbs (LED brake lights will also keep your cruise control form working). Finally check all of the fuses. This system needs at least 3 different fuses to work properly.

Aug 05, 2008 | 1998 Honda Accord

Not finding what you are looking for?
2002 Chrysler Town & Country Logo

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8589 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...