Question about 1998 Plymouth Grand Voyager
Want my vehicle to pass inspection but the service the engine light is on.does this matter?
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There has been issues with the solder joints on the PIN connection to the gauge cluster. The issue being that over time thru vibration and such one of these solder joints will fail (happened on or 1999) you can repair this though. You will have to remove all of the trim from around the driver's side dash board, this will include the trim towards the center of the dash. Once these pieces are remove you'll need to remove the gauge panel (I believe (4) allen head screws) carefully bring the panel and release the wire clip from it. Looking at the back of the panel, where the plug was, carefully with plenty of light look for one of the pins to have a failed solder joint. It will be very faint however the failed joint will be a fine dark line around the pin. To correct use a small soldering iron and reheat this solder until it wants to flow, let it cool and reassemble.
As I fore mentioned I had the exact same issue as you are describing, our is a 99. The most tricky part is the dash, take your time with it.
I hope this may have assited you,
Posted on Oct 18, 2009
it is located behind and below the glove box,you might want to remove the glove box assembly to see it easier,
there are four screws holding a blower motor cover you to take off first,now remove the screws holding the blower motor up,disconnect the motor wires.
if your changing this because you think its bad,you should test the blower motor wires with a test light with the key on and blower switch turned on.if you have power in the wires,then it is bad.
but if you have no power in wires it could be blower motor resister,or switch.
Posted on Dec 06, 2009
its built into the lock mechanism lock might have to be replaced try adjusting it first. should be able to move the latch.
Posted on Jan 06, 2010
Testimonial: "A true expert. Makes sense to me."
Tips for a great answer:
Dec 26, 2016 | 1998 Plymouth Grand Voyager
Nov 15, 2014 | 1998 Plymouth Grand Voyager
Apr 24, 2014 | 1992 Plymouth Voyager
Oct 09, 2012 | 1998 Plymouth Grand Voyager
Jun 04, 2011 | 1998 Plymouth Grand Voyager
Apr 25, 2011 | 1991 Plymouth Grand Voyager
Apr 11, 2010 | 1998 Plymouth Grand Voyager
Nov 15, 2009 | 1998 Plymouth Grand Voyager
Oct 16, 2009 | 1998 Plymouth Grand Voyager
May 17, 2009 | 1998 Plymouth Grand Voyager
127 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: