Question about Chrysler Cirrus

Open Question

2000 cirrus no heat

Fan blows warm air heater core not blocked thermostat working

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

brainyass
  • 242 Answers

SOURCE: heater only blows warm air.

The hoses from your heater core should be very hot to the touch. Check the hoses going to the core from the water pump. It should be very hot. The return hose should also be very hot. Now check the hoses going to the core. If they are not the same temp, then your heater control valve is not working correctly or the vacuum is not working. At any rate, locate the vacuum line going to the heater valve. Remove the silver bar on the valve from the plastic plunger arm. You will have heat all the time now if it was only a vacuum problem. You can fix it later when it's warmer out. BTW a 200* thermostat will make your heater even hotter.

Posted on Nov 21, 2008

michigan man
  • 3533 Answers

SOURCE: 2000 expedition heat problem

first of all I would make sure the car has proper amount of coolant and you are right it is very possible you have an air pocket in the system also ask your self did you change the thermastat after you did the heater core when the car is cold make sure there is coolant at the cold mark on the reservior bottle because you might not have enough coolant then start the car and get it up to temp and if the coolant goes not go up to the hot mark when the car gets to temp you do not have enought coolant just keep adding coolant and you will see the bubble after the thermastat opens

Posted on Jan 12, 2009

  • 3 Answers

SOURCE: blowing cold air

I had the same problem that I just fix by flushing the heater core out with a hose.   take the two hoses off the fire wall and put the water to it and let flush.  my heater is putting out 150 dg. F  of hot air.   I'm so excited!  i will stay warm now.

Posted on Feb 27, 2009

  • 1 Answer

SOURCE: rear heater core works great fan works but doesn't

checked vacuum hose works good now

Posted on Oct 20, 2009

  • 1 Answer

SOURCE: I have a 2001 1500 dodge ram it has no heat

are heater inlet outlet mix valves standard for all dodge heater cores. I have 2001 dodge cummings blows warm air not hot when gauge is 195 degrees would there be a mix valve under the dash because it is not inline outside the wall

Posted on Nov 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is my heater blowing cold


Most likely it is the heater control valve that shifts air from blowing across your heater core to your air conditioner core.

If your fan works and your car is fairly new..meaning your heater core isn't dirty and full of craap...then it is the climate cotrol valve.
If you are lucky, it might be a thermostat that is bad and blocking hot water from entering your heater core. Bottom line, if hot water doesn't circulate thru that little heater core, you won't get heat.
You might be able to look under the hood and grab the hot water lines that go thru the firewall and feed your heater core. If they feel cold to the touch after engine has warmed up, then you aren't getting circulating water to the heater core. If they feel nice and warm, then the heater core is fine, but your climate control valve has closed off the fan that blows across the core to disperse heat into the cabin

Feb 24, 2015 | Cars & Trucks

2 Answers

2003 f350 diesel no heat


thermostat is sticking open

Dec 25, 2012 | Ford F-350 Cars & Trucks

1 Answer

My heater will not blow hot air in my 1999 Chrysler Cirrus


When the coolant flush was done, did you have the thermostat changed as well? I would have the thermostat replaced. If the temperature gauge was reading properly, but you still had warm, not hot air, it would lean more towards the heater core being clogged, but that deosn't seem to be the issue your having, so i would go with the thermostat replacement. And whereever you have the repairs done at...make sure they fully bleed all the air out of the cooling system, this could also cause poor warm-up / heating problems. Hope this helps...

Oct 27, 2012 | 1999 Chrysler Cirrus

1 Answer

Heater blows out cool air only


Could be a stuck thermostat... or low coolant level. feel hoses going to heater core, if only one is hot while car is warmed up. i would say the heater core is plugged because this is where you get the heat for inside of car ! hot coolant goes through heater core and a fan blows it out to heat inside of car. if both are hot then the heater core is ok.

Oct 20, 2011 | 2000 Pontiac Bonneville

3 Answers

No heat , replaced radiator , water pump, rad. cap , hoses and flushed system twice.blows cool air.whats left?


Thermostat.? if you haven't? Do it first then try it. While the car is running for a while touch the heater hoses that lead to the firewall. if one is cold and one is hot? You have a blocked Heater core. Follow the hoses back to the engine. Unconnect them both. By using a garden hose flush out the heater core do one side and then reverse by doing the other hose Lots of junk will come out so be care ful. Mistake people make is "Flushing the system" That doesn't mean your flushing the heater core.
Seeing that you have done everything else it could be the thermostat which you didn't list or the heater core being clogged. When you finished installing the thermostat and flushing the heater core out. Replenish the coolant system . If you have a bleeder on the thermostat housing? use it . loosen it and top off the fluid until you see fluid comeout of the bleeder. The system being air bound would cause no heat..

Jan 10, 2011 | 2000 Buick LeSabre

2 Answers

Changed thermostat and added coolant but 1997


could be waterpump?
i was going to say rad fan,but if so heater would be hot.
lack of coolant will make heater core to blow cold,if engine heats up with full coolant,usually means poor or no circulation.
water pump?
run engine with full coolant,at operating temp.with rad cap off and look in rad cap hole and see if there is movement of water inside rad.
[rad fan will not come on if water is not circulating through rad water pump?]

Dec 20, 2009 | 1997 Chrysler Cirrus

1 Answer

No heat from heater, blower works ,fan works ,coolant good, pump good, luke warm heat, 1988


check the temp of the heater hose going into fire wall,make sure they are both the same temp,if they are replace the thermostat.
if one is hot and the other is not,the heater core is partially block and will need blowed out with air hose or replaced

Dec 09, 2009 | 1988 Plymouth Sundance

1 Answer

No heat


CHECK THE HEATER CORE. MORE THAN LIKELY IT IS PLUGGED OR THE HEATER CONTROL VALVE IS NOT FUNCTIONING PROPERLY. THE HEATER CONTROL VALVE CONTROLS THE WATER TO THE HEATER CORE. THUS NO FLOW, NO HEAT. GOOD LUCK.

Jan 25, 2009 | 1996 Chrysler Cirrus

1 Answer

Heater blows cold air


With the car warmed up,feel the heater hoses,are they both warm/hot near the firewall in the engine compartment?If they are both warm/hot,then the heater core should have circulation through it and it may be a "blend door" issue in the heater a/c assembly.If they are not warm/hot then the heater core could be dirty and plugged up and needs to be flushed.
If the above does not help,a drain and vacuum of the cooling system and vacuum refill will remove any trapped air.
Sometimes,clamping off the top rad hose and holding the engine rpm at 2000 rpm will force trapped air out of the heater core.(Watch temp gauge when trying this)
Lastly,a NEW thermostat doesn't mean its working correctly.

May 18, 2017 | 2005 Lexus SC300

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...