Question about 2006 Chevrolet Aveo

1 Answer

P1107 while running engine get shivering when we are at a signal and engine light iluminated on display. some times not getting power to engine

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Master
  • 366 Answers

Check alternator belt not loose, also check battery connections are tight.

Posted on Dec 30, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2004 grand prix,sputters at 2000 rpm no engine light.w/ car off key on, press gas 5 times get codes 1125,2125. clear codes light goes out but still sputters. do i change accelerator and TPS?

.The control module provides the APP sensor a 5-volt reference circuit and a low reference circuit. The APP sensor then provides the control module a signal voltage proportional to pedal movement. The APP sensor 2 signal voltage is low at rest and increases as the pedal is depressed. When the control module detects that the APP sensor 2 signal or the APP sensor 5-volt reference voltage is outside the predetermined range, DTC P2125 sets.

The control module provides the APP sensors a 5-volt reference circuit and a low reference circuit. The APP sensors then provide the control module signal voltages proportional to pedal movement. The APP sensor 1 signal voltage is low at rest and increases as the pedal is depressed. The APP sensor 2 signal voltage is also low at rest and increases as the pedal is depressed. One APP sensor DTC will not cause the Reduced Engine Power message to be displayed. Two APP sensor DTCs for the same sensor also will not cause the Reduced Engine Power message to be displayed. However, if two or more DTCs are set involving more than one APP sensor, DTC P1125 will set.

Jan 17, 2017 | Cars & Trucks

1 Answer

Signal lights on dashboard

I would start at the left brake light. Check the bulb and wiring. Your brake light could be grounding through the blinker circuit.

May 13, 2013 | 2000 Chevrolet Venture

1 Answer

I am trying to find the fuse that lights up my shifter so I can see what gear I am in.

the power for the ilumination comes from the mlps switch on the side of transmission. If no ilumination suspect bad sensor.

Jan 06, 2011 | 2005 Ford F-150

2 Answers

Hi my plymouth 98 after start engine the first time in the morning the light advise engine service soon iluminate on the dashport the engine running with a light vibration for 3 minutes at the end is...

When light is on, take it to some place like autozone, let them do a code reading, they will do this service for free, get back with us the the trouble code number, so we can help you. This way you know what's going on, so it don't damage another sensor.

Aug 10, 2010 | 1998 Plymouth Voyager

2 Answers

Ck engine light , p1107 code reading ,cant find any vacum leak? olds 88 96 model 3.8 liter.

a3342: Your code is for map sensor intermittent low voltage.
This car has on board diagnostic capabilities which is what AllDATA recommends doing first.

Apr 24, 2009 | Oldsmobile 88 Cars & Trucks

2 Answers

Radio will not iluminate at night

U will need to pull the radio out of the dash and remove the top cover of the radio chassis, under that cover there is a tiny light bulb in a little socket that twists into the back of the dial display, the bulb looks like a miniature peanut, this is the back light for the radio display, u can buy the bulb at any full service parts store or at the dealer, about $1

Jan 05, 2009 | 2003 Toyota Tundra

1 Answer

1990 ford bronco/full size headlight, cab lighting, and sterio shut off

the connection to the light adjustment knob thats imbeded in your dash. the one that adjusts the intensity of your dash lights and such probably came loose or detached.

Nov 24, 2008 | 1990 Ford Bronco

Not finding what you are looking for?
2006 Chevrolet Aveo Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides