Question about 1999 Chevrolet Silverado 1500

1 Answer

FUEL PRESSURE REG

WHERE IS IT LOCATED

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 102 Answers

I would guess on the pump in the gas tank, if there is one,?Computer controlled try resetting that.good luck

Posted on Jan 17, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 KIA Sorrento 2.4 were is the fuel pressure regulator located. put on adjustable fuel reg .need to disconnect stock one


fuel pressure regulators are normally located in the fuel manifold. They are either vacuum controlled or electronic controlled to maintain the right fuel pressure for engine requirements and to shut off the fuel pump when the ignition is turned off
If your manually adjusted unit will not do all that then you are asking for fault codes to appear and all sorts of problems to occur

Jan 18, 2016 | Kia Cars & Trucks

1 Answer

Where is the fuel pressure regulator on a 2008 cobalt?


Look at your fuel rale. At the end of the fule rale is where the fuel pressure reg, is located. It should have a vacuume hose it it also. It should be about 2 inches round and about and inch thick.

Dec 02, 2012 | Chevrolet Cobalt Cars & Trucks

1 Answer

How do i change a fuel pressure regulator on a 1996 town and country lxi van ?... while driving the van shuts off and all rpms go down and then comes back on .. Someone told me to replace the fuel filter ,...


The filter needs to be replaced first, if there is not enough volume or pressure reaching the fuel rails, the pressure regulator it's not going to work, nor can it be tested accurately. Filter cost less and and is fairly easy to replace. The filter is located above and on the inboard side of the fuel tank

Fuel pressure should be 38-45 psi . Check the pressure before and after you replace the filter.

The pressure regulator is mounted on the throttle body with (2) 10mm bolts. It has a vacuum line and fuel line attached. Remove the vacuum line, make sure the line has vacuum on it, not cracked or broken--- If the vacuum line has any gas in it, replace the regulator.

I hope this helps & good luck with your Chrysler.

Sep 01, 2011 | 1996 Chrysler Town & Country

1 Answer

I have a 00 F250 after the truck is warm and under a load the fuel pressure falls to around 12 psi the fuel filter and pressure regulator are new fuel pump is 6 months old


i know pressure reg. is new but its bad. try when first crank up put a vacuum pump on reg. if pressure drops then drop replace it

Oct 28, 2010 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Where is the fuel pressure regulator located on a 1988 ford lobo


is this a car or a truck? in all the Fords i have worked on the regulator is located at the end of the fuel supply rail that goes over the fuel injector inlets on the top of the engine, it has a vacuum hose goint to it. see picture below of typical Ford pressure reg.


ab9f429.jpg

Oct 15, 2010 | 1988 Ford F 150

1 Answer

1996 Jeep Cherokee, straight 6cyl, new fuel pump and now it is struggling running and pushing to much fuel. How do check fuel regulator, or where is it located? Thanks


the reg is most likely on the fuel rail. perform a pressure test with a fuel pressure gauge. attatch the gauge to the test point on the rail(looks like a vavle stem on the wheel), start engine and measure pressure. you must get the specs for pressure for your vehicle.typicly between 30 and 50 shut the vehicle off and leave the gauge attached. the pressure should hold. is the check engine light on?

Feb 25, 2010 | 1996 Jeep Cherokee Country

1 Answer

Where is the fuel pressure regulator located on 1986 nissan d21 pickup


its at the rear of the fuel rail has a small vacuum hose goig to it ? suggest going t oadvance.com and type in your year make and model and "fuel pressure reg" it will show you a picture of it might help?

Aug 29, 2009 | 1989 Nissan Hardbody King

1 Answer

Van runs good when cold but wants to shut off a lights and will only keep running if I keepgiving it gas. Model does not have a egr valve could it be the pressure reg. located on the fuel rail


NO THE PRESSURE REGULATOR IS NOT THE ISSUE, THE FUEL PUMP MAY BE THOUGH, TEST THE PRESSURE WHEN THIS HAPPENS, THERE IS A TEST PORT ON THE FUEL RAIL.

Sep 02, 2008 | Ford Aerostar Cars & Trucks

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...