Question about 2005 Mazda 3

Open Question

How to check oil in manual transmission mazda b series 2005

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 84 Answers

SOURCE: engine seized no oil did not get check oil or check engine light

The oil pressure warning light only comes on when oil pressure drops below 4psi at this moment there is no oil in the engine most often it does not get to this point because oil, water etc is checked every week. It could be your engine was using oil which would point to an engine fault.

Posted on Jan 22, 2009

Ad
i4get75
  • 39 Answers

SOURCE: how do you check the

http://www.techguys.ca/howto/transmission_fluid.html

In addition to this site I have heard that you can remove the shifter boot and plate for easier access to the fill hole.

Posted on Jul 24, 2011

  • 1 Answer

SOURCE: Place to check and fill Transmission oil in Mazda Protege 1993

Don't listen to the other guy, I own a 1990 1.8L mazda protege with a manual transmission. Yes it will make it easier to hoist it up. I am not going into extreme detail so as long as you know a little about cars this will be a great help.
on the transmission locate the drain plug, it will be on the bottom of the transmission. don't loosen it yet you want to make sure you can fill the transmission before you drain it. there is no fill plug, you have to fill the transmission through the hole the speedometre cable is attached to the transmission. the speedometre cable is straight up and down/vertical, it should be above the passenger side cv shaft coming out of the transmission.
remove the small bolt holding it in place and then pull it straight up and out of the transmission. now drain the transmission. put the drain plug back in and start filling, make sure not to overfill you are not supposed to fill it right full.
Make sure to check the fluid level as you fill, the transmission is at the right level when the gear oil is just at the top of the speedometre gear that is on the end of the cable that is inserted into the transmission.
I believe these transmissions take 75w 90.
Hope this helped you, and maybe future people who view this looking for help.

Posted on Feb 18, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I check my transmission oil level on a Mazda familia sport 20 2001 model automatic transmission


Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
Best Manuals

Dec 31, 2016 | Mazda Cars & Trucks

1 Answer

How do you check the transmission fluid level on a 1991 Mazda 323 with a manual transmission?


U need to check if transmission oil or gear oil is needed for ur manual trans try to locate a dipstick normally on d top part of the trans otherwise look for threaded plug again on the upper sides of d trans and ur level would be reached when oil start dripping out of the plug hole in that case no need to fill. Good Luck

Nov 16, 2016 | Mazda Cars & Trucks

2 Answers

Maintenance?


ALL the RX-8's Series 1 or 2 use the same Oil's, BUT...

The Oil for the Diff and Transmission is NOT the same, one is GL4 and the other is GL5.
MT-90 GL4 75W90 for Transmission.
75W90 GL5 High Performance Gear Oil for Differential.

May 15, 2014 | 2004 Mazda RX-8

1 Answer

Jerking when it goes into 2nd gear


first step is to have the fault codes read so that you have an idea of what is wrong
next is to have the transmission oil changed as dirty oil will cause that sort of fault
find an accredited service center with mazda experience or go to an accredited automatic shop for a service f the transmission
it will be servo/solenoids or oil problems

Mar 27, 2017 | 2005 Mazda 3

1 Answer

2005 Mazda Tribute... Similar to a few unsolved issues. Burns excessive oil, ever since I got it. Every 1000km or so, 1/2 to 3/4 liter of oil. No leaks, emissions are okay. Also fuel economy is not...


Sounds like the Valve Guides are **** out oil is seeping down valve stems and burning in the cylinders. Some times STP oil treatment can slow the oil down because of its thickness. I have put about a cup of dexron2 transmission fluid in my oil to swell up the O-ring seal on the valve stem to stop this problem and a cup will not hurt anything. Like i have put STP in Automatic Transmissions to correct leaky valve body problem work like a charm.Can give you 3 to 5 more years of life to a transmission.

Feb 01, 2011 | 2005 Mazda Tribute

1 Answer

Mazda mpv 2000 no work reverse


Transmissions have a series of clutch plates, friction plates,bands,gears and solenoids located inside the transmission. As the vehicle moves forward, these plates operate similar to a clutch on a manual transmission, but using fluid pressure and momentum to do so. Usually these go bad due to lack of proper service intervals. If the fluid is not changed at recommended intervals, it breaks down, similar to engine oil,and causes the transmission to get hot and burn up these clutch plates and bands. Therefore you will get certain gears that will fail to engage. In your case, the reverse.

Oct 16, 2010 | 2000 Mazda MPV

3 Answers

Where is the manual transmission dipstick on 1993 mazda Mx6


manual gear boxes do not have a dipstick , there is a bung plug on the side of the box , about 1/2 way up. to check oil level,umdo that bung plug the oil level is the bottom of that hole.when at correct level oil will just drip over the lip.

Aug 16, 2009 | 1993 Mazda MX-6

1 Answer

Service for 2005 mazda mpv transmission


Yes, that and the oil of course. Just to be 100% clear on this, i'll explain every step in am automatic transmission service. First, drain the oil from the transmission by removing the drain plug. Second, remove the oil pan from the tranny. Then comes the removal of the filter. Then, replace the filter with the new one. Then clean the oil pan of excess dirt and gasket residue if any, and put the new gasket on the pan. Then you just put the oil pan back on the tranny and top off the oil. For the exact amount of oil needed, call your local dealer, or local garage or parts store. Then just verify the oil level just to be sure everything is OK, and note that most transmissions require the engine to be hot to have the correct level on the oil gauge. It should say if it is needed in your owners manual, or on most oil gauges it says ajust when hot, or hot level and cold level. If in doubt, ask the local dealer, garage or parts store again.

Jul 08, 2009 | 2005 Mazda MPV

Not finding what you are looking for?
2005 Mazda 3 Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...