Question about 2003 BMW Z4

Open Question

Z4 fault code 2CA2

Engine warning light came on , had diagnostic test done by friend and code 2CA2 came up

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 126 Answers

SOURCE: E46 323 1999 WONT START

how old is your battery? sounds like not enough juice from the battery to crank the starter motor. next time it happens, have someone jump you (or use a battery jumping box) to see if it will now crank. if it does, then battery is too old and should be replaced. good luck

Posted on Jan 25, 2009

Zim1308
  • 543 Answers

SOURCE: I have 3 sensor lights

there area magnitude of things that can be the issue here. I wil take a chance here and say that there is an issue with a couple of sensors. This situation involves 1. The brake light sensor (which indicates that i brake light bulb is faulty) 2. The Tire pressure sensor (which is the tire pressure) and 3. ABS sensor ( Which i would associate it with a wheel speed sensor)

You should check the tire pressure, and correct it. Check the bulbs on your brake light and replace as necessary. Then check for a torn or broken ABS sensor, which are located on each wheel,

Posted on May 31, 2011

darryllew398
  • 2 Answers

SOURCE: BMW E36 ABS WARNING LIGHT

i believe that the abs and esp are linked had the same problem on my x5 turned out to be steering angle sensor.

hope this helps

Posted on Aug 18, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Had my Smart 4-2 mot'd Monday and it needed a suspension arm on the passenger side. This was done on Tuesday. Saturday morning the engine management light came on yet the car runs and sounds fine.


Very seldom does the check engine light being on affect the way the engine runs, so have it tested for the fault that turned the light on, It is called an OBD2 fault code test and is done with a code reader through the diagnostic data link under the dash.

Sep 19, 2016 | Smart fortwo Cars & Trucks

1 Answer

What is ecu code 19 for 5.7 ltr vt 2?


It may well be the crankshaft position sensor, which is one of the most common error codes for any vehicle.

Unfortunately there's no way of testing a crankshaft position sensor other than replacing it.

A point to bear in mind is that an error code can display as a warning light .. and the true fault may be 'unknown'.

You have a choice: replace the crankshaft sensor in the hope that things are fixed .. or get a professional diagnostic check done. A mobile mechanic ..

A hand-held diagnostic machine is unlikely to be able to identify an error code on a pre-2004 vehicle. That's why mechanics -good ones - have a 'selection' of hand held diagnostic readers.

Feb 17, 2016 | 1999 Holden VT

1 Answer

What's some warning light on the 2002 mustang Gt?


If you have a service engine warning light showing up on your instrument cluster go to Autozone and get a free diagnostic test done. They will give you the codes and explanation.

Jul 09, 2014 | 2002 Ford Mustang

1 Answer

Z4 E85 2006 ABS Inspection


any one of the abs sensor could be faulty, have it scanned for fault codes to be sure.

Mar 16, 2014 | 2006 BMW Z4 Roadster

1 Answer

The BMW 330CI engine oil pressure warning lamp is lit.why?


The first trial. Switch on ignition. The engine oil pressure warning light for thered light. Start and run the engine, warning lights, half a minute later re lit, butthe Yellow state. Repeated tests a few times are so. Turn off the engine. Pull out the dipstick check the amount of oil, the normal. Self diagnosis to connect to the GTl diagnostic instrument, choose 3 E46 chassis models, click on the"test" button, the scanning of the electronic control system of the whole car.After click two times right. Enter the fault code list interface, can be seen in the"KOM combination meter" project. The store has a fault code.then use the obd code reader to check out it.

Nov 18, 2013 | BMW 330Ci Cars & Trucks

1 Answer

Engine warning light


Hello and welcome to fixya.com
turned on by the systems computer it is to alert you to the fact that the computer module has detected a fault in the systems operation, this can be the engine, the emissions system or the transmission. What must be done now is to have the system scanned for fault codes, these are called OBD2 fault codes, then diagnostics are performed to determine the cause of the fault codes and repair made based on the diagnostics performed.

Jun 19, 2012 | 2005 Ford Focus

1 Answer

I own 2006 vw passat 2.0 tdi. . car lost power other night.... got diagnostic report done come up with fault code p1040.... local garage seems to think this relates to the power circuit relay..can u...


P1040 VOLKSWAGEN - Injector 1 Supply Voltage Circuit Malfunction

Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)

Possible causes:
- Injector 1 circuit open or shorted
- Injector 1 circuit poor electrical connection
- Faulty injector 1

Test it and keep us updated.

Jun 07, 2011 | 2006 Volkswagen Passat

2 Answers

While driving on the parkway the check engine light on my 2006 uplander came on. i have 67000 miles on the van. . .what should i do


The check engine light could have come on for any of a large number of reasons, some potentially critical and some not. The only way to find out what caused the warning to come on is to take the vehicle to your mechanic or a dealer and have them read the fault code using their diagnostic computer. Call around for prices. Some charge for the reading, some don't, and some will charge but apply the cost towards any repairs that are done.
BillB

Feb 21, 2010 | 2007 Chevrolet Uplander LS Minivan

2 Answers

Engine warning light came on


It means the Engine Control Computer has picked up a fault of some kind. Many service providers will give you a free 'diagnostic' - they'll plug in a code reader and the code reader will tell you which fault occured. Most Checker auto parts places will read the engine codes free. If you disconnect the battery for two minutes, then reconnect, and the warning goes away, it was an intermittent fault - not to worry.

Gene, in AZ

May 24, 2009 | 2006 Toyota Tundra

1 Answer

Warning lights


this means you have some problems
have a computer diagnostics test done to get the DTC's diagnostic trouble codes

Dec 18, 2008 | 2007 Subaru B9 Tribeca

Not finding what you are looking for?
2003 BMW Z4 Logo

Related Topics:

277 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...