Question about 2004 Toyota Sienna

Open Question

Is the p2716 code a recall

Does the p2716 code cause my transmission to slip and my van 2to run rough?

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: oem code p2716

Same issue.

There is a service bulletin on this. Toyota will replace computer. I have a 2007 Corolla S with 56,000 miles

Posted on Mar 07, 2009

Ad
bschilz
  • 2049 Answers

SOURCE: Transmission code error P2716

The computer wants to know if the transmission is working properly. So it reads the speed of the input shaft and compares it to the speed of the output shaft. It knows which gear you're in because it commanded the transmission to shift into that gear. The turbine speed refers to the torque converter. That's the device that transfers power from the engine to the transmission. Think of two fans facing each other. Turn on one fan and the blades on the other fan will spin. The fan that ISN'T turned on is the turbine. So, with the input shaft or turbine speed, the gear selection, and the output speed, the computer can calculate how efficiently the transmission is working. If the speed is off, it knows that something is slipping inside the transmission. It can then try to boost the fluid pressure to compensate. If that doesn't work, it sets a different trouble code, usually a P0716 code means that the computer has detected a value for the input sensor that's either out of range (way too high or too low), or there's a circuit issue (bad wiring, etc. Should probably get it to a repair shop ASAP before damage is done.

Posted on Sep 19, 2009

  • 1861 Answers

SOURCE: engine light on...P2716 diagnostic

Hello. Welcome to FixYa.

No, the P-2716 DTC is not a recall.
It is a software issue that results in a 'false code' being generated.

What Toyota is doing is replacing your computer with an updated unit; the programming in the current computer needs to be changed, and the Corolla computer you have cannot be 'reflashed', it must be physically changed out.

If you car has less than 80,000 miles on it, the replacment will be free.
Get in touch with your local toyota dealership, and they will get you a new computer.

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Pressure control solenoid electrical fault


code p2716 refers to transmission fluid pressure (TFP) solenoid D --electrical=== causes wiring---TFP solenoid
check all connections are clean and tight . replace the solenoid.

May 14, 2014 | 2013 Mazda MAZDA6

1 Answer

My 2005 Corolla is continuing to have trouble with shifting. I keep getting the code p2716, but I have already had the compression solenoid for that code replaced. What should I do?


There is currently a recall going on for this problem. You can likely get your money back on the prior repairs as well. See this link http://www.toyota.com/recall/corolla-matrix.html. On the left-hand side, you can click to take you to put in your VIN and see if your vehicle is included. My 2007 vehicle IS included, and I just had the check engine light come on and have been experiencing rough shifting for about 6 months. When the light came on yesterday, it was extremely rough jerky shifting. The light went off today. Took it to Autozone and got same code P2716. Toyota has assigned me a case number, but I won't get a call back until Monday or by close of biz on Tuesday. This problem can cause your car to not start, or to shut down while driving. YIKES! The person I talked to at Toyota acted a little too nonchalant about the whole deal. Telling me to just wait for the call that I will get. She said most dealers would not have the part needed to fix this. According to what I have read. That is the reason why Toyota is not sending out the notification letters to the affected parties until mid-September. Check out all the info and good luck. I am a little bit p.o'd about this right now. - Natalie

Aug 25, 2010 | Toyota Corolla Cars & Trucks

1 Answer

I have a 2005 toyota Corolla. The check engine light came on. I had it check and a code of P0741 came up. Do you know how much this cost to fix? The code P2716 also came up but this is covered under...


There is currently a recall going on for this problem. You can likely get your money back on the prior repairs as well. See this link http://www.toyota.com/recall/corolla-matrix.html. On the left-hand side, you can click to take you to put in your VIN and see if your vehicle is included. My 2007 vehicle IS included, and I just had the check engine light come on and have been experiencing rough shifting for about 6 months. When the light came on yesterday, it was extremely rough jerky shifting. The light went off today. Took it to Autozone and got same code P2716. Toyota has assigned me a case number, but I won't get a call back until Monday or by close of biz on Tuesday. This problem can cause your car to not start, or to shut down while driving. YIKES! The person I talked to at Toyota acted a little too nonchalant about the whole deal. Telling me to just wait for the call that I will get. She said most dealers would not have the part needed to fix this. According to what I have read. That is the reason why Toyota is not sending out the notification letters to the affected parties until mid-September. Check out all the info and good luck. I am a little bit p.o'd about this right now. - Natalie

Jun 08, 2010 | 2005 Toyota Corolla

2 Answers

Pressure Control Solenoid P2716 toyota matrix issue


There is currently a recall going on for this problem. You can likely get your money back on the prior repairs as well. See this link http://www.toyota.com/recall/corolla-matrix.html. On the left-hand side, you can click to take you to put in your VIN and see if your vehicle is included. My 2007 vehicle IS included, and I just had the check engine light come on and have been experiencing rough shifting for about 6 months. When the light came on yesterday, it was extremely rough jerky shifting. The light went off today. Took it to Autozone and got same code P2716. Toyota has assigned me a case number, but I won't get a call back until Monday or by close of biz on Tuesday. This problem can cause your car to not start, or to shut down while driving. YIKES! The person I talked to at Toyota acted a little too nonchalant about the whole deal. Telling me to just wait for the call that I will get. She said most dealers would not have the part needed to fix this. According to what I have read. That is the reason why Toyota is not sending out the notification letters to the affected parties until mid-September. Check out all the info and good luck. I am a little bit p.o'd about this right now. - Natalie

Oct 12, 2009 | 2006 Toyota Matrix

2 Answers

Hello i have a code p2716 in toyota crolla 2006


THIS FIX IS COURTESY OF EXPERT TOYOTA ED, HE IS A TOYOTA DEALER SERIVCE MANAGER, THANKS ED!
There is a known issue with the 2005-2007 Corolla automatic transmission shift logic. The shift points may seem harsh, and the Check Engine light may be illuminated.

There is a
technical service bulletin published (TC015-07) that will address and rectify this condition.

The diagnostic code P2716 will be stored in the
computer memory. The procedure involves replacing the Engine Control Module (the computer) with an updated unit.

The repair is covered, under the factory warranty, for 96 months, or 80,000 miles, which ever comes first.

I hope that this helps you Corolla owners out

Oct 01, 2009 | Toyota Corolla Cars & Trucks

1 Answer

Transmission code error P2716


The computer wants to know if the transmission is working properly. So it reads the speed of the input shaft and compares it to the speed of the output shaft. It knows which gear you're in because it commanded the transmission to shift into that gear. The turbine speed refers to the torque converter. That's the device that transfers power from the engine to the transmission. Think of two fans facing each other. Turn on one fan and the blades on the other fan will spin. The fan that ISN'T turned on is the turbine. So, with the input shaft or turbine speed, the gear selection, and the output speed, the computer can calculate how efficiently the transmission is working. If the speed is off, it knows that something is slipping inside the transmission. It can then try to boost the fluid pressure to compensate. If that doesn't work, it sets a different trouble code, usually a P0716 code means that the computer has detected a value for the input sensor that's either out of range (way too high or too low), or there's a circuit issue (bad wiring, etc. Should probably get it to a repair shop ASAP before damage is done.

Sep 19, 2009 | Toyota Corolla Cars & Trucks

2 Answers

What is P2716 code for a 2006 Toyota Corolla mean?


There is currently a recall going on for this problem. You can likely get your money back on the prior repairs as well. See this link http://www.toyota.com/recall/corolla-matrix.html. On the left-hand side, you can click to take you to put in your VIN and see if your vehicle is included. My 2007 vehicle IS included, and I just had the check engine light come on and have been experiencing rough shifting for about 6 months. When the light came on yesterday, it was extremely rough jerky shifting. The light went off today. Took it to Autozone and got same code P2716. Toyota has assigned me a case number, but I won't get a call back until Monday or by close of biz on Tuesday. This problem can cause your car to not start, or to shut down while driving. YIKES! The person I talked to at Toyota acted a little too nonchalant about the whole deal. Telling me to just wait for the call that I will get. She said most dealers would not have the part needed to fix this. According to what I have read. That is the reason why Toyota is not sending out the notification letters to the affected parties until mid-September. Check out all the info and good luck. I am a little bit p.o'd about this right now. - Natalie

Sep 13, 2009 | 2006 Toyota Corolla

4 Answers

Oem code p2716


Same issue.

There is a service bulletin on this. Toyota will replace computer. I have a 2007 Corolla S with 56,000 miles

Nov 01, 2008 | 2007 Toyota Corolla

Not finding what you are looking for?
2004 Toyota Sienna Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8557 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...