Question about Chevrolet Express

2 Answers

Turn ignition key nothing happens

Battery fully charged and when i turn the key nothing happens. it started a few times with no cranking sounds from starter. chevy express 3500 van 2003

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Chevrolet Expert
  • 252 Answers

Starter may have quit. If you can get to the wiring on the starter, you can jump it with a screwdriver and see. If not, you can take it out and test it. I'll warn you though, bench testing it doesn't mean it will work under a load. I pulled one that wouldn't do anything. Tested fine on the bench. I had done some other troubleshooting and was almost certain it was the starter. I replaced it and Bam, works good. Plenty of info to show you how to check in the link. how to test starter YouTube

Posted on Jan 05, 2016

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 4 Answers

Crank shaft sensor maybe?

Posted on Dec 30, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pippall
  • 1486 Answers

SOURCE: Ignition and/or starter problem.

Immobilizer armed its self

Posted on May 29, 2009

  • 4 Answers

SOURCE: 2002 chevy express fuel pump/crank sensor?? not starting

i had a similar problem and called the dealer during lunch hour. i talked to a mechanic, the distributor in these vehicles is plastic, and is prone to cracking.not just the cap but the body also, I have been taking the cap off and wiping the moisture out of the cap. or replacing the cap but the problem is I need a new distributor. just a cheep way to get rolling is cleaning the inside of the cap, especially when it is very damp or the outside temp changes alot during the day. good luck.

Posted on Jul 03, 2009

  • 56 Answers

SOURCE: 2003 Chevy Impala periodically won't start

Try under the dash, attached to colum is a switch that the rod goes into from your ignition key switch, that may need to be adjusted tword your steering wheel just a touch, they go out of alignmnet from time to time

Posted on Sep 15, 2009

  • 12104 Answers

SOURCE: 2004 chevy 3500 express passenger van transmission

if ur replacing it remove front grill disconnect both lines and carefully remove retaining clips from radiator if replacement is original eguipt mount & reconnect --if its a universal follow instructions usually cut off fittings and use clamps and hose to hook up

Posted on Oct 27, 2009

  • 1810 Answers

SOURCE: 2000 CHEVY EXPRESS 1500 VAN. BUZZER/CHIME RINGS

locate chime under dash and remove it

Posted on Jan 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

What happens when you take the battery out leave it out for a 30 days


Would suspect the new battery or battery connections. If the terminals have not been cleaned before installing the new battery it is possible that an oxide layer has built up during the extended storage without a battery installed.
Turn dome lights on manually and observe when you attempt to crank the car. If they dim test the crank voltage with a multi meter on the terminals of the battery. Leaving the car with out a battery would not have a lasting problem. Removing the battery for about an hour would have the same effect as thirty days.. With an interruption of the 12 volt supply the EMC (engine control module) will lose the running parameters that were learned. The factory defaults will be installed. This can create an idle and shift problem for the first few miles of operation.

26121683-4vc0c40x2fxceyzbnoyxjmn0-3-0.jpg

Mar 07, 2016 | 2004 Mazda RX-8

1 Answer

2009 jeep commandeer wont start, when I turn the key there is no sound, lights wont turn on and is that wasn't enough the key gets stuck in the ignition. any ideas?


it wont crank, no A/t car starts unless cranked first. (a key point)

fix head lights first. this is a feature in all cars.

that is SIMPLE and HOT all the time

they must work at all times and is the top way to diagnose

electric problems



you have a dead battery,.

only why remains.

i bet it cranks jumper cable started, call AAA or buy some cables.

or swap in a charged battery , or heck charge yours, buy a charger.

check fuses.

check battery lugs for green death?

check battery voltage. at 12.6vdc, if not charge the battery

if the battery continues to disgharge.

that is called phantom drains, or bad battery .

or the alternators is bad.(system)

once started the battery volts must be 13.3.to 15v, if not the charge system is bad ,(fuses, belts slipping and lots more possibles)

Sep 19, 2014 | 2009 Jeep Commander

2 Answers

Keys turns on but wont start the engine


check:
battery good 11 v min
battery conecctions cables, all clean
if automatic trans, in park or neutral selector
if standar trans, press the clutch pedal full down, check switch in pedal
the dash lights all on in switch on, check for antiefth extra
alarm disabled
and doors closed, seat belts
or crank start but engine no start need a full diagnosis for qualificated personal.

Sep 09, 2014 | Cars & Trucks

1 Answer

Cant remove key


Try the reset for the key switch , hook up battery charger or maintainer to battery then turn key on do not crank engine leave key in on position for ten minutes , repeat a total of three times then turn key switch to off position after third cycle then remove key . Then reinstall key to ignition switch then crank the engine over and see if that fixes your issue .

Jan 23, 2014 | 2000 GMC Jimmy

1 Answer

Key turns in ignition but nothing happens


could be alot of things I would start with the battery make sure its fully charged then I would check the silonoid turn the key to on position put a screw driver from post to post on siloniod it could be an electrical problem computer or even a silent alarm I dont know about the malibu but on bmw this is the same thing that happens when the silent alarm is triggered

Dec 22, 2012 | 2006 Chevrolet Malibu LT

1 Answer

2002 cadillac escalade engine doesn't crank


From your description, it could be a defective ignition switch

Nov 12, 2012 | 2002 Cadillac Escalade Base

1 Answer

2002 S10 4 cyl 5 speed manual trans. Truck will not start, no power to starter, or starter relay, when turning key odometer readout goes blank in run position, and fuel gage appears to not power up aswell....


could be the security system. this same thing happened to my grandmothers s-10. she took it to dealer and sure enough thats where the problem lay. i would start there

Aug 01, 2009 | 2002 Chevrolet S-10

3 Answers

I have a 1997 Grand Am 2.4 SE that won't start


Check battery full charge, battery terminals are clean, cables aren't cracked, broken or corroded and alternator first.

Which your having replaced your starter with new already. If you're still getting nothing it sounds like a bad ignition switch.

They wear normally and need to be replaced. But as a helpful hint don't place excess keys or weighty trinkets on your ignition keys.

They wear on the seating of the key in the ignition and often promote failure in the ignition from bearing the dangling weight.

Jul 27, 2009 | 1997 Pontiac Grand Am

1 Answer

Engine won't crank or seem to get power on key turn.


More than likely, your starter has gone out. If the battery is fully charged and its not even turning over, that is what i would start with.

Jun 17, 2009 | 2003 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

322 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...