Question about 1997 Subaru Legacy

Open Question

1997 subaru 2.2L eng. Only 4.25 volt at the fuel pump connector

Posted by Anonymous on


5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 78 Answers

SOURCE: fuel pump runs all time on 1997 subaru

Try replacing the fuel pump relay

Posted on Jul 29, 2010

  • 277 Answers

SOURCE: where is fuel pump located on subaru impreza wrx

Most likely in the gas tank.

Posted on Jun 04, 2011

  • 98 Answers

SOURCE: Try to find the fuel pump relay on a 1997 Subaru Legacy 2.5

Should be located in this relay box.

Posted on Nov 27, 2012

  • 196 Answers

SOURCE: 1997 subaru Impreza sport won't stay running . stalls after minute replaced Fuel pump,filter spark plugs wires ,cleaned injectors checked fuel pressure what next

check your grounds. I find many easy fixes by cleaning all the grounds around the engine bay. I would also check the ground at the fuel pump connector that wiring is prone to corrosion and breakage

Posted on Feb 25, 2013

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

No fuel to engine

Check fuses first. With a volt meter check for power to the fuel pump relay and thru the relay. Check for power at the fuel pump connector in the trunk. If you have power to the pump replace the pump.

Feb 05, 2014 | 1997 Volvo 850

1 Answer

Having problem with 1998 Mercury Grand Marquis LS Fuel Pump. Only getting 6.58 volts at the pump. Suggestions?

Sounds like a bad connection between the two points.
It may be easier to run a new wire than to tear the harness and connectors apart.

Sep 28, 2012 | 1997 Mercury Grand Marquis

1 Answer

Where is the fuel pump located on the subaru outback wagon?

You should have an access panel under rear seat or in cargo area. on passenger side. here is a replacement procedure

Hope this helps, it it does please leave feedback and vote Thank You and Good Luck
  1. Release fuel pressure.

  1. Disconnect fuel delivery hose (1) and return hose (2).
  2. Disconnect jet pump hose (3).

  1. Remove nuts which install fuel pump assembly on to fuel tank.

  1. Take off fuel pump from fuel tank .


Connect lead harness to connector terminal of fuel pump, and apply battery power supply to check whether the pump operates.


  • Wipe off the fuel completely.
  • Keep Battery as far apart from fuel pump as possible.
  • Be sure to turn the battery supply "on" and "off" on the battery side.
  • Do not run fuel pump for a long time under non-load condition .
Installation is in the reverse order of removal. Do the following:

  1. Always use new gaskets.
  2. Ensure sealing portion is free from fuel or foreign particles before installation.

  1. Tighten nuts in numerical sequence shown to specified torque.
Tightening Torque: 4.4 ±1.5 N.m (3.3 ±1.1 ft-lb)

Jan 02, 2011 | 1997 Subaru Outback

1 Answer

Trying to change the fuel pump on a 1997 Subaru Legacy Wagon? Will I have to drop the tank? Any additional instructions would be much appreciated! Thank You!

The fuel pump is located behind the rear seat on the passenger side. Remove the upholstery cover to expose the metal oval cover which will expose the fuel pump. D/C the neg terminal and the electrical connector. Remove the nuts to release the fuel pump from the tank. Only now you can release the fuel hoses. Reverse the procedure to reinstall the new fuel pump.

Sep 21, 2010 | 1997 Subaru Legacy

1 Answer

Fuel pump runs all time on 1997 subaru

Try replacing the fuel pump relay

Jul 29, 2010 | 1997 Subaru Outback

1 Answer

How do i relieve the pressure to replace the fuel filter?

 Disconnect the wiring connector of the fuel
 Crank the engine for more than five seconds.
If the engine starts, let the engine run until it
 After turning IG switch OFF, connect the wiring
connector of the fuel pump.
 Disconnect ground cable from battery.
2) Loosen the screw of the hose clamp and pull
off the hose from the filter.
3) Remove the filter from the holder.
4) Replace fuel filter with a new one

Nov 11, 2009 | 1997 Subaru Legacy

1 Answer

1997 GMC Sierra 5.7 Vortec, replaced the fuel pump, fuel filter, spider injector. Still not getting fuel past the spider. fuel pressure is 10 psi! What could be wrong

10psi is, as I'm sure you know, about 48psi short of what you need to get it running. Did you verify you're getting a full 12 volts at the fuel pump connector? Check the ground wire also, ohm it out to chassis ground, shouldn't be more then a few ohms. Verify it's making a good connection and the terminals are clean and tight. High resistance in the wiring or a connector in the circuit could cause the fuel pump to not output the right amount of pressure.
Did you replace the fuel pump with an aftermarket unit or an oem part?

Nov 01, 2009 | 1997 GMC Sierra

1 Answer

My Subaru '96 outback suddenly does not start at all.

nope. no suggestions. you hvave a dead fuel pump! Mine went exactly the same way.

Mar 29, 2009 | 1997 Subaru Outback

Not finding what you are looking for?
1997 Subaru Legacy Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Brandon Johnson
Brandon Johnson

Level 2 Expert

251 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides