Question about 2006 Toyota Tacoma

1 Answer

Diy installing new electric break

I need to install a electric break on my 1998 toyota tacoma sr5 4x4 3.4 v6. is this something i can do with average machanic skills?

Posted by on

  • markswindell May 19, 2009

    Thanks, so you just plug in the controler ? anything else i need to do? thanks for your help!

  • markswindell May 19, 2009

    Thanks so much for your help! I really appreciate it. Mark

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 245 Answers

Yes this can be done by yourself the truck should have come with a pigtail that will plug up under the dash to connect the controller to. if you did not buy the truck new or no longer have that pigtail you can buy them at the dealer they cost approx. $30. all of the newer trucks are prewired for the trailer brakes.

Posted on May 19, 2009

  • jon fuller May 19, 2009

    nope you just wire the controller to the pigtail and plug it in then if you dont already have the 7 pin wiring on the back of the truck you need to install it and find the wire in the rear harness of the vehicle not sure where they have it tucked in the toyotas

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Temp sensor on 1998 toyota tacoma 3400


The engine coolant temperature sensor is usually located on the thermostat housing. This sensor controls the readings of the coolant temperature gauge in your vehicle when the ignition switch is ON .Here's a link to the sensor. REMOVAL & INSTALLATION

  1. Drain the coolant from the vehicle.
  2. Disconnect the engine wiring protector from the brackets.
  3. Disconnect the sensor wire.
  4. Using a 19mm deep socket, remove the sensor and gasket.
To install:
  1. Apply a thin coat of Loctite or equivalent to the switch. By hand, carefully thread the switch into the engine. If resistance is felt at all, remove the switch and inspect the threads for any damage. Continue to install the switch. Once installed, tighten to 14 ft. lbs. (20 Nm).
  2. Connect the sensor wiring.
  3. Install the engine wire protector to the brackets.
  4. Refill the coolant. Start the engine and check for leaks.
http://www.autozone.com/engine-management/coolant-temperature-sensor/duralast-coolant-temperature-sensor/toyota/tacoma-2wd/1998/6-cylinders-n-3-4l-efi-dohc/61401_0_18589

Aug 01, 2015 | 1998 Toyota Tacoma

2 Answers

How do i fix my 98 tacoma's powersteering when its pluged?


In that case then the fluid is too thick of a viscosity to run through the lines. In some cases you can clean it out otherwise install a new one. must pull pump to clean out.

Nov 27, 2014 | 1998 Toyota Tacoma

1 Answer

ABS light. I have a 1999 4WD limited V6 Tacoma. The abs light is on all the time and I don't feel the system operating anymore. The break pads and rear bands are new, the pump is working well, the...


Issue with your master line... Check for Rusty and Pinch Line along the Frame at the Back Check Rubber Line Joint for leaking Oil ..Check Level Gauge into Brake Container for bad connection

Oct 06, 2010 | 1998 Toyota Tacoma

1 Answer

How do i remove the manuel clutch to a 1998 tacoma


If you want to change the "Remove clucht trasmision bars front and rear, remove the cylinder in the booth attendant said you have to remove the gear-change broadcasts have jack-remove the bracket that supports the transmission back-to remove the exhaust pipe - Put the jack, remove the screws that attach the transmission with the engine off, remove the transmission clucht well ... You have to ensure the transmission on the jack will not fall

Jan 11, 2010 | 1998 Toyota Tacoma

1 Answer

Working on a 98 toyota tacoma v6 4wd 3.4l eng. I


Yes,need to make sure crank is at TDC as well

Oct 09, 2009 | 1998 Toyota Tacoma

2 Answers

1998 Tacoma V6 (Pre-runner) dies when key is released


I BELIEVE they have A BALLAST RESISTOR Close to the COIL that Will Cause this if they FAIL

Aug 12, 2009 | 1998 Toyota Tacoma

2 Answers

Difficulty in replacing v6 valve cover gaskets


at auto store they sell gasket adhesive or use a little silicon and clean cover til oiless ( use break cleaner) and glue gaskets in place and let dry and then install

Jul 08, 2009 | 2002 Toyota Tacoma

2 Answers

1997 Toyota Tacoma v6/4x4/manual: Clutch petal/Clutch


I currently have a 1998 Toyota Tacoma, and the clutch pedal does not return all the way. I know it is not the clutch, it is actually the spring located underneath the pedal. It is catching and not releasing after pushed.... Hope it helps.

Jun 19, 2009 | 1998 Toyota Tacoma

1 Answer

Need plug wire schematic for 2000 toyota tacoma


REMOVE THEM ONE AT A TIME THIS WAY YOU DONT GET THEM MIXED UP.

Mar 19, 2009 | 1998 Toyota Tacoma

2 Answers

Toyota tacoma headrest removal


There should be a button on the base of the headrest to raise & lower it. Push the button, and lower it. With the button pushed, raise the headrest, and pull hard. They ARE tight.

Jun 25, 2008 | 1999 Toyota Tacoma PreRunner

Not finding what you are looking for?
2006 Toyota Tacoma Logo

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...