Question about 2007 Toyota Avanza 1.3

Open Question

Code trouble dtc - 2007 Toyota Avanza 1.3

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes service 4wd light to come on in a 2006 hummer h2


Could be any number of thing's , having the 4X4 control module checked for code's is the first thing you should do , before just replacing parts. Do you know what a DTC is ? Diagnostic trouble code .
DTC B0790
DTC B2725
DTC C0306
DTC C0327
DTC C0329
DTC C0359
DTC C0550

Apr 13, 2018 | Hummer Cars & Trucks

2 Answers

What are the probable causes of DTC P0720?


According to the database the code means OUTPUT SPEED SENSOR CIRCUT MALFUNCTION.

Dec 12, 2015 | Cars & Trucks

1 Answer

What does no dtc code on a 2001 Nissan pathfinder mean


DTC = Diagnostic Trouble Code.
No DTC means no trouble.

Feb 18, 2015 | 2001 Nissan Pathfinder

1 Answer

Where is the obd2 connector location on holden ra rodeo v6


isuzimpuls.gif
Connect white (test lead) and black (ground lead) wires that are branched from harness approximately eight inches from ECM. After leads are grounded, the "Check Engine" light will flash the diagnostic trouble codes. The DTC's are indicated by the flashing CEL.
FLASH, FLASH, pause, FLASH, FLASH, FLASH = Code 23.
If only one diagnostic trouble code is stored, the DTC will repeat continuously until test leads are disconnected. If more than one diagnostic trouble code is stored, each DTC will repeat three times, starting with the lowest, then proceed to the next DTC. After all DTC's have been displayed, the pattern will repeat.I-MARK 84-85
Connect male and female test leads taped into wire harness near ECM. After leads are connected, the "Check Engine" lamp will flash the trouble codes. The DTC's are indicated by the flashing CEL.
FLASH, FLASH, pause, FLASH, FLASH, FLASH = Code 23.
If only one diagnostic trouble code is stored, the DTC will repeat continuously until test leads are disconnected. If more than one diagnostic trouble code is stored, each DTC will repeat three times, starting with the lowest, then proceed to the next DTC. After all DTC's have been displayed, the pattern will repeat.
86-87 Impulse located near the ECM connector, is used to actuate the Engine Control Module (ECM) trouble code memory within the module. Two terminals (A and C) of this connector are used to activate the diagnostic trouble code system in the ECM. With the ignition switch turned On, engine Off, connect a jumper wire between terminals A and C. The "Check Engine" lamp will begin by flashing a DTC 12. DTC 12 = flash, pause, flash, flash. There will be a longer pause and a code 12 will repeat two more times. This code indicates the self-diagnostic system is operating. The cycle will then repeat until the engine is started or the ignition is switched Off. In most cases, DTC's will be checked with the engine running since no DTC's other than DTC 12 or 51 will be present without the engine running. Remove jumper wire from ALDL connector before starting engine. Reconnect jumper wire after engine is running.

Throttle Body Fuel Injection

The ECM test connection is located under the center console.
A built-in, self diagnostic system will identify problems in the throttle body fuel injection system. When a problem is detected, the diagnostic system will illuminate the "Check Engine" light.
When the engine is started, the Check Engine light should turn off.. If the light remains lit, the self diagnostic has detected a problem. To determine where the problem exists, ground the "Test" terminal of the connector with the ignition On, engine Off and watch the check engine light. Each DTC will flash three times (lowest to highest).

Aug 21, 2014 | Holden Rodeo Cars & Trucks

2 Answers

What is DTC mean


Diagnostic Trouble Code- the codes the computer stores in memory when it senses a malfunction or aberration of sensor information. there are hundreds of possible trouble codes.

I hope that's the DTC you meant. Manufacturers use all kinds of such 3 or 4 letter symbols to denote a system. Last best chance is to "google it".

May 06, 2014 | 2002 Acura 3.2TL

2 Answers

What is dtc?


This means Diagnostic Truoble Codes;

A DTC is made up of 5 digits. The figure below demonstrates the composition of a DTC. With this information it is easier to trouble shoot a DTC without knowing the description of the code.


8_14_2012_6_35_17_pm.gif

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Aug 14, 2012 | 2002 Mitsubishi Montero

1 Answer

What is service engine light code 12 mean



READING CODES USING MIL (CHECK ENGINE) LAMP

Be advised that the MIL or CHECK ENGINE light can only perform a limited number of functions and it is a good idea to have the system checked with a scan tool to double check the circuit function.

  1. Within a period of 5 seconds, cycle the ignition key ON - OFF - ON - OFF - ON .
  2. Count the number of times the MIL (check engine lamp) on the instrument panel flashes on and off.

The number of flashes represents the trouble code. There is a short pause between the flashes representing the 1st and 2nd digits of the code. Longer pauses are used to separate individual 2-digit trouble codes.
An example of a flashed DTC is as follows:


Lamp flashes 4 times, pauses, then flashes 6 more times. This denotes a DTC number 46. Lamp flashes 5 times, pauses, then flashes 5 more times. This indicates a DTC number 55. DTC 55 will always be the last code to be displayed.


0900c1528007935b.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 2: Diagnostic trouble code chart (1 of 2)-1995-97 engines


0900c1528007935c.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 3: Diagnostic trouble code chart (2 of 2)-1995-97 2.0L engines

Jul 26, 2012 | 1995 Dodge Neon

1 Answer

How do you reset the security light on a 2005 chevy cobalt?


There is no reset , if security light is lit there is a problem with the anti-theft system .Should have it checked for DTC'S - diagnostic trouble codes . Could have 8 different B - codes
DTC B0685 DTC B2955 DTC B2960 DTC B3031 DTC B3033 DTC P1626 DTC P1630 DTC P1631
You would need a professional type scan tool to read these type codes , not an OBD 2 code reader .

Apr 14, 2012 | Cars & Trucks

1 Answer

2002 Buick LeSabre ECM DTC codes


P14xx and P15xx Diagnostic Trouble Codes?????????? You say has no DTC'S ???? What ?????

006 O2 Sensor Signal Analysis
What are the fuel trims at ? add fuel ,taking it away . Are the O2 sensors switching ?
What does scan data show the mass air flow sensor doing ?
010 Mass Air Flow Signal Analysis

006 Fuel Pump Current Testing Fuel pressure is AOK ??? fuel flow ?

035 Emission Tests Lean Fuel Condition

002 Fuel System Tests Start Here
DTC P1404
DTC P1441
DTC P1635
DTC P1639
DTC P1640
DTC P1650
DTC P1660
DTC P1670




Jul 24, 2017 | 2002 Buick Rendezvous

Not finding what you are looking for?
2007 Toyota Avanza 1.3 Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...