Question about 2004 Chrysler Sebring

Open Question

Need to replace oil filter mount ,broke oilfilter mount off its aouter lower passenger side

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the oil pressure switch located on a 88 dodge dakota?


Under hood, driver side, lower engine area, rear of oil filter, mounted in block for a 4cylinder and 6 cylinder is passengers side of distributor lower on block

Oct 09, 2014 | Cars & Trucks

2 Answers

Where is the oil pressure sending unit on a 1993 jeep grand


on the 4.0 motor Under hood, passenger side, lower engine area, rear of distributor, mounted in engine block.
on the v8 Under hood, center, rear engine area, passenger side of distributor, mounted in block.

Feb 09, 2010 | 1994 Jeep Grand Cherokee

1 Answer

I have a 95 ford tauras,3.8 v6. Ineed to remove the external oil pump,there is steady oil drip cpming from where it mounts.How hard and what is involed to remove it??


You mean the oil filter, don't you? The filter needs to be tightened or replaced. It is located passenger side, looking up from underneath the car you will see it tucked away towards the front of the car, passenger side. Good luck!

Nov 29, 2009 | 1995 Ford Taurus

1 Answer

1990 riviera oil pressure guage goes nuts when accelerating. can just a sensor be replaced?


Could be. Check the wiring at the oil pressure sending unit. If the wiring is good, replace the sensor. It is located Under hood, passenger side, rear engine area, above oil filter, mounted on lower timing cover. Curtorsey: Auto Zone.

Sep 07, 2009 | 1990 Buick Riviera

1 Answer

2002 chevy cavalier - somthing hitting oil filter


if you can't tell buy looking at the mount get somebody to help you. start up the car with the hood up in nuetral with whoever you have helping you watching from the top to check to see if their is excessive movement in the upper mounts. turn your wheels hard to one side then the other while your helper looks closely to see if the bottoms moving. after that if no movement is noticed do all over again but put the car in drivewhile applying the brake fimly. just get the rpms up to pu strain on the motor. don't hammer the gas.

Aug 15, 2009 | 2000 Chevrolet Cavalier

2 Answers

I have 96 honda odyssey, its leaking oil between the engine block and the oilfilter housing.


you should change all the sensors and repair the computer of the car when i was in 10th grade my father brought a 97 honda oddesey and it also got this same problem

Jul 29, 2009 | 1996 Honda Odyssey

1 Answer

Where is the oil filter located on the bmw 116i


right at the front in the middle below plastic housing. Has 1 large plastic cap on a metal lower casing, not metal bodied like old oil filters just has filter element. Also replace 'O' rings that should come with the new filter as the old will have squared off or become perished. I think you need a 27mm socket to undo the filer housing.

May 12, 2009 | 2005 BMW 1 Series

2 Answers

Oilfilter


You didn't post the size of motor but once you drop the skid plate, you will see it.

The oil filter is under the engine skid plate. You need to remove the trap door to see.
The skid plate door is located by the drivers side door, directly midway underneath the vehicle. You will need a flat or Phillips-hear srewdriver to open the trap door. Don't worry, the screws are 'loss-proof' and will not fall off the trap door plate. Once this has been removed, the oil drain plug and oil filter are now visible and accessable (how smart is that!) Typical oil change and oil filter replacement time = 15-20 mins. for a familiar shadetree. p.s. The Inline 6 (24 valve - 4.2L) takes 7 quarts of oil. Good luck!

Mar 15, 2009 | 2008 Chevrolet Trailblazer

1 Answer

Where is the fuel filter on a 1991 Toyota 4 x 4 Truck 4 cyl.


On a 4 cyl., under hood, mounted on lower center passenger side of engine.
On a 6 cyl., under vehicle, passenger side, below seating area, passenger side of transmission,mounted on frame.

Jan 26, 2009 | 1991 Toyota Pickup

1 Answer

Where is the oil pressure switch on a 1991 6 cyl toyota cressida?


Oil Pressure Switch On your 1991 Toyota Cressida 3.0L FI , the Oil Pressure Switch is located: clearpixel.gif Under hood, passenger side, lower engine area, front of oil filter, mounted in engine block clearpixel.gifDavid clearpixel.gif clearpixel.gif

Jul 15, 2008 | 1990 Toyota Cressida

Not finding what you are looking for?
2004 Chrysler Sebring Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...