Question about 2006 Chevrolet Equinox

Open Question

Rear brake clicking sound when appling brakes at low speed

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
centralvalle
  • 386 Answers

SOURCE: replaced brake shoes and had drums turned when

you need to inspect your backing plates for grooves in the pads where the brake shoes contact the backing plate. during a break job these spots are supposed to be lubed with proper non grease brake backing plate lube. some people use never sieze compound... also make sure brake shoes were installed correctly having the primary and secondary shoe correctly in it's place, if you have grooves in your backing plates then the shoes will bounce up and down as they move across the groves this will make a clicking noise, also have seen cracked brake drums make noise... give close inspection with wheels off , if you can jack rear of car off ground support with jack stands , chalk front wheels , then remove wheels on both sides but use a lug nut to hold brake drum on securley, now have someone watch and listen and watch as you let wheels spin under power of engine at low rpm , inspect and watch for possible clues...please rate my help, thanks...

Posted on Aug 08, 2009

Ad
  • 164 Answers

SOURCE: sometimes at low speeds only

yup sensor it is. there is one on each wheel, the fronts can be corroded or bad, and the rear just fail and are part of the whole wheel bearing assembly. you need to take to a shop that has the ability to drive,record and graph the sensor outputs to tell which one/s are at fault. you need a scan tool to do this since the car must be rolling on all 4 at speed to test. good luck!

Posted on Sep 03, 2009

  • 2418 Answers

SOURCE: abs/AWD light on 04 venture

Have you checked the brake fluid level?

Posted on Jun 06, 2010

SOURCE: drumming noise from front end

brake shoes

Posted on Jun 14, 2012

headstrong56
  • 493 Answers

SOURCE: 2004 Chevy Malibu intermittent grinding noise rear wheel

sounds like wheel bearing to me

Posted on Jul 16, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 dodge 4x4 diesel abs and brake light on no codes exist


If the brake fluid is low or if you have low pressure, it will cause both of these lights to come on. This truck has rear drum brakes if I am not mistaken??? you also might want to adjust up the rear brakes some more. The rear brake shoes being out of adjustment can also cause this. Something else you might want to check is the rear speed sensor on the rear differential.

Apr 18, 2012 | Dodge Cars & Trucks

1 Answer

When i brake at low speeds i hear a grinding "whomp whomp whomp" sound. only when braking. ive recently got new brakes. what gives?


are you sure front and rear brakes are new and is your abs light on when this happens were the rotors machined do you have rear discs brakes or drum brakes

Jan 25, 2011 | 2003 Mitsubishi Lancer

1 Answer

Abs/AWD light on 04 venture


Have you checked the brake fluid level?

Jun 06, 2010 | 2004 Chevrolet Venture Passanger

1 Answer

Replaced brake shoes and had drums turned when installed the right rear brake stated to make a clicking sound when brakes are applied. The sound is consistant with the speed you are going when you apply...


you need to inspect your backing plates for grooves in the pads where the brake shoes contact the backing plate. during a break job these spots are supposed to be lubed with proper non grease brake backing plate lube. some people use never sieze compound... also make sure brake shoes were installed correctly having the primary and secondary shoe correctly in it's place, if you have grooves in your backing plates then the shoes will bounce up and down as they move across the groves this will make a clicking noise, also have seen cracked brake drums make noise... give close inspection with wheels off , if you can jack rear of car off ground support with jack stands , chalk front wheels , then remove wheels on both sides but use a lug nut to hold brake drum on securley, now have someone watch and listen and watch as you let wheels spin under power of engine at low rpm , inspect and watch for possible clues...please rate my help, thanks...

Aug 08, 2009 | 1999 Chevrolet Prizm

1 Answer

2002 dodge caravan rear disc noise


Sure sounds like you need new brake pads. On the brake pad is a small metal tab that contacts the rotor and squeals when the pads need to be changed. Hope this helps. Please keep me posted. Good luck

Apr 05, 2009 | 2002 Dodge Grand Caravan

1 Answer

I HAVE A 2003 AVIATOR, & I'M GETTING A CLICKING


I had a resent exp with this noise coming from my rear right... after 5 trips to Sears.... It is the parking brake shoe slaping around... ahave that wheel removed and the brake and the rotor... and behold the broken parking brake shoe will most likley fall out once the above is taken apart......

Mar 19, 2009 | 2004 Lincoln Aviator

2 Answers

Steering vibrate when I brake


Oh Yes The Dreaded Bent Rotor Sound Find Out If Its Clicking In The Front Or The Rear And Replace Front Or Rear Rotors And Brakes.

Jan 12, 2009 | 2006 Chrysler Neon

1 Answer

84 Nissan 720 rear brake lock-up


Was the proportion valve and mater cylinder replaced? The problem most likely is a bad proportion valve it doesn't allow the fluid to return to the master and therefore stays in the system and locks-up the brakes.

Dec 10, 2008 | 1984 Nissan Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...