Question about Cars & Trucks

Open Question

Where is the fuse box on my 2008 Isuzu i-290 - Cars & Trucks

Posted by Anonymous on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 375 Answers

SOURCE: Isuzu I-290 parts from a Chevrolet Colorado or GMC Canyon

The parts sure better be interchangeable, seeing as how all of those Isuzu pickups roll off of the Canyon/Colorado assembly line. In truth, the Canyon/Colorado is actually based on a jointly-developed platform that was originally sold overseas as the Isuzu D-MAX – however, on the version that was later built here in the United States, General Motors swapped-in their own engines and restyled the body… but the platform itself is virtually identical. Due to something called the Chicken Tax, Isuzu sells the GM version here in the US (rather than their version that is built in Thailand). Basically, it is far too cost prohibitive for Isuzu to sell the D-MAX in the United States – so, to save themselves the tariff, they simply slapped an Isuzu emblem on the domestically-produced Canyon/Colorado instead.

Posted on May 18, 2008


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is timing marks on Isuzu 4jj1 d,teq 2008 engine

post 2, why post so many times to USA forum
with no such car.
why not post to a forum in your unstated country.
is telling country so hard,? why?/??????????
learn that cars vary by COUNTRY

we have only these. 4. that year.
Ascender LSAscender Si-290 Si-370 LS

Dec 28, 2016 | Isuzu Cars & Trucks

1 Answer

What's the location of the T.M.C in the Isuzu-08 pickup Transmission What is the location of the T.C.M in the 2008 Isuzu Transmission

i-290 or i 370?????? its not an asunder.
you are H3LL bent on find this box. TCM , not TMC.
why post 2 times same question, why?\
USA car?
and why assume its a separate box, why>?
never assume that.

there were 3 transmissions
4L60, 4L65, and 4L70-e , all for are dash E(electric shifted)

now guess 10
The transmission control module (TCM) (5.3L only) is mounted near the lower left front of the engine and connects directly to the engine wiring harness

some do have seperate TCM ,
but why not scan the car first
and not risk damaging a vary expensive module.
leave it be.
scan it.
check fuses first and levels ATF.

Dec 03, 2015 | Isuzu Cars & Trucks

1 Answer


That Must be a Sensor on The Disc Brake Pads Are They Not Worn Out If Not Its Touching Earth Somewhere , It Should Be a Single Wire With A Bullet Connector At The Brake Caliper

Mar 28, 2013 | 2008 Isuzu I 290

1 Answer

Brake lights not working. fuse ok just changed bulbs.


Aug 25, 2011 | 2008 Isuzu I 290

1 Answer

Isuzu I-290 parts from a Chevrolet Colorado or GMC Canyon

the canyon and colorado are built on the same chassis as yours so i believe that they should be able to interchange

May 29, 2009 | 2007 Isuzu i-290 Extended Cab

1 Answer

Low beam headlight is out on 2008 i290


Most probably you are seeing a lot of clutter in the bonnet to put your hand in and change it right? The best way sometimes is to unbolt the headlamp , move it out change the bulb and back in. But another way would typically be to remove the battery (and battery holder plastic box) or air box (whichever is in the way) and then you should be able to access the headlamp cover from behind. Anyways in both cases you should find a metal clip holding the bulb. Unclip the bulb whilst making sure that you dont touch the new bulb with you hands while putting it in. Press its metal clip in place again. and be sure to mount the plastic cover at the back properly so no water goes in the headlamp if its raining.

It was nice to help you :)

Best Regards

Jan 07, 2009 | 2008 Isuzu I 290

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13614 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides