Question about 1996 Lexus LX 450

Open Question

Can't reset security for Lexus LX 450

Trying to reset security system for LX 450 light blinks but reset does not happen

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

johnny5846
  • 379 Answers

SOURCE: timing belt replacement 1997 lexus lx 450: when?

well don , if this is a 4wd , actually even if it wasn't i show it to have locking diff(s) , if you have 4wd i show you to have a switch and a light somewhere on dash display indicating if it is locked in or not . , if you look at the passenger side of the rear differential you might see some electronical gizmo attached to it . i recently worked on a lx470 , it was awesome , i cracked the woodgrain cover around the power window switch , ouch , it cost $500 just for that little piece of woodgrain , lexus is very proud of their parts , lol , enjoy that vehicle . i would sure appreciate a FIX YA vote . thank you .

J5

Posted on Jan 28, 2009

  • 1757 Answers

SOURCE: how to change the spark plug wires in a lexus 1996

For the 1996 Lexus LX450 4.5L In-Line 6-Cylinder:

Firing Order:
1-5-3-6-2-4

Cylinders:
(back)
|..6..|
|..5..|
|..4..|
|..3..|
|..2..|
|..1..|
(front)

Distributor:
.........(back)
...........(+)-screw
........4......2
.....1.............6
(+)..................(+)
........5......3
(front)

Let me know if this helped....

Posted on Apr 18, 2010

Testimonial: "Very helpful and a really quick response time! thank you so very much!!!!"

vetteman3002
  • 2299 Answers

SOURCE: Lights will not go off

Disconnect the battery for 15 minutes. This will reset the computer. If the problem happens when you hook the battery back up then something is causing the security system to fault. Weather it is the security computer or a faulty switch. It is very hard to determine without disconnecting and troubleshooting switches etc. But hopefully disconnecting the battery will get you going again.

Posted on Oct 19, 2010

dttech
  • 4803 Answers

SOURCE: i need a belt digram

There are two drive belts on your truck. One drives the A/C and the other drives the alternator. The routing is so simple that the service manual does not even make mention of it. Sorry, no diagram available.

Posted on Aug 09, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 Lincoln navigator won't start the anti theft light just keeps blinking what can I do


Disconnect the battery cable and leave disconnected for 5 to 10 minutes. Reconnect cable and see if this resets the security system. If light is not flashing, then it should have reset. If when trying to start and the theft light comes on again, have your key checked to see if it has lost its code. If you have a second key, try using it. If this does not work, you may have to have the system flashed at the dealership.

Dec 16, 2014 | 2002 Lincoln Navigator

2 Answers

Security light is blinking and car won't start just replaced the fuel pump car will start for a couple secounds and dies


you need your manual it tells how to reset security system or give dealer a call they should tell you

Jun 20, 2014 | 2001 Pontiac Grand Am SE

2 Answers

Lights and start


Sounds like an anti-theft issue. Make sure you are not using an aftermarket key. There is a technical service bulletin01-6-2 which pertains to the problem.

Mike

Apr 13, 2014 | 1999 Ford Explorer

1 Answer

Security light blinking


check engine immobilizer. Reset the CPU with a code reader to reset the security system

Oct 26, 2013 | Cars & Trucks

1 Answer

My 2003 z71 has a blinking securtiy light but it will not start. all other lights work fine and all other electrical parts work ok. I had the battery tested and recharged. I was told that if the securtiy...


The factory security light should not flash. Put the key in the dash and turn it forward like your going to start it but do not crank. Let the truck sit with the key on until the light stops flashing. It usually takes anywhere between 20-45 mins for this to happen so just be patient with it. Once the light stops flashing try to start it. Alot of times the key sensor on the ignition switch goes bad and will kick the security feature on in the truck. ((On a side note if you have a remote start installed on the truck they use a bypass for the factory security the sometimes will fluke out.))

Jan 05, 2011 | 2003 Chevrolet Suburban 1500

1 Answer

Have a 2003 Saturn LW2 wagon- 1st problem lights inside and outside of car started blinking on & off- then just opening car door lights blinked on & off- now blinking stop-but car will crank over-...


That thing about the lights flashing, think about it. that happens only when you lock or unlock the car with remote to set and off-set the security system. Makes sense that your security system is in lock-out mode so nothing works, right?. Disable or reset your security system and you'll be fine.

Jul 10, 2017 | 2003 Saturn Lw 4dr Wagon

3 Answers

Code on diagnostics p0401


Code on diagnostics p0401:

What is going on?
Exhaust Gas recirculation low flow detected means that: there is vacuum problem in the EGR system - between the combustion chamber, EGR valve (mechanical - blown up diaphragm or clogged airlets/hoses) , EGR Modulator Valve (mechanical - blown up diaphragm, dirty EG/air filter or clogged airlets/hoses) and Vacuum Switching Valve ((mechanical - blown up diaphragm or clogged airlets/hoses OR electrical - VSV not properly synchronizing with the ECM, for instance).

Effects?
This causes the combustion chamber temperature to increase and produce Oxides of Nitrate (NOx) that is out of an acceptable emission range. This triggers the Malfunction Light (check engine light) to stay on (after a couple of driving cycles)!
Solution: Focus on EGR airways (hoses...) and organs (EGR valve, EGR Modulator, VSV), clean, check or replace the defected one. VSV seems to be criticale as it plays electrical & mechanical function. Once the repair is done, Clear the P0401 code using an OBII scanner.

Dec 21, 2008 | 1996 Lexus LX 450

1 Answer

I have a 1996 Lexus LX450, engine light came on. The DTC is P0420


With that code you most likely have to replace the catalytic converter.You can try to reset the light but it will come back in time.

Nov 14, 2008 | 1996 Lexus LX 450

1 Answer

2003 pontiac grand am


This happened to me as well - always at the most inopportune time. When you get this, turn the ignition off, then turn to on (do not start). Let it sit there for about 10 minutes. Once the security light quits blinking you are good to go.

Sep 11, 2008 | 2004 Pontiac Grand Am

Not finding what you are looking for?
1996 Lexus LX 450 Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

881 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...