Question about Chevrolet Tahoe

Open Question

2005 Tahoe left and right turn rubbing/grinding noise. Does not rub or grind when car is cold. can also feel in right rear wheel when backing up. Truck has a new rear end.4 whl drive

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 13 Answers

SOURCE: noises when turning steering wheel

check cv joint

Posted on Jul 16, 2008

Ad
  • 375 Answers

SOURCE: Grinding noise in the left

grinding on front wheel is caused by 2 things. a bad or loose wheel bearing,or worn out brakes, have them both checked
You might also want to check the level of fluid in the power steering reservoir - low or lack of fluid will also cause a noise (although more of a whining than a grinding).

Posted on Jul 29, 2008

  • 2 Answers

SOURCE: Rubbing or grinding noise coming from Driver side rear tire/wheel

I had the same problem that based on interner research is common for Fords trcuks/suvs. The common problem fro rear humming "rubbing"sound might be the rear wheel bearings/seal. These will need to be replaced as it will progressivly get worse and the noise louder and eventually the bearings can sieze. I would hesitate to take to a ford dealer if I were you as it can run $500-900. Take to mechanic that knows how to replace wheel bearings and seals. My mechanic replaced them for about $150. and the bearing and seals are around $40. A good way to test this is to raise the wheel were you can freely spin by hand...if does not spin or there is a lot of friction then it might be the wheel bearings.
Good Luck

Posted on Apr 11, 2009

localwonder
  • 6784 Answers

SOURCE: rubbing or grinding noise in steering wheel

Hi, this could be a combination of many issues. i would check the following.

Check the strut mounts. there could be some damage here concerning the mounts. i would also check the control arm bushings as well. check for damage here. I would also inspect the CCV half Shaft as well. this is a known problem spot(re manufactured)CCT.

The last problem spot here will be the actual wheel bearings in the front. they may be worn or dry. this could cause the symptoms you stated as well.

you will find the issue in one or all of the above problem spots stated.

Please rate and god bless:)

Posted on Apr 27, 2009

  • 2 Answers

SOURCE: 2002 Mountaineer SUV, 4WD, Especially while turning the wheels

I had the same problem with my 2002 Mountaineer at about forty thousand miles. Murcury replaced the steering column free under warranty. I now have ninty two thousand miles and it's back. The rear end is making a whining noise, the tranny is starting to slip, and the rear window regulator went out. Why did we buy a Mercury?????? Disgusted Dave!!!

Posted on May 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes a popping noise from front end, and a rubbing noise , not grinding


4wd?? Check CV shafts. Also look for whats rubbing. whre is the dirt rubbed off.

Feb 26, 2016 | 2005 GMC Yukon

1 Answer

Rubbing or grinding soud front driver side area


check to see if the dust shield behind the brake rotor got bent a little and is rubbing the rotor- cheers Denny

Dec 04, 2013 | 2002 Ford Explorer

1 Answer

Chevy Tahoe Right Rear Wheel grinding noise


Sounds like a rear wheel bearing that needs replacing. If you have the tools check out Scotty Kilmer's handy video http://youtu.be/OeSykJguOjY

Jul 21, 2013 | 2006 Chevrolet Tahoe

1 Answer

2005 Ford Explorer is making a grinding noise


I had some issues with my 2005 explorer left rear. It was making a creepy old door sound at low speeds and then a high pitched whisel at high speeds. That turned out to be a broken wheel bearing and had it replaced. Note each wheel has two wheel bearings. After that a new noise developed that sounded like metal scraping/ grinding metal. It end up being the brake dust cover got bent when they replaced the bearing and it was rubbing something, the fix for that was bending it so it didn't rub. I hope this helps.

Sep 03, 2012 | 2005 Ford Explorer

1 Answer

Noise when turning the wheel fully to the left or right.sounds like grinding.


check the inside of the wheel to see if it rubs on tie-rod ends and the tires for wear and tear. also verify what size of tires are recommended, too big the tires will rub on the inside of the fender

Jun 25, 2010 | 2005 Chrysler 300

1 Answer

2005 Z71 Tahoe - When turning left only there is a squeal like sheet metal rubbing something. Pulled axles and replaced brake backing plates (rusted out) and all rear brakes. Had to replace the driver side...


Did you check the front shields also. Had a lady going into a tizzy one time with pretty much the same problem. Squealing when turning only one way. I took it for a quick drive and pulled it into the shop. Took off the front wheel where I thought the offending sound was coming from.

Well there's your problem lady. A small rock between the rotor and dust shield. Cost to customer. $0.

Hope this helps.

Oct 04, 2017 | 2005 Chevrolet Tahoe

1 Answer

2002 Mountaineer SUV, 4WD, Especially while turning the wheels


I had the same problem with my 2002 Mountaineer at about forty thousand miles. Murcury replaced the steering column free under warranty. I now have ninty two thousand miles and it's back. The rear end is making a whining noise, the tranny is starting to slip, and the rear window regulator went out. Why did we buy a Mercury?????? Disgusted Dave!!!

Mar 17, 2009 | 2002 Mercury Mountaineer

1 Answer

Grinding rubbing noice turning right


If you have stock sized tires on it.. check the brakes.. also look for loose fender skirting near the wheel as a helper turns the wheel maxxed out to the right.. Lemmie know, Thanx

Mar 11, 2009 | 2003 Pontiac Grand Am

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...