Question about 1997 Chevrolet Blazer

1 Answer

One low beam wont turn on, but both high beams will

All of the lights work except one of the low beam headlights. Although, both high beam headlights work. Low and high beam are from the same bulb which I just replaced thinking it was only burnt out.

Posted by on

  • Devin F Jan 04, 2014

    Do you know where the ground would be though for the low beam driver side? I am having difficulty hunting it down. There is no power at the plug or before it. (I stabbed a little hole in the wire just to check to make sure it was not the plug) I also replaced the switch on the dash for the lights hoping that would fix it. Although, there is still no power.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 62 Answers

Ok if you run a power wire to the positive on battery does it go?
if so its a plug or cable issue. if not make an earth wire for the earth side of light and try the power again. if it goes you have a bad earth.

Posted on Dec 29, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
michigan man
  • 3533 Answers

SOURCE: Low beam headlight not working

check the bulbs first because on most cars the low beam bulbs blow out first and yes check the fuses under the drivers side dash and also the relay box under the hood if owners manual check there also to find where everything is located also if you have any after market CD player or amps check the grounds and connections on these also

Posted on Jan 04, 2009

djicenova
  • 319 Answers

SOURCE: low beam headlights not working

check voltage at switch

Posted on Mar 18, 2009

heavymetal77
  • 721 Answers

SOURCE: low beam headlight /daytime light are not working

It's on the driver's side. Remove all the plastic & it's in there.Big rectangle, black box,about 1.5" thick,lotta wires.

Posted on Jun 22, 2009

  • 69 Answers

SOURCE: No headlights. Low beam out High beam work. I

could be becauce if you dont have low beams and high beams do work once you replace them with new bulbs low beams should work.

Posted on Sep 24, 2009

  • 312 Answers

SOURCE: 2000 impala-low beams don't work but high does

sounds like the problem is the dimmer switch, get a price on the dimmer switch. If you have to, get one at a junk yard . It's cheaper.

Posted on Dec 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

While low beams on the left high beams stays on dim light but wen I turn high beams on they work fine


It could be driving lights mode instead of low beam. Check connections.

Jun 16, 2017 | Cars & Trucks

1 Answer

Both my low beam and high beam wont work. And my headlights wont go down even when lights are turned off and the button is unpressed on the inside.


check the headlight relays ,
Check for possible faulty light stalk switch also. Dash lights may fail with this possible cause.
Check fuses

Jan 25, 2016 | 1992 Mazda MX-5

1 Answer

I have a problem with the low beams on my headlights. The high beams works just fine. All of the other lights(turn signal, emergency lights, etc.) work except for the low beams.


Check the fuses first. then replace the turn signal switch if all fuses are good. All the lights run threw it, except the high brake light on the rear.

Jan 01, 2015 | 2003 Ford Escape

3 Answers

One low beam head lights will not work, high beam works though


check for a damaged wire for the low beam. Also wouldn't hurt to check the ground wire as the high beam will try and ground through the low beam but not visa verse

Dec 29, 2013 | 1997 Chevrolet Blazer

1 Answer

1987 Chrysler Fifth Avenue, only one low beam headlight is on.


the light is out replace it the low side work when u have high beams on ththe short in the light is in the low beam .

Sep 09, 2012 | 1987 Chrysler Fifth Avenue

2 Answers

Hello, I have a headlight problem on a 2004 chey calvalier. All of my lights work except low beam on drivers side. Fuses on left and right headlights are good. I've switched bulbs as well and nothing...


I would focus on the connections going to that head light for the low beam. I agree, it is not the switch, otherwise other side low beam would not be working. It is most likely bad bulb inlet( if it i separated bulbs for high and low) or it is the connection going to the low beam that operates it. Hope this helps. Don't waste your time on switch, it is not that.

Jun 08, 2011 | 2004 Chevrolet Cavalier

1 Answer

The low beam headlight on my 2001 buick regal ls wont turn on, but my high beams do.


It could be the low beam lights have gone bad. It is very possible for only the high beams to work, by themselves. If they won't turn on check fuses.

Nov 27, 2010 | Buick Regal Cars & Trucks

1 Answer

2001 Ford Focus - High beam / low beam problem with headlights


just replace the dimmer switch under the column its wore out on the low beam side

Jan 17, 2010 | 2005 Ford Focus

1 Answer

Dynasty headlights


it is ur switch that changes it from low beam to high beam
[ turn singnal switch]

Feb 15, 2009 | 1990 Dodge Dynasty

2 Answers

High beams wont turn on.


First place to start is with headlight switch. I did have a case many years ago when both high beams were blown out at once, but this is rare. When you have the headlight switch out, jump power from te low beams to the high beam contacts. If high beams come on, replace switch.
Bill

Nov 19, 2008 | 2004 Ford Explorer Sport Trac

Not finding what you are looking for?
1997 Chevrolet Blazer Logo

292 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...