Question about 2003 Nissan Sentra

1 Answer

2003 nissan sentra security light stays on on right side of dash on top

Just replaced computer will not start how can I repair

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 110 Answers

System needs to be reset unhook both sides of battery 15 min if doesnt help dealer reset

Posted on Dec 29, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 7 Answers

SOURCE: 2003 Nissan Sentra Brake lights stay on

When you depress the brake pedal, the brake pedal will move away from the brake light switch and cause a close circuit and the brake lamps light up. There is a rubber bunk on the pedal which pushes against the brake light switch to shut it off when you release the brake pedal. Most likely this rubber bunk has either fallen off or disintegrated leaving a hole in the brake pedal so there is nothing to push against the switch to shut it off. Look up the brake pedal until you see the brake light switch, then depress the brake pedal to see if the rubber bunk is still there. It is easy to replace. Or you can use some double sided adhesive tape and a coin and stick the coin over the hole in the brake pedal.

Posted on Oct 23, 2008

  • 26 Answers

SOURCE: Nissan sentra 1993 1.6 l won't start

try puting shifter in nuetral , common nissan problem

Posted on Dec 29, 2008

  • 1 Answer

SOURCE: 1999 nissan sentra gxe headlight problem

I switched one of the new bulbs with a working older bulb, and the problem went away. weird...

Posted on Apr 24, 2009

  • 22 Answers

SOURCE: nissan clutch problem

If your not able to shift into any gear that means your clutch is not engage/disengaging. Check for fluid leaks, you said topped off and fluid levels were low? It sounds like you have a Slave cylinder or master cylinder leak, if its leaking its bet to replace both.

Posted on Apr 27, 2009

  • 770 Answers

SOURCE: brake light, 2008 Nissan Sentra

Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.

Posted on Jun 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 Nissan Sentra 1.8 black guy has no injector pulse no ignition fire what would the problem be and how can I fix it


Being it is two separate areas in the computer. Check and see if the security is set. Light would stay on or flashing. Check fuses. then check for power at the injectors and coil pack/s

May 15, 2016 | Nissan Cars & Trucks

1 Answer

Why does my 2008 nissian sentra blinker stay stuck on RIGHT SIDE ONLY even with the key off/out?


You have to take it to the dealer and they have to change your ipm computer board. They'll probably have to order the computer part and replace it. bring both of your keys in when you pick up so they can re-program them. This part will clear out your keyless remotes.

Feb 02, 2016 | 2008 Nissan Sentra

1 Answer

I have a 2005 Nissan Sentra 1.8s and my left turn signal and my hazards will not work when running lights are on but the right signal works fine, also the left turn signal indicator in the dash is on


You have a bad ground on the left side. Use a jumper wire on the ground wire near the socket on the left side. If the lights start to work normally than trace the ground wire back to its body connection and repair

Nov 29, 2013 | 2005 Nissan Sentra

1 Answer

Where is the reset for 2007 nissan sentra fuel pump


How To How to Reset the Computer on a Nissan Sentra When the check engine light illuminates on the dash in a Nissan
Sentra, it is an indication that the computer has recognized a problem within its sphere of influence. Once the problem has been addressed and corrective action completed, the computer can be reset by erasing the existing codes.
jQuery('.intro .thumbnail').each(function(i,e){ jQuery(e).find('img').one('error',function(){ jQuery(e).remove(); }); }); Instructions Things You'll Need:
  • Code scanner
  1. Step 1 Insert the code scanner's connector into the OBD port located under the dash to the right of the steering column.
  2. Step 2 Turn the ignition key to the run position. Make sure the engine is off.
  3. Step 3 Press the button for "Read" on the code scanner. Within less than 1 minute, the scanner will display all failure codes that are stored in its memory.
  4. Step 4 Write down the failure codes displayed by the scanner. Cross-reference the codes with the code sheet that comes with the scanner. The codes are displayed with a letter followed by a four-digit number code. Deciphering these codes by cross-referencing them with the code sheet offers an explanation of the failure.
  5. Step 5 Turn the key off. Correct the failure so that the computer can be reset.
  6. Step 6 Turn the ignition key on, keeping the engine off. Press the "Erase" button on the scanner. Start the vehicle and allow it to run for 5 minutes. Watch for the check engine light to come back on. If it does, the problem has not been corrected. If it stays off, the problem has been successfully resolved.

Feb 07, 2010 | 2007 Nissan Sentra 2.0 SL Sedan

2 Answers

1999 nissan sentra gxe headlight problem


do you have the right light bulb? i own a 98 sentre and
it takes a 9004 bulb, but walmarts computer said to use 9007. That made the high beam censor stay on till i replaced it. if you look at the bulb you can tell if it is a dual or single beam bulb.!!!!

Mar 11, 2009 | 1999 Nissan Sentra

1 Answer

1999 nissan sentra gxe headlight problem


I switched one of the new bulbs with a working older bulb, and the problem went away. weird...

Nov 09, 2008 | 1995 Nissan Sentra

1 Answer

2003 nissan sentra gxe


if the fuse to the radio is ok. i would suspect the radio is no good. i have replaced several in sentras!!

Oct 20, 2008 | 2003 Nissan Sentra

2 Answers

2003 Nissan Sentra Brake lights stay on


When you depress the brake pedal, the brake pedal will move away from the brake light switch and cause a close circuit and the brake lamps light up. There is a rubber bunk on the pedal which pushes against the brake light switch to shut it off when you release the brake pedal. Most likely this rubber bunk has either fallen off or disintegrated leaving a hole in the brake pedal so there is nothing to push against the switch to shut it off. Look up the brake pedal until you see the brake light switch, then depress the brake pedal to see if the rubber bunk is still there. It is easy to replace. Or you can use some double sided adhesive tape and a coin and stick the coin over the hole in the brake pedal.

Oct 02, 2008 | 2000 Nissan Sentra

Not finding what you are looking for?
2003 Nissan Sentra Logo

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...