Question about 1999 Plymouth Breeze

1 Answer

Oxygen sensor problems

After replacing oxygen sensor the car sputters.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Plymouth Master
  • 50,583 Answers

Run faults again to find out what you missed.

Posted on Dec 29, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Replaced cam sensor,oxygen sensor, egr vavle, when normal operating temp vehicle dies at stop signs and has jerking and sputtering when accelerating

If these symptoms only start after vehicle warms up, possible coolant temperature sensor. I would suggest having the sensor data scanned by a shop to monitor sensor operation to see if one is out of range before replacing any unecessary parts.

Oct 25, 2015 | 2001 Pontiac Aztek

1 Answer

Spitting sputtering

Throttle position sensor, if it has one. Oxygen sensor if it has one or choke positioner.

Mar 02, 2014 | Honda Civic Cars & Trucks

1 Answer

I have a 2000 Ford Taurus, ran out of gas the other week, came home the next day put fuel in it, and got a mean sputter, so we flush the fuel lines out, but at the same time this man adjusted the...

Whenever I get a vehicle in that "sputters" the first things we check is the fuel filter and pressure on the fuel pump. With the 1995 and newer cars the computer will kick out error codes if the oxygen sensors are defective.

Sep 11, 2011 | 2000 Ford Taurus

1 Answer

I have an 89 s10 blazer 4.3 TBI that spits, sputters and dies at an idle and seems like it misfires as driving, no check engine lite came on. gave it a tune up. replaced the EGR valve , Ran perfect for a...

ing. mod. and coil pack may be starting to go bad had same trouble with mine only a tune-up problem solved then came back be fore i put car on di machine found that coil pack was bad! when if you scange coil pack or ing. mod. replace all, if not will have problems again.

Jun 12, 2011 | Chevrolet Blazer Cars & Trucks

1 Answer

We understand that your problem is: We have a 1997 GMC Safari 4.3 Litre 2 wheel drive. Stalls when idleing. Sputters when accelerating at speeds around 70-90 kms. Gas consumption has risen dramatically....

Welcome to the world of improper diagnostics. There isn't a trouble code in the world that says you should replace a part. It only tells you what's going on with that component. In your case, the code P0137 means that the computer sees Low Voltage on the Bank I Sensor 2 oxygen sensor. You replaced the sensor and still have the problem. That means the computer sees Low Voltage on the Bank I Sensor 2 oxygen sensor. In other words, you've got a wiring problem, not a part problem. You'll need a shop manual with step by step instructions on how to test the entire circuit to find the fault.

Jul 27, 2017 | 1997 GMC Safari

1 Answer

1993 ranger sputters until warm?

replace the Oxygen senson before catalytic converter this sensor tells the computer to send signal to fuel injectors to allow rich mixture upon start up for warm up then leans out mixture as it heats.

Feb 24, 2010 | 1993 Ford Ranger SuperCab

1 Answer

How do i replace the oxygen sensor on a 2003 hyundai sonata. The car runs fine for a while then it will sputter and the engine will die. I wait a minute, start it up and the car is fine for a while before...

did you pick up a fault code to explain your action as i dont believe the oxygen sensor is at might be that one of your other sensors is at fault.the 02 sensor only reads the emmition gasses but will not cut the engine.plse get the fault codes.

Jul 11, 2009 | Hyundai Motor 2003 Sonata

3 Answers

19966 nissan pickup sputters at a stop light,but

possibly a spark plug wire loose or plugs need replacing?

Feb 27, 2009 | 1994 Chevrolet S-10 Blazer

Not finding what you are looking for?
1999 Plymouth Breeze Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides