Question about 1998 Ford Explorer

1 Answer

2001 Toyota sequoia rear hatch won't unlock

Rear hatch will not unlock. How do I get the internal plastics off while the hatch is closed? Could the actuator just be stuck? It sounds/feels like it is trying to unlock.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 42,190 Answers

Have some one push down while you activate the lock as it may be stuck or under too much load from the sealing rubbers.

Posted on Dec 29, 2013

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 103 Answers

SOURCE: When I turn on the rear heater or air conditioner,

Easy,your rear blend door actuator is bad. buy one and install it! no problem. it's right on rear plenum,just pull trim off and panel out and sneak it in there.

Posted on Jul 18, 2009

  • 1 Answer

SOURCE: Ford Expedition rear hatch won't open

where is the rear door fuse located on a 2000 ford expedition?

Posted on Feb 02, 2010

  • 1 Answer

SOURCE: stuck rear door

I have the same problem with my 2003 I can't get the little door open that is behind the drivers side.

Posted on Aug 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Toyota Sequoia Oxygen sensors


No the wires won't likely be the same length

The front upstream sensors, are not the same
Part # as the rear,downstream monitor sensors

Go to Rock Auto.Com & look up your oxygen sensors
I would get the NTK or Bosch,if they have that

You do not replace the rear sensors, until they fail

You replace the front ones at 100,000 miles or sooner,
if they fail

Jun 02, 2012 | 2001 Toyota Sequoia

1 Answer

How do I fill the rear washer fluid on a 2002 Toyota sequoia


On alot of SUV's, you have to open the back hatch or tailgate, and there is a washer fluid reservoir either in the door jam of the hatch, or inside the back of the truck.

Apr 27, 2012 | 2002 Toyota Sequoia

2 Answers

HOW TO OPEN HATCH BACK LOCK, IF ITS BROKEN


the sequoia hatchback handle breaking is a known problem due to the extremely low quality of the plastic. 1st you have to open the back door! there is a small pin to the right side of the hatchback door exterior handle. bend a coat hanger and put it on the small pin, pull down and the door will open. Then remove inside panel and you can undo screws and replace the hatchback door handle.

Dec 02, 2010 | 2001 Toyota Sequoia

1 Answer

Rear hatch latch was broken, replaced but now when the lock button is pressed on the transmitter the rear hatch releases and opens.


sounds like the linkage is hookup wrong and may be backwards, the release and lock/unlock linkage are in the wrong holes reverse the two and try it, this sounds like the problem.

Aug 25, 2010 | 2006 Toyota Sequoia

1 Answer

The rear wiper, rear window washer and the rear on the 2001 sequo


a fuse would only apply if they all share the same circuit. i don't believe they do. i think the only common thread they share is that they are on the rear hatch. look to see if a wiring harness is pinched of chafed through.

Feb 18, 2010 | 2001 Toyota Sequoia

2 Answers

I broke the handle to the hatch of my 2003 Toypta Sequoia form the outside. First how do I get in the hatch then how do I go about replacing it?


You can remove the panel from the inside and then open it by a push/pull motion of the rods. You should see two bolts that attach the handle to the deck. You will need to pop the plastic clips loose when you remove the broken handle. Check online on Craigslist first to see if someone is parting out your make and model...there are several years that will interchange. Next move would be to look on ebay and then a junkyard.....last would be the dealership.

You can do this yourself without any special tools.

Dec 07, 2009 | 2003 Toyota Sequoia

2 Answers

My rear hatch door handle broke i need to replace it. how do i replace it?


how do i get the rear gate panel off so I can replace the latch on the 2003 sequoia.

Jul 06, 2009 | 2002 Toyota Sequoia

2 Answers

2003 rear door latch broken how do I get the panel open


if the door is shut, it is a real doozy but i have done it. you have to pry the inner panel off the door using hook tools and small, crowbar shaped tack pullers....kinda like a mini wonder bar. once the panel is off, you have to fish around inside the door and pull the cable on the latch by hand.

Jun 29, 2009 | 2001 Toyota Sequoia

2 Answers

Rear door latch replacement 2003 sequoia


Fig. The latch bracket shown is moved by loosening the mounting fasteners and sliding it as necessary. Matchmark the bracket to the door pillar before moving-1.8L Passat model shown

Jun 02, 2009 | 2003 Toyota Sequoia

Not finding what you are looking for?
1998 Ford Explorer Logo

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...