Question about 2000 Ford Focus

1 Answer

Blower motor resistor

Were do I locate the resistor on the car

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 40,710 Answers

Resistors are normally in the blower box near where the wires enter for the motor.

Posted on Dec 29, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mutthu273
  • 3 Answers

SOURCE: location of blower motor resistor

in china

Posted on Jun 16, 2008

chrischronic
  • 235 Answers

SOURCE: where is the resistor for

under the dash on passenger side. take the under dash pannel off and then you should be able to see it. its put in a hole in the heater/ blower motor case and has a 4 wire connector, unplug connector and then remove resistor.the wire colors should be 2 black and blue wires 1 black and yellow and 1 black.

Posted on Jan 14, 2009

  • 63 Answers

SOURCE: where is the blower motor resistor located on a

On Your Truck Im Not 100% Sure But Most Are In The Heater bow Right Behind The Glove Box

Posted on Aug 17, 2009

  • 1 Answer

SOURCE: 99 ranger blower motor resistor

the resistor is located under the hood, in the black electrical box. There is a drawing of all that is in that box in the owners manual -- if I remember correctly, it's number 9

Posted on Oct 08, 2009

sscullys
  • 984 Answers

SOURCE: where is the heater blower motor resistor located

Just a picture to confirm what coly_coli posted, no new information

5778eef.jpg
This is the wiring harness for the blower motor resistor, the actual resistor is mounted in the blower duct. If you follow the harness to the left ( towards the driver's side ) it is on the connector on that end.

Posted on Nov 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 mustang blower motor resistor location


The blower motor resistor can be accessed from below the RH side of the instrument panel.
  1. Disconnect the blower motor resistor electrical connector.
  1. Remove the 2 blower motor resistor screws.
  1. Remove the blower motor resistor.
  1. To install, reverse the removal procedure.

Feb 21, 2015 | 2005 Ford Mustang V6

3 Answers

2009 cobalt blower motor resistor location


This video will show you where the blower motor resistor is located on your 2009 Chevy Cobalt and how to replace it.


Jul 02, 2011 | 2006 Chevrolet Cobalt

2 Answers

1999MERCURY MOUNTAINEER AC BLOWER ONLY RUNS ON HI SPEED? WHAT TO DO?


blower motor resistor is burnt up
located upsteam in air plenum from blower motor
passenger side compartment at foot
locate motor then you should spot resistor close by

May 09, 2011 | 1999 Mercury Mountaineer

1 Answer

Need to locate the motor blower resistor for my 1999 mercury mountaineer, it has dual air, the resistor for the back is fine but the one in the front is bad and i cannot locate it. Please help.


If you have a manual system, you have a resistor. If electronic, you have a blower motor speed controller. Please rate if this helps.

here is info:

Control System Outputs-Manual A/C
Blower Motor Switch Resistor
The heater blower motor switch resistor has the following features:
  • The assembly is located on the evaporator housing in the engine compartment.
  • Three resistance elements are mounted on the resistor board to provide four blower motor speeds.
  • Depending on the heater blower motor switch position, series resistance is added or bypassed in the blower motor circuit to decrease or increase blower motor speed.
  • An overheating protective device (thermal limiter) will open the resistor coil circuit when the temperature reaches 121°C (250°F) interrupting the blower motor operation in all speeds except HI.
  • The thermal limiter cannot be reset and is not serviceable.
Control System Outputs-EATC
Blower Motor Speed Control
The blower speed control is located on the evaporator housing in the engine compartment.
  • The function of the blower motor speed control is to convert low power signals from the electronic automatic temperature control module to a high current, variable ground feed for the blower motor (18527).
  • The blower motor speed is infinitely variable and is controlled by the electronic automatic temperature control module software.
  • A delay function provides a gradual increase or decrease in blower motor speed under all conditions.

Jan 10, 2011 | 1999 Mercury Mountaineer

3 Answers

Blower motor resistor, where is it located/


It will be up under the dash on the passenger side near the blower motor. It will have 5 or six wires in its connector

Nov 10, 2010 | 2000 Jeep Grand Cherokee

1 Answer

2005 Kia Sorento only blows hot and cold air on high. Is it a blower motor resistor and if it is where is it located?


If the blower moter only works on hi speed it is the blower motor resistor that is bad. The blower motor resistor is located under the passenger side of the dash next to the blower motor. It is not necessary to remove the blower motor to change the resistor.

May 12, 2009 | 2005 Kia Sorento

1 Answer

Blower motor fuse is located 99 mercury cougar


SECTION 412-04: Control Components 1999 Cougar Workshop Manual REMOVAL AND INSTALLATION Blower Motor Resistor Removal
  1. Remove the upper footwell trim panel (passenger side).
    • Remove the pushpins.
  1. Disconnect the blower motor resistor electrical connector.
  1. Remove the blower motor resistor.
-------------------------------------------------------------------------
f9d16f6.gif

May 06, 2009 | 1999 Mercury Cougar

3 Answers

Lincoln 2000 town car Blower doesn't work at HI-MED-LOW speeds...


it is called blower motor resistor , should be close to blower motor , you will see a plug type connector with two screws , remove the screws and there should be a resistor inside the cover for the motor, swap with new and reassemble

Feb 19, 2009 | 2000 Lincoln Town Car

1 Answer

Where is the heater blower motor resistor located


if you locate the blower motor the rester is the wire that atachec to blower motor fallow wire till you find a circuit bord this is ur resistor

Dec 06, 2008 | 1999 Mercury Villager

Not finding what you are looking for?
2000 Ford Focus Logo

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...